Kyle TX Heating & Air Conditioning Services

Performed AC cooling check. Checked the electrical, mechanical, safety, and performance of the system. I cleared the condensation drain line and flow tested the drain with two gallons of water. I also treated the drain line. The air filter was clean and had been recently replaced by the homeowner. I cleaned the condenser coil. No major issues were found. The system was running at the completion of service.

Diagnostics found a dirty evaporator coil that I suspect was causing water to drip on the air filter and in the return chase. While I was here, I did verify the float switch is working properly and the primary drain was cleared. I went over my findings with Lettie and she chose to have the air handler cleaned today. The blower wheel and housing have been cleaned. The evaporator coil has been cleaned along with all other interior components. Once cleaning was completed, I cycled the system on to verify proper operation. The system is cooling at completion of service.

Performed AC cool check. Checked the electrical, mechanical, safety, and performance of the system. I cleared the condensation drain line and flow tested the drain with water. I also treated the drain line. The air filters were clean and had been recently replaced by the homeowner. I cleaned the condenser coil. No major issues were found. The system was running at the completion of service.

Performed AC cooling check. Checked the electrical, mechanical, safety, and performance of the system. I cleared the condensation drain lines and flow tested the drain with water. I also treated the drain lines. The air filter was replaced with a client supplied filter. I cleaned the condenser coil. Surge protectors and system sterilizers are operational. No major issues were found. The system was running at the completion of service.

Performed AC cooling check. Checked the electrical, mechanical, safety, and performance of the system. I cleared the condensation drain line and flow tested the drain with two gallons of water. I also treated the drain line. I cleaned the condenser coil. The surge protectors are operational. No major issues were found. The system was running at the completion of service.

AC cool check was completed on a horizontal straight cool system. Outdoor coils were cleaned. I did give extra attention to the drain line because the float switch into the secondary was tripped. I did adjust the primary PVC coming out of the evaporator coil for better flow. I also noticed the insulation above the coil coming loose and fixed that issue as well. This should help prevent water from entering the secondary again. All electrical and mechanical components were found within manufacturer specifications. The system was cooling properly at completion of service.

Installed Carrier R-454B system. 4 ton evaporator coil with 3.5 ton condenser. Gas furnace in attic. Built and installed new return plenum fitted with 20x25x4 AprilAire media filter. Built and installed new supply plenums fitted with new zoning equipment. Installed new zone control board. Installed new secondary drain pan. Rebuilt the primary condensation drain and added SS2 and SS3 secondary safety switches. Cleared with CO2 and primed with water. New gas pipe and flue pipe connections for the furnace. Installed two EcoBee lite thermostats. Sealed all new ductwork connections with mastic/hardcast. New disconnect box and wiring for the condenser. Pressure tested system with nitrogen and pulled vacuum. Testing heating and cooling operation of new system. Tested operation of new zoning equipment. Charged AC with R-454B refrigerant. Everything is working at completion of install.

Removed old plenum and old flex ducts. Removed old buckets. Made and installed new supply plenum. Made and installed 10x6 box. Installed new sidewall grilles and sealed with silicone. Sealed all connections with mastic foil tape, mastic and hard cast. Ran new flex ducts for the 3 buckets. Ran and supported new return flex. Tested temperature split. Everything is working at this time.

Service diagnostic found the outdoor capacitor had failed on the herm side. Also found the outdoor fan motor and and starter relay showing wear and tear. The outdoor compressor also has a hot spot. At the indoor system I found the blower motor leaking oil. The blower wheel is dirty. Blower capacitor is below rated value. Spoke with the homeowner about the age and state of his system. He chose to have the the outdoor capacitor replaced. I removed the fan motor and compressor capacitor and installed a new dual run capacitor. Secured outdoor wiring connections and washed the outdoor coil at no additional cost. The system is operational at this time

Performed AC cooling check. Checked the electrical, mechanical, safety, and performance of the system. I cleared the condensation drain line and flow tested the drain with two gallons of water. I also treated the drain line. The air filter was replaced with a client supplied filter. I rinsed the condenser coil. No major issues were found. The system was running at the completion of service.

AC cool check was completed on a horizontal straight cool system. Outdoor coils were cleaned. Drain line was flushed and treated. Air filter was replaced. All mechanical and electrical components were checked. No major issues were found. The system was found to be cooling properly. All components found within manufacturer specifications.

Performed AC cooling check. Checked the electrical, mechanical, safety, and performance of the system. I cleared the condensation drain line and flow tested the drain with two gallons of water. I also treated the drain line. The air filter was replaced with a client supplied filter. The condenser coil was cleaned. No major issues were found. The system was running at the completion of service.

Performed AC cooling check. Checked the electrical, mechanical, safety, and performance of the system. I cleared the condensation drain line and flow tested the drain with two gallons of water. I also treated the drain line. The air filter was replaced with a client supplied filter. I cleaned the condenser coil. The capacitor for the blower motor is below value. The system was running at the completion of service.

Performed a/c tune-up on a Carrier straight cooling system. Checked the electrical, mechanical, and performance systems of the unit. Cleared, cleaned, flushed and treated the drain line and washed the outdoor coil. Did find the 20x36 filter grille is showing wear and tear and might need to be replaced in the future. No other issues were found. The system is operational at this time.

Diagnostic found the indoor blower motor torque booster failed, preventing the blower motor from working. Homeowner chose to have it replaced today. I replaced the torque booster and function tested the system. I did let the homeowner know that his system is 27 years old and that due to the age we could not offer any preventative repairs. The system was cooling at completion of service.