Kyle TX Heating & Air Conditioning Services

Performed diagnostic. I found that the system is low on refrigerant due to a leak in the evaporator coil. I also found that the condenser fan motor is showing signs of overheating. I presented options to repair and the customer chose to just add refrigerant at this time. I added 7 pounds of refrigerant, the rated subcooling is 10 degrees and I left it at 9.5 degrees. The system is on and running at this time.

Performed diagnostic. I found that the outdoor capacitor has failed. I also informed the customer that the condenser fan motor is showing signs of overheating. I presented options to repair, and he chose to just have the capacitor replaced at this time. I replaced the capacitor and cycled the thermostat.

Performed AC cool check. Checked electrical, mechanical, safety, and performance of the system. No major issues were found. Drain line cleared and treated. Condenser coil cleaned. Electrical disconnect confirmed in and on. System was running at the time of departure.

Performed AC cool check. Checked electrical, mechanical, safety, and performance of the system. System was found to be low on refrigerant. Leak check was performed, and no leaks were detected. The contactor on the condenser unit is also burnt and pitted. Options for repair were presented to the customer and they chose to have the system charged with refrigerant and to have the contactor replaced. System was charged with three pounds of R-410A. System is currently running at 10 degrees of sub cooling. Contactor was replaced. System was function checked and the condenser coil was cleaned. Electrical disconnect confirmed in and on. System was running at the time of departure.

Performed service diagnostic. Diagnostic found that the breaker for the condenser unit has failed. Options for repair were presented to the customer and they chose to have the breaker replaced. Breaker was replaced and the system was function checked. System was running at the time of

Performed service check on the AC system. Upon arrival the homeowner informed me that outside condenser was not running. System components were checked and I determined that the float switch and drain line were clogged. Presented my findings to the homeowner and we have decided to move forward with drain service. Drain was cleared and treated. System now operational.

Performed semiannual maintenance on one cooling system. Inspected all Performance, Mechanical and Safety Systems. Verified everything was operating within the manufacture’s specifications for operation. Outdoor condenser refrigerant pressures are within range and condenser cleaned. Indoor system drain line cleared and treated. Homeowner had already replaced filters before arrival. No major issues were found and system running at time of departure.

Installed new 3-ton Carrier gas system. Installed two new Ecobee Lites. Rebuilt and insulated condensate drain line. Added SS2 and SS3 safety float switches. Replaced secondary drain pan. Installed new filter dryer, pressure tested with dry nitrogen and pulled a vacuum on the copper line set. Replaced the supply and return plenums. Installed bullhead T and replaced all zoning equipment. Moved the condenser away from the gas inlet to the house and brought over all the connections for the condenser as well. Added a new disconnect for the condenser away from the gas manifold. Charged system to factory spec. System is working properly at time of departure.

On arrival, the homeowner mentioned that the upstairs AC would not cool down. I inspected the thermostat wiring and while doing so I noticed the back side of the thermostat had burn marks. I installed a new thermostat and reset the system. Then went outside to conduct further diagnostics and found the condenser fan motor seized up. I installed a new condenser exhaust motor and installed a new outdoor run capacitor for the outdoor heat pump. I then reset the cooling system again and tested all systems. Everything is working at this time.

Performed the AC tune-up. Cleared and treated the drain line. Condenser coils clean.

Air Conditioning System Repair Service. Performed diagnostic. I found that the outdoor capacitor has failed on the compressor side. I presented the customer with options to repair, and they chose to have the capacitor replaced today. Completed repair and then continued diagnostic. I was not able to get an accurate reading on refrigerant levels due to the high heat load inside the house. It was 88 in the house and it’s now 86 so the system is cooling. The temperature difference between supply and return is 17 degrees. I informed the customer to leave the filter out until tomorrow morning when the house cools down. System is on and working at this time.

Performed cooling maintenance. Checked electrical, mechanical and performance of the system. Cleared and treated drain line and washed the condenser coil. No major issues were found. System is operational at this time.

Performed service diagnostic. Diagnostic found that the electronic safety switch has failed. Options for repair were presented to the customer and they chose to have the switch replaced and sign up for our maintenance plan. Safety switch in the secondary drain pan was replaced. System was function checked and was running at the time of departure.

HVAC Repair Service. Performed service diagnostic. Diagnostic found that the capacitor on the condenser unit has failed. Condenser fan motor is also showing signs of overheating. Condenser coil has large sections of the coil smashed in from the community lawn care service. Options for repair were presented to the customer and they chose to have the capacitor replaced today. He also stated that they know the system needs replacement, but they are looking/planning to move so they do not wish to replace the system. Capacitor was replaced and the system was function checked. System was running at the time of departure.

Performed the AC tune-up. Cleared and treated drain line. Condenser coils clean. I did find the capacitor was under value. No other major issues were found. Presented repair options and the homeowner chose to have the capacitor replaced today. Repair completed and system is operational.