HVAC Service In Buda, TX

Performed heating tune-up on a Carrier Infinity Series system. I discussed surge protection to protect HVAC equipment and system sterilization to improve indoor air quality with client. Customer has renewed the maintenance plan and will contact us if they choose to move forward with system enhancements.

Performed heating check on a Carrier heat pump system with whole house dehumidification. Found return plenum accumulating heavy amounts of debris and the 14x14x1 filter for dehumidification system heavily caked with dirt, dust, and debris. Client will get new filters immediately. I presented the client with options to clean return plenum and add system sterilizers to improve indoor air quality. Also discussed adding surge protection to protect HVAC equipment. Lastly, I found outdoor fan motor in poor condition. I replaced the outdoor fan today and created estimates for the system enhancements. Repair completed and system is operational.

Performed heating tune-up on a Trane gas system. Heating sequence is operational but found outdoor fan motor in poor condition. I presented options to replace outdoor fan motor and add surge protection to protect HVAC equipment. Client has approved both. Repair completed and surge protection installed, secured, and tested. System fully operational.

Performed heating tune-up on a Carrier gas system. I did find heavy amounts of mildew buildup in the return plenum and presented my findings to the customer. I did present options for system sterilizers to help prevent future mold growth and will send estimate for this.

Installed Trane 5-ton gas system in attic. Added new supply and return plenums and drain pan. Converted system to propane and rebuilt drain line with SS-2 and SS-3 safety switches. Installed new line filter dryer and pressure tested system for extensive leak check. Pulled deep vacuum and charged system to factory specs. Installed new Ecobee thermostat and rehung upstairs flex. System operating at this time.

Fan motor was replaced at no charge (There was an issue with the unit that we installed being loud).

Performed the heater tune-up on two systems and everything is working at this time.

Performed heat check on two systems. Checked electrical, mechanical, safety, and performance of the systems. System one in the offset garage had a condenser fan motor that showed signs of overheating. Options for repair on system one was presented, and customer decided to move forward. Repair completed and system tested. No other major issues were found. Drain lines were cleared and treated. Condenser coils cleaned. Both systems operational. Electrical disconnects confirmed in and on. Systems were running at time of departure.

Trip 1 - Performed heat check. Checked electrical, mechanical, safety, and performance of the system. System was not operating due to low pressure switch. Leak check found that there was a leak in the TXV. Will return to complete repair under parts and labor warranty. Trip 2 - Replaced indoor evaporator coil. Installed new line filter dryer and pressure tested system for extensive leak check. Pulled deep vacuum and weighed in new charge. Installed new SS-2 safety switch and insulated line. System charged to factory specs and working at this time.

Performed heat check. Checked electrical, mechanical, safety, and performance of the system with no major issues found. Drain line cleared and treated. Condenser coil cleaned. Electrical disconnect confirmed in and on. System set to 68° per customer. System was running at time of departure.

Performed heating tune-up on Carrier heat pump system. 20x20x4 Honeywell filter was changed out and dated. Also, a hard start kit was added to outdoor compressor to help prolong the life of the air conditioner. System is operational.

No heat due to gas valve in off position. Valve has been turned back on and system operational.

Had a discussion with the customer and he stated that he did not feel that our tech completed a diagnostic that would account for a $125 charge.

Performed heat check. Checked electrical, mechanical, safety, and performance of the system with no major issues found. Drain line cleared and treated. Condenser coil cleaned. Electrical disconnect confirmed in and on. System set to 74° per customer. System was running at time of departure.

Completed performance check. Checked electrical, mechanical, safety, and performance of the system with no major issues found. Drain line cleared and treated. Condenser coil cleaned. Electrical disconnect confirmed in and on system was running at time of departure.

Performed heat check. Checked electrical, mechanical, safety, and performance of the system. Signs of overheating was found on the condenser fan motor. Drain line cleared and treated. Condenser coil cleaned. Options for repair were presented to customer and they chose to move forward. Repairs were completed. Electrical disconnect confirmed in and on. System was running at time of departure.

Replaced the furnace control board and system is now operational.

Performed heat check on two systems. Checked electrical, mechanical, safety, and performance of the systems with no major issues found. Drain lines cleared and treated. Condenser coils cleaned. Electrical disconnects confirmed in and on. Systems were running at time of departure.