Kyle TX Heating & Air Conditioning Services

Performed diagnostic. I found that the system has a 4-inch media filter and a 1-inch filter. They were both extremely dirty and restricting airflow through the system. I informed the homeowner that they only need one filter and multiple filters will create an airflow restriction. It will also create an airflow restriction when dirty. He chose to keep the 4-inch media filter and have it replaced at this time. I replaced the filter and watched the system run for 30 minutes. Everything is working at this time.

Performed service diagnostic. Diagnostic found that the condensate drain line was clogged. Water had backed up and tripped the safety switch. Options for repair were presented to the customer. They chose to move forward with a drain service today and to sign up for our Gold Maintenance plan on both systems. Drain line was cleared and flow tested with water. Drain line was treated. System was running at the time of departure.

Performed the AC tune-up. Cleared and treated the drain line. Condenser coil clean. I did find that the condenser fan motor is leaking lubricant on all sides. No other major issues found. Presented repair options and the homeowner decided to move forward with replacement of the fan motor. Repair completed and system is operational.

Performed diagnostic. I found that the starter was burnt and pitted at the contacts and was not passing voltage. I replaced the starter and cycled the thermostat. I also replaced the filter for the homeowner. No other major issues were found. System is on and working at this time.

Performed diagnostic. I found that the furnace control board was not sending power to the blower motor. I ordered and replaced the board and once I got power back to the motor, I found that the motor was shorted to ground. I ordered a new motor and replaced it, and everything is on and working at this time. I talked to the homeowner about multiple other deficiencies with the system as well.

Performed diagnostic. I found that the thermostat was not getting 24 volts due to the float switch that was not passing power. I replaced the float switch and cycled the thermostat. System is operational at this time.

On arrival, I spoke with the homeowner, and she stated that she would hear a loud screeching noise when the outdoor unit was running. I removed power from the unit, then restored power and noticed the fan motor was having a hard time starting up. I verified the run capacitor was within value and visually inspected the outdoor fan motor. I noticed lots of oil on the condenser fan motor wiring. Presented repair options and we chose to move forward with a new fan motor. Replaced fan motor and tested system. Everything is working at this time.

Performed semiannual maintenance on one cooling system. Inspected all Performance, Mechanical and Safety Systems. Verified everything was operating within the manufacture’s specifications for operation. Indoor system drain line cleared and treated. Outside condenser refrigerant pressures are within range and condenser cleaned. Noticed that the fan motor is showing signs of overheating and the capacitor is below value. No other major issues found. Presented repair options and the homeowner chose to have both components replaced today. Replaced the fan motor and capacitor. System is operational.

Installed new 3.5-ton mobile home system. Installed new Honeywell thermostat. Replaced gas valve for the furnace. Replaced pass through duct underneath house. Installed new liquid line filter dryer. Replaced disconnect and whip. Ran control wire in Seal-Tite. Pressure tested and pulled a vacuum on the copper line set. Verified system operation in cooling and verified system charge was to manufacturers specifications.

Performed service diagnostic. Diagnostic found that both zones for the system are operational. Dampers are operating. System was cooling at 12 degrees of sub cooling which is within manufacture specifications. The capacitor on the condenser unit is depleted, preventing the reliable start of the compressor. Options for repair were presented to the customer and they chose to have the capacitor replaced today. Capacitor was replaced and the system was function checked. System was running at the time of departure.

Performed semiannual maintenance on one cooling system. Inspected all Performance, Mechanical and Safety Systems. Verified everything was operating within the manufacture’s specifications for operation. Both indoor system’s drain lines cleared and treated. Both outdoor condenser refrigerant pressures are within range and condensers cleaned. I did find that the condenser fan motor for the downstairs system is showing signs of overheating and the capacitor is below value. No other major issues found.

Performed diagnostic I found that the system was slightly undercharged. I informed the homeowner and she chose to have refrigerant added today. I added 1 pound of refrigerant and the system is operational at this time.

On arrival, I spoke with the homeowners, and they stated that during the day the indoor unit would continue to run but the outdoor unit would turn off. I visually inspected the indoor system and noticed the primary drain line to be severely backed up with water, touching the emergency water safety switch on the unit. I flushed and treated the primary drain and reset the cooling system. Inspected all Performance, Mechanical and Safety Systems. Also secured the high voltage compressor wires as they were rubbing into the vapor refrigerant line inside the outdoor heat pump. Lastly, I noticed that the Carrier badge on the outdoor heat pump had broken off, so I replaced it with a new one. Everything is working at this time.

Installed new Carrier 5-ton gas system. Installed new Ecobee Pro thermostat. Rebuilt and insulated condensate drain line. Added SS2 and SS3 safety float switch. Replaced secondary drain pan. Installed new filter dryer, pressure tested with dry nitrogen and pulled a vacuum on the copper line set. Replaced both supply and return plenums and sealed with a mastic airlock. Replaced the disconnect and whip on the condenser. Put down a new condenser pad. Charged system to factory spec. System is working properly at time of departure.

Checked over the system, no issues were found with the operation of the unit. System was most likely affected by the power outages running through Kyle this weekend. Ryan and Eli wish for you to review our service on Google.