Get the Best HVAC Service
Garner Heating & Air Conditioning offers over 35 years experience in servicing, repairing, and replacing your HVAC system, so let us take that pressure off of you. We'll do the work - you enjoy the comfort. Call 512-392-2000 for all your HVAC replacement, repair and maintenance service near Kyle, TX or contact us online with any questions.
HVAC Replacement Service in Kyle, TX
Like all major appliances in your home, your HVAC system is made up of countless parts all working in concert to provide your home welcoming comfort. Those parts need to be properly maintained and cared for so you always have the warming heat or refreshing cool you need. But who has the time to do that themselves?
If your AC unit is more than 10-15 years old, replacing it could save you money on energy bills and repair costs. Upgrading to a new, energy-efficient system can improve comfort, reduce maintenance, and lower your electricity usage.
When Should You Replace Your HVAC System?
- Your AC needs frequent, costly repairs.
- Your unit is over 10 years old and struggles to cool your home.
- Energy bills have steadily increased despite regular maintenance.
- Your home has uneven temperatures from room to room.
What Size AC Unit Do You Need?
The right AC size depends on your home’s square footage, insulation, and layout. An oversized unit may cool too quickly without removing humidity, while an undersized unit will struggle to keep up. Our HVAC experts perform a full evaluation to recommend the best system for your home.
Expert Air Conditioning Repair in Kyle, TX
If your AC isn’t keeping up with the heat, it might be time for repairs. Common signs your air conditioner needs servicing include:
- Warm air blowing from vents – This could indicate low refrigerant levels or a failing compressor.
- Unusual noises – Grinding, squealing, or rattling sounds could mean parts are loose or worn out.
- High energy bills – If your energy costs are rising, your system may be struggling to run efficiently.
- Frequent cycling – If your AC turns on and off repeatedly, it could be a sign of thermostat issues or restricted airflow.
How Long Does AC Repair Take?
Most AC repairs can be completed within a few hours, depending on the problem. Our team arrives with the tools and parts needed to diagnose and fix issues quickly. If a major repair is needed, we’ll discuss your options and provide transparent pricing before starting any work.
Heating and Cooling Service FAQs
If your air conditioner freezes, follow these steps to get your unit functioning again:
- Turn off the unit from the breaker. This will allow the unit to thaw. FYI, thawing could take an entire day.
- Do not remove the ice by hand to avoid damaging the unit.
- After thawing, dry the coils by turning back on your unit but on the fan setting only. This helps circulate air and dry the coils quickly.
- Turn the AC back on to see if it operates without freezing over.
Homeowners can anticipate paying between $100 - $500 for air conditioner repairs.
A faulty drain pan, loose connections, or worn-out components can lead to costly water damage. Catching minor issues early prevents major headaches down the road.
The cost to replace a heating and cooling system typically ranges from $5,000 to $15,000, depending on factors like the size of the home, system efficiency, and installation requirements.
If it's Garner, It's Guaranteed
We know it can be difficult to bring someone into your home and trust them to do the work right. That's why Garner offers at 100% satisfaction guarantee on all the service we perform. We want you to be certain, before we even step through the door, that you're going to get the right solutions, at the right price, with the right quality.
Give us a call at 512-392-2000 and make us your partner in comfort today. Of course, the best opinion on our work comes from your neighbors. See what they have to say about Garner Heating & Air Conditioning below.
Recent Jobs and Reviews in Kyle, TX
Customers say: The overall sentiment across these reviews is overwhelmingly positive, reflecting high levels of customer satisfaction and appreciation. Customers consistently express gratitude for the professionalism, punctuality, and expertise demonstrated by the service team. There is a strong recurring theme of technicians being knowledgeable, thorough, and excellent communicators who take time to explain issues, answer questions, and provide helpful advice without applying undue pressure. Many reviewers highlight the courteous and respectful nature of the staff, noting details such as wearing shoe covers, protecting work areas, and leaving spaces clean after completion. Timeliness emerges as another dominant positive trend, with numerous mentions of technicians arriving on time or even early, completing work efficiently, and providing same-day service. Customers frequently express confidence in the quality of work performed, even under challenging conditions like extreme heat, and many indicate strong loyalty, stating they will use the service again and recommend it to family and friends. The emotional tone is enthusiastic and appreciative, with reviewers describing their experiences as "great," "excellent," "fantastic," and "outstanding." Overall, the reviews convey a sense of trust, reliability, and exceptional customer care that has clearly resonated with clients.
Kyle, TX at a glance
Garner Heating & Air Conditioning Inc has completed 15 jobs in Kyle, TX in September 2022.
The most recent job was on September 21, 2022.
Garner Heating & Air Conditioning Inc has completed 527 jobs in Kyle, TX in the last 12 months. The first job there was in July 2018.
