Kyle TX Heating & Air Conditioning Services

Replaced supply plenum and reattached existing ducts. Reattached air purifier and sealed all connections with mastic air lock. Also completed a quick inspection of the system. Cleared and verified drain operation. Checked capacitor readings and system pressures. Everything is working at this time.

On arrival the customer stated that the system has been struggling. Diagnostic found that the furnace control board was not providing consistent voltage to the blower motor. Options for repair were presented to the customer and they chose to renew the maintenance plan and have the control board replaced today. Furnace control board was replaced. Heat check was performed, and no other major issues were found. Drain line cleaned and treated. System was running at the time of departure.

Performed heat check on 2 systems. Checked electrical, mechanical, safety, and performance of both systems. Flame ignition achieved and flame sensors cleaned. Filters changed on both systems with customer supplied filters. No major issues were found and systems were running at time of departure.

Performed heat check. Checked electrical, mechanical, safety, and performance of the system. Flame ignition achieved and flame sensor cleaned. Filter changed by customer before arrival. No major issues were found and system running at time of departure.

Service diagnostic found that the contactor in the condenser unit has failed. Options for repair were presented to the customer and they chose to have the contactor replaced today. I replaced the contactor and tightened down the power whip from the disconnect. System was function checked and was running at the time of departure.

Service diagnostic found that the capacitor on the condenser unit has failed. Options for repair were presented to the customer and they chose to have the capacitor replaced today. I replaced the capacitor and function checked the system. The system is operational and cooling at time of departure.

Performed heat check. Checked electrical, mechanical, safety, and performance of the system. Flame ignition achieved and flame sensor cleaned. Filter changed with customer supplied filter. Mini split on office shed inspected with no issues.

Installed new TXV. Replaced in line filter dryer, pressure tested with dry nitrogen and pulled a vacuum on the copper line set. Cleared the drain line and checked proper operation of the system. The system is working at this time.

Diagnostic found that the condensate drain line was clogged and water had tripped the safety switch. I cleared the drain and flow tested the system with water. Drain line was treated and the system was running at the time of departure.

Performed heat check. Checked electrical, mechanical, safety, and performance of the system. Flame ignition achieved and flame sensor cleaned. Filter changed prior to arrival. No major issues were found and system running at time of departure.

Performed heat check. Checked electrical, mechanical, safety, and performance of the system. Flame ignition achieved and flame sensor cleaned. Filter changed by customer before arrival. I did adjust some wiring and the pressure tube as the unit was short cycling. After making those adjustments, the system ran as intended. No other major issues were found and system running at time of departure.

Installed new 3-ton Carrier gas system. Installed new Ecobee Lite thermostat. Rebuilt and insulated condensate drain line. Added SS2 and SS3 safety float switches. Installed new filter dryer, pressure tested with dry nitrogen and pulled a vacuum on the copper line set. Replaced the condenser pad. Replaced the disconnect and ran the low bottom in Seal-Tite. Replaced both supply and return plenums and sealed with mastic airlock. Charged system to factory spec. System is working properly at time of departure.

Service diagnostic found that the capacitor on the condenser unit has failed. Condenser fan motor showed signs of overheating. Options for repair were presented to the customer and they chose to have the capacitor replaced. Condenser capacitor was replaced and the system was function checked. System was running at the time of departure.

Performed heat check. Checked electrical, mechanical, safety, and performance of the system. Flame ignition achieved and flame sensor cleaned. Filter changed with customer supplied filter.

Performed heat check. Checked electrical, mechanical, safety, and performance of the system. Flame ignition achieved flame sensor cleaned. Filter had already been changed by the customer prior to my arrival. No major issues were found and system running at time of departure.