Kyle TX Heating & Air Conditioning Services

Performed heater tune-up. No major issues found, and the system is operational at this time. Once the tune-up was completed, I cleaned the top and sides of indoor air handler along with inside cabinet as well.

Performed heater tune-up. No major issues found, and the system is operational at this time. Once the tune-up was completed, I cleaned the top and sides of indoor air handler along with inside cabinet as well.

Performed heater tune-up. No major issues found, and the system is operational at this time. Once the tune-up was completed, I cleaned the top and sides of indoor air handler along with inside cabinet as well.

Performed heater tune-up. No major issues found, and the system is operational at this time. Once the tune-up was completed, I cleaned the top and sides of indoor air handler along with inside cabinet as well.

Performed heating maintenance on a two stage Rheem gas system. Checked all electrical, mechanical, safeties and performance of the system. Cleared and treated the drain line and cleaned the exterior of the furnace. The supply plenum was not sealed 100% to the evaporator coil so I used hard cast tape and sealed the system to prevent any air leaks. No other major issues were found, and the system is operational at this time.

Performed semiannual maintenance on one gas heating system. Inspected all Performance, Mechanical and Safety systems. Adjusted fuel pressure of the gas furnace to ensure 100% heating capacity. Also changed out two air filters provided by the homeowner. Everything is working at this time.

Performed semiannual maintenance on one gas furnace heating system. Inspected all Performance, Mechanical and Safety systems. Verified everything was operating within manufacture’s specifications for operation. Everything is working at this time.

On arrival, the customer stated that their unit started having issues roughly a week ago. During my diagnostic I found the capacitor on the condenser has fallen below manufacture specs. In addition, I found a clog in the drain line. I presented my findings to the homeowner, and they chose to have the drain line cleared but wait on replacing the capacitor. I cleared and treated the drain line. I then function checked the system and it is currently operational.

Heating tune-up completed on an up-flow gas system. I found that the capacitor for the blower motor is slightly below manufacture specs. No other major issues were found.

Performed semiannual maintenance on one gas furnace heating system. Inspected all Performance, Mechanical and Safety systems. Tested and verified everything was operating within manufacture’s specifications for operation. No major issues found.

Performed heater tune-up on two gas systems. Checked electrical, mechanical, safety, and performance of the systems. The attic drain line was loose at one of the 90s on the drain, so I glued the drain line back in place. The drain lines were cleared, and flow tested with two gallons of water. The drain lines were then treated. The duct work and blower wheels are clean. The wiring is tight and in good condition. The igniters are in good condition and operational. The flame sensors were cleaned. No other major issues found.

Performed heater tune-up. Checked electrical, mechanical, safety, and performance of the system. The duct work and blower wheel are clean. The wiring is tight and in good condition. The drain line was cleared, and flow tested with two gallons of water. The drain line was then treated. The static pressure is within factory specifications. Flame sensor was cleaned. Spark igniter is operational. Inducer fan motor is operational and running at a normal amperage. Condenser coil was cleaned. No major issues were found.

Performed heater tune-up. I found that the flame rod had some carbon build up, so I cleaned it off with steel wool. I also cleaned out some debris that was inside of the furnace. No other major issues found.

Performed heater tune-up. I found that the flame rod had some carbon build up, so I cleaned it off with steel wool. I also cleaned out some debris that was inside of the furnace. No other major issues found.

Performed heater tune-up. I found that the flame rod had some carbon build up, so I cleaned it off with steel wool. I also cleaned out some debris that was inside of the furnace. No other major issues found.