Our Local Reviews by City
- Austin, TX (78)
- Buda, TX (331)
- Canyon Lake, TX (5)
- Creedmoor, TX (4)
- Dale, TX (1)
- Driftwood, TX (29)
- Dripping Springs, TX (26)
- Hays, TX (1)
- Kingsbury, TX (1)
- Kyle, TX (480)
- Lockhart, TX (15)
- Manchaca, TX (9)
- Martindale, TX (14)
- Maxwell, TX (3)
- Mountain City, TX (26)
- New Braunfels, TX (13)
- Niederwald, TX (15)
- San Marcos, TX (157)
- Seguin, TX (3)
- Uhland, TX (2)
- West Lake Hills, TX (1)
- Wimberley, TX (104)
- Woodcreek, TX (4)
Job Locations and Reviews
Installed new Carrier ductless system in garage. Ran new control wire and condensate drain line. Also ran new high voltage wire in seal tight past the fence. Sealed wall penetration and added silicone around disconnect. Leveled out condenser pad and ran copper in line hide. System operating at this time.
Performed diagnostic and found that the capacitor had failed and also burnt one of the wires. Replaced capacitor and wire. Tested system and everything is operational at this time.
Performed maintenance on the AC system. Cleared, treated, and tested drain line. Found rust in the secondary pan and recommended replacement. I also cleaned the condenser and found that the condenser fan motor is showing signs of overheating.
Performed service diagnostic. Diagnostic found that the safety switch in the secondary drain pan had failed and was not passing signal. Primary condensate drain line was also clogged. Options for repair were presented to customer and they chose to have the drain cleared and the safety switch replaced. Drain line was cleared and flow tested with water. Safety switch for the secondary drain pan was replaced. System set to 77 degrees per customer. System was running at the time of departure.
Performed semiannual maintenance on two comfort cooling systems. Tested all Performance, Mechanical and Safety Systems. Found everything to be operating within manufacture’s specifications for operation. Please see attached checklists for full tune-up details.
Diagnosed that the upstairs zone damper is failing intermittently and not opening when called to do so. I removed the damper from the zone system and placed it in the open position so the upstairs will have cool air. Customer chose to have the damper and the zone board replaced. Parts will be ordered and we will return to complete repairs once received. Installed one new 14” round zone damper into upstairs supply run and also replaced a two-zone control board. I then tested operation of system insuring both dampers opened and closed and were functioning properly. I programmed zone board to match system specifications. System is operational at this time.
Performed AC cool check. Checked electrical, mechanical, safety, and performance of the system. Primary condensate drain line was clogged. Drain line was cleared and treated. No other major issues were found. Condenser coil was cleaned. Electrical disconnect confirmed in and on. System was running at the time of departure.
Performed the AC tune-up. While performing the inspection I did find deficiencies with the system. The client chose to have the mandatory repairs done at this time. After performing the repairs everything is coming on and working at this time.
Diagnosed that the primary and secondary drain lines were clogged causing the drain pan to overflow. I cleared the primary and secondary drain, treated drain, and then tested with three gallons of water and found that flow was restored to the drains. I inspected the drain pan for signs of cracks from the top and the bottom and found none. I wiped down areas I could reach for any water flowing where it should not have been. System operational.
Performed service diagnostic. Diagnostic found that the primary condensate drain line was clogged. Blower motor capacitor was below value. Condenser fan motor showed signs of overheating and the system was low on refrigerant. Options for repair were presented to customer and they chose to have the blower motor capacitor replaced today and also clear the drain. Blower motor capacitor was replaced. Drain line was cleared and flow tested with water. Drain line was also treated. System was running at the time of departure.
Performed maintenance on the AC system. I cleared and treated the drain. I also cleaned the condenser. Please see attached checklist for full tune-up details.
Diagnosed that the furnace switch had been turned off which stopped the system from receiving power. Customer decided to join our maintenance plan, so I performed a cool check on the system. I cleared the drain and treated the drain. Safety switch was wired incorrectly so I rewired it. I also cleaned the condenser. System is operational at this time.
Installed new 2.5 Rheem heat pump system. Built a transition to existing supply plenum and sealed with mastic airlock. Rebuilt and insulated condensate drain line. Installed new filter dryer, pressure tested with dry nitrogen, and pulled a vacuum on copper line set. Put down a plywood overlay. Sealed return chase with duct board and mastic. Ran new thermostat wire to both the condenser and air handler. Ran condenser wire in seal tight. Replaced high voltage wire from disconnect to condenser. Added a junction box inside air handed closet for condenser. Charged system to factory specs.
Diagnosed that the capacitor had failed not allowing the compressor to run. Also found air restriction due to dirty filter. Gave client options and they chose to have the capacitor replaced and the drain cleared today. Also recommended that the filters be changed immediately and each month moving forward.
Inspected all Performance, Mechanical and Safety Systems. Found the indoor blower motor of the American Standard split system to have failed, running constantly even with no call for cool. Also noted there is no return air duct for the upstairs portion of the home. I did turn the system on to test the temperature of the supply vents and verified they were within range of the manufacture’s guidelines for cooling operation. The system also needs an additional 12x12 return air grille in the air handler closet to allow for better circulation throughout the HVAC system. Installed new OEM motor from manufacture. Also installed new 12x12 return air grille, insulated return chase, and tested system. Everything is working at this time.