Wimberley TX Heating & Air Conditioning Services

Performed the heater tune-up on the Goodman heat pump system in the attic. Everything is coming on and working at this time.

When I arrived, the tenant informed me that he would set the thermostat to 73 and it would climb to 80. I performed a diagnostic and found that 5 kw of the 15 kw had been disconnected and looks like it has been for quite some time. Also, the tenant installed his own thermostat yesterday thinking that could be the problem. Everything is coming on and turning off the way it is supposed to. I informed the landlord and the tenant that the parts that are hooked up are working properly but the system is 20 years old and in poor condition. I did replace the heat sequencer at the request of the tenant and landlord.

Performed the heater tune-up on the Carrier heat pump system in the attic. While performing the inspection I did find the voltage enhancer to be weak and undervalued. (It is supposed to be a 45/5 but reading 44.8/3.1). I presented the customer with their options and they chose to have it replaced at the silver level at this time. After performing the silver level repair on the voltage enhancement system everything is working to industry standards at this time.

Performed diagnostics and found a faulty electrical connection on upstairs heat pump system. Cut and reconnected high voltage wiring with new wire nuts and preformed safety testing. System working at this time.

Performed the heater tune-up on the Carrier heat pump system in the attic. Everything is performing to industry standards at this time.

Performed the heater tune-up on the Carrier heat pump system in the closet. Everything is coming on and working to industry standards at this time.

Performed the heater tune-up on the Carrier Greenspeed heat pump system in the attic. Everything is working to industry standards at this time.

Performed the heater tune-up on the Carrier electric heat system in the attic. Everything is working to industry standards at this time.

Performed the heater tune-up and everything is working at this time. While performing the inspection I did find the voltage enhancer to be weak and undervalued. I gave the customer her options and she chose to wait on repairs. I also spoke to her about the Maintenance plan and she asked if we would call her in January to renew it at that time.

Performed the heater tune-up and everything is working at this time. While performing the inspection I did find the voltage distributor to be pitted and showing signs of failure. I gave the customer his options and he chose to have it replaced at the gold level at this time. After performing the gold level repair the system is up and running.

Performed the heater tune-up and everything is working at this time.

Performed the heater tune-up and everything is working at this time. While performing the inspection I did find the air purifier had completely failed. I gave the customer her options and she chose to have a new Reme Halo LED installed.

Performed diagnostic on system and found safety switch in an open position due to a bad connection. Switch was put back into housing and wiring was extended and secured. System is back up and cooling. I also walk customer through primary/secondary drain maintenance.

When I arrived, I diagnosed the compressor to be pulling locked rotor amps. I gave the customer her options and she informed me that they have a home warranty that will take care of it.

Installed new Carrier 3-ton heat pump in closet. Added 20x20 filter base and capped gas line. Installed new line filter drier and pressure tested system for extensive leak check. Pulled deep vacuum and ran new control wiring for both outdoor unit and Ecobee thermostat. Replaced flue pipe top piece and plugged indoor. Benchmarked system in heating and checked downstairs furnace in heating.

When I arrived, I turned the gas on to the fireplace and lit the standing pilot. Everything came on and worked for me. I turned it off and on multiple times and it started for me every time. I spoke with the customer and she asked me to get her prices to have the gas valve replaced. I spoke to the parts house and they are going to call me back when they find the part. He said it could be tomorrow before I hear back from him, but we will reach back out once part available. We will discount the repair by $125 on the replacement of the gas valve.

When I arrived, the customer informed me that the mini split system upstairs had overflowed over the weekend. I turned the system on and let it run for over an hour. Everything was draining outside and there was not even a drop of water that came from the unit. I spoke with Ryan and we talked about possibly running another clear drain tube for the drain line if it happens again. Everything is working at this time. Ryan said this is covered under parts and labor.

Please see attached quote for repairs. The supply registers need to be replaced, the buckets need to be re-insulated, and the ductwork needs to be cleaned because of growth issues. The system is capable of dehumidification but is not wired properly to have this operation of the system working.

Found that the 240 (high voltage) to the 4-ton condenser is not staying on, even with the disconnect off at the condenser.