Kyle TX Heating & Air Conditioning Services

Performed semiannual maintenance on one cooling system. Inspected all Performance, Mechanical and Safety Systems. Verified everything was operating within the manufacture’s specifications for operation. Outside condenser refrigerant pressures are within range and condenser clean. Indoor system drain line cleared and treated and filter changed. No major issues were found and system running at time of departure.

Installed new 3.5-ton Carrier system. Installed a new Ecobee thermostat. Rebuilt and insulated primary drain line. Cleared drain and verified drain operation. Installed SS2 and SS3 safety float switches. Built new supply plenum and return plenum and sealed with mastic airlock. Replaced disconnect and whip at the outdoor condensing unit. Installed new filter dryer, pressure tested the copper line set with nitrogen and pulled a vacuum on the line set. Charged system to factory spec. System is working properly at time of departure.

Performed diagnostic. I found that the outdoor capacitor has failed, and the condenser fan motor is showing signs of overheating and leaking lubricant. I presented options to repair, and he chose to have both the motor and capacitor replaced at this time. He also wanted to join our Gold Maintenance plan which he will start this Fall/Winter. Complete repairs and cycled thermostat. System operational upon completion of repairs.

Performed diagnostic. I found that the outdoor capacitor has failed. I also informed the customer that the condenser fan motor is showing signs of overheating and leaking lubricant. I presented options to repair, and he chose to have the capacitor replaced today. Cycled thermostat and the system is on and running at this time.

Found the outdoor run capacitor and outdoor exhaust motor have failed. I installed a new run capacitor and new outdoor condenser fan motor and tested the cooling system. I found the system to be operating with a 12°SH and a 10°SC. The system had also been freezing up and I feel this was due to the downstairs zone damper becoming stuck closed. I tested the damper multiple times and verified it was open and closing properly before leaving the home. Everything is working at this time.

I replaced the condenser fan motor and cycled the thermostat. System operational at this time.

Perform diagnostic. I found that the outdoor capacitor has failed on the fan side and the condenser fan motor is showing signs of overheating. Repair options presented and the homeowner chose to have the capacitor replaced today. Repair completed and system is operational.

Performed the AC tune-up. Drain line cleared and treated. Condenser coil clean. I found that the condenser fan motor is leaking lubricant. No other major issues found. I presented repair options for the fan motor to the homeowner but they declined at this time. Will send an estimate via email.

Performed diagnostic. I found that the blower motor has failed. Replaced blower motor and cycled the thermostat. On arrival the house was at 87 and after running it for 15 minutes it is now 84. The system is on and working at this time. I did remove the filter and informed customer to replace it tomorrow morning when the house has cooled down.

Installed new 3.5-ton Carrier gas system. Installed new plywood overlay. Installed new filter base. Rebuilt and insulated condensate drain line. Added SS2 safety float switch. Cleared and treated drain and verified operation. Transitioned to supply plenum and sealed with mastic air lock. Installed new filter dryer, pressure tested with dry nitrogen and pulled a vacuum on the copper line set. Replaced disconnect and whip at outdoor system. Verified system is to factory spec. System is working properly at time of departure.

Performed diagnostic and I found that the outdoor capacitor has failed on the fan side. I also informed the customer that the condenser fan motor is showing signs of overheating and the system is slightly low on refrigerant. I presented options to repair, and they chose to have the motor and the capacitor replaced and add refrigerant to the system. They also chose to join our Gold Maintenance Plan which they will start this Fall/Winter. Performed repairs and added 12 ounces of refrigerant. System is on and working at this time.

Performed diagnostic and I found that the outdoor capacitor has failed. I also found that the condenser fan motor is leaking lubricant. Lastly the system is low on refrigerant. Presented repair options and she chose to have the capacitor and fan motor replaced at this time. I completed repairs, cycled the thermostat and the system is running at this time.

Performed semiannual maintenance on one cooling system. Inspected all Performance, Mechanical and Safety Systems. Verified everything was operating within the manufacture’s specifications for operation. Outside condenser refrigerant pressures are within range and condenser cleaned. Indoor system drain line cleared and treated and filter changed. No major issues were found and system running at time of departure.

Performed semiannual maintenance on one cooling system. Inspected all Performance, Mechanical and Safety Systems. Verified everything was operating within the manufacture’s specifications for operation.

Replaced the indoor TXV. Replaced the in-line filter dryer, pressure tested with dry nitrogen and pulled a vacuum on the copper line set. Charged system to factory specs and checked operation. System is working properly at this time.