Kyle TX Heating & Air Conditioning Services

On arrival, I spoke with the homeowner, and they stated they had a power surge because all power in the garage was lost. Reset power to the system and found the thermostat has failed. I also noticed an electrical burning smell coming from the thermostat. Presented repair options and we have decided to move forward with installing a new Ecobee thermostat. Installed new thermostat and programmed it to match equipment specifications. Also connected the thermostat to Wi-Fi and the iOS application. Tested all systems and everything is working at this time.

Performed heat check. Checked electrical, mechanical, safety, and performance of the system. Both heat strips activated. Filter was clean and did not need to be changed. No major issues were found and system running at time of departure.

Replaced the indoor evaporator coil. Reconnected the condensate drain. Added an SS2 safety float switch. Replaced and relocated inline filter dryer. Pressure tested with dry nitrogen and pulled a vacuum on the copper line set. Pulled and cleaned the blower. Checked operation of the system and cleared condensate drain. System operational.

Performed service diagnostic. Diagnostic found that the condensate drain line is clogged. Water backed up into the safety switch and shut down the system and thermostat. The capacitor on the condenser unit is below value. Options for repair were presented to the customer and they chose to have the capacitor replaced and drain service completed. Capacitor for the condenser unit was replaced. Drain line was cleared and flow tested with water. Drain line was treated. System was function checked and was running at the time of departure.

Performed semiannual maintenance on two heat pump heating systems. Inspected all Performance, Mechanical and Safety Systems. Changed homeowner supplied filters and verified all systems were operating within manufacture’s specifications for operation. The Stage 3 Breathe Easy System in the main house is on and operating as designed.

Performed heating maintenance on one furnace system. Checked all electrical, mechanical and performance of the system. Customer did not have filters for replacement and she said she would order some and replace them as soon as possible. No other major issues were found. System is on at this time. See attached checklist for full tune-up details.

Performed a heating tune-up. After speaking with the homeowners, they mentioned a concern with a smell coming from their new air purifier, so we made sure to investigate that while we were in the attic. We adjusted the air purifier from the maximum output to a lower level for the size of the system. We then resumed the heating check over the furnace and discovered the following: the igniter was showing pitting and wear, and the inducer bearings were starting to go out. No other major issues found. The homeowners elected to renew their maintenance agreement and have the inducer motor and igniter replaced. I replaced the igniter and also replaced the inducer motor. System is in working order at completion of service.

Performed heat check. Checked electrical, mechanical, safety, and performance of the system. No major issues were found. Drain line was cleared and flow tested with water. Drain line was treated. Condenser coil clean. Electrical disconnect confirmed in and on. System was running at the time of departure. See attached checklist for full tune-up details.

Performed heating maintenance on one heat pump system. Checked all electrical, mechanical and performance of the system. Cleared and treated drain line and washed the outdoor condenser coil. Customer provided filter for replacement. No major issues were found. System is on and working at this time.

Performed heating maintenance on one furnace system. Checked all electrical, mechanical and performance of the system. Filter was replaced before my arrival. No major issues were found. System is on and working at this time.

Performed heating maintenance on one furnace system. Checked all electrical, mechanical and performance of the system. Filters were replaced before my arrival. No major issues were found. System is on at this time.

Performed semiannual maintenance on one gas heating system. Inspected all Performance, Mechanical and Safety Systems. Adjusted fuel pressure to match the system performance output to ensure 100% heating capacity. The 20x25x4 filter that is currently installed is still in a clean condition. Verified everything was operating within manufacture’s specifications for operation.

On arrival, I found that the outdoor unit was not receiving 24VAC control voltage. Was able to conclude that there is a break in the wire somewhere inaccessible in the wall or at eave of roof. The original control voltage has an additional wire that I used to replace the damaged common wire. Also noted that the air handler disconnect has become overheated at the terminal connection points and is not making solid contact across the pullout disconnect. Recommended running new control wiring and installing a new air handler disconnect to ensure proper high voltage pass through and proper control voltage being delivered to the outdoor heat pump. Ran new 18/10 wire to outdoor condenser in 1/2 EMT and secured to outside wall. Had to relocate the thermostat to the upstairs and ran new 18/10 to it. Replaced disconnect and whip at outdoor system. Replaced disconnect to air handler. Everything is operational at this time.

Installed 4-ton Carrier gas system. Installed Ecobee Pro and relocated thermostat upstairs. Built new extended supply and return plenums and sealed with mastic air lock. Replaced secondary drain pan. Rebuilt and insulated primary drain line. Added SS2 and SS3 safety float switches. Cleared drain and verified drain operation. Rebuilt Incoming gas line with a sediment trap. Replaced disconnect and whip at the outdoor system. Ran the low voltage in 1/2” Seal-Tite. Pressure tested system with nitrogen and pulled a vacuum on the line set. Verified system operation.

Performed heating maintenance on one furnace system. Checked all electrical, mechanical and performance of the system. Customer did not have a filter for replacement and said he would replace it as soon as possible. No major issues were found. System is on at this time.