Kyle TX Heating & Air Conditioning Services

Performed service diagnostic. Diagnostic found that the condensate drain line was clogged. Drain line was cleared and treated. System was running at the time of departure.

Performed service diagnostic. Diagnostic found that the capacitor on the condenser unit has failed. Options for repair were presented to the customer and they chose to have the capacitor replaced today. Capacitor was replaced and the system was function checked. System was running at the time of departure.

Performed service diagnostic. Diagnostic found that the capacitor on the condenser unit has failed. Options for repair were presented to the customer and they chose to have the capacitor replaced today. Capacitor was replaced and the system was function checked. System was running at the time of departure.

Rebuilt and insulated condensate drain line. Added SS2 safety float switch. Replaced secondary drain pan. Installed new filter dryer, pressure tested with dry nitrogen and pulled a vacuum on the copper line set. Built a transition to existing supply plenum and sealed with mastic airlock. Put down a plywood overlay. Installed two new 14x30 RAFGs. Replaced disconnect and whip. Ran new low voltage in Seal-tight. Installed and leveled new condenser pad. Charged system to factory spec. System is working properly at time of departure.

Installed Carrier Ductless system with 2 heads. Mounted the condenser to the exterior wall with a bracket. Replaced the disconnect and whip. Pressure tested both line sets and pulled a vacuum on them. Verified system operation. Verified drain operation. Cleared drain on upstairs system. System operational.

Performed diagnostic. I found that the starter at the condenser had ants in it and was not passing 240 volts to the compressor and fan motor. I presented my findings to the homeowner, and they chose to have it replaced today. I replaced the starter and sprayed the electrical with JS 685 ant deterrent. System is working at this time.

Performed diagnostic on a 2001 Goodman R-22 heat pump. I found the capacitor has failed on the fan side and the condenser fan motor is showing signs of overheating. I also informed the customer of multiple other deficiencies with the system including a leak in the evaporator coil. Presented repair options and he chose to have the capacitor replaced today. Capacitor replaced and system is currently operational.

Upon arrival, I noticed that the outside system was not running, but the indoor system was. Checked over all mechanical components. I found that the capacitor on the fan side has no value. Presented my findings to the homeowner and they have decided to move forward with capacitor replacement. Replaced the capacitor and checked over the system. After letting the system run for a little while, I noticed that the refrigerant levels were slightly low. The system uses R-22 refrigerant which is no longer made. I did inform the customer that due to this, they should plan for system replacement in the future.

Performed semiannual maintenance on one cooling system. Inspected all Performance, Mechanical and Safety Systems. Verified everything was operating within the manufacture’s specifications for operation. Indoor system drain line cleared and treated and filter changed. Noticed that thermostat wire running from evaporator had chew marks on it. Repaired with tape and brought to homeowners’ attention. Outside condenser refrigerant pressures within range and condenser cleaned. Leaves removed from inside of the condenser. No other major issues were found and system running at time of departure.

Performed the AC tune-up. Cleared and treated the drain line. Condenser coil clean. No major issues were found.

Upon arrival, I noticed that the outdoor condenser was not running but the indoor system was. After diagnosing the system, I found that the capacitor and starter are below value. The condenser fan motor has also overheated and seized up. Presented repair options to the homeowner and he has decided to move forward with repairs. Completed repairs and the system is now operational.

Upon arrival at the residence, I noticed that the outside condenser fan was not running. After entering the home, I found that the indoor system was running. After checking through the system, I found that the drain line was clogged with water. I presented repair options and the customer chose to move forward with drain service. Cleared the drain line and then tested with a couple of gallons of water. Treated drain line. System operational at this time.

On arrival, found the outdoor run capacitor has failed below value. Installed new run capacitor and reset the cooling system. Inspected all Performance, Mechanical and Safety Systems. Everything is working at this time.

Performed service diagnostic. Diagnostic found that the condensate drain line is clogged; water had backed up and tripped the safety switch. Options for repair were presented to the customer and they chose to have the drain cleared and sign up for our maintenance plan. We will complete the first maintenance visit in Fall/Winter. Drain line was cleared and flow tested with water. Drain line was treated. System was running at the time of departure.

Performed service diagnostic. Diagnostic found that the system is operational. System was cycled on and off three times and the condenser fan motor came on each time. Capacitor on the system is within manufacture specifications. I spoke with the customer about what his options were and he chose to have the capacitor and condenser fan motor replaced just to be safe. Repairs were completed and the system was function checked. System was running at the time of departure.