Kyle TX Heating & Air Conditioning Services

Service diagnostic found that the capacitor on the condenser unit had failed. Options for repair were presented to the homeowner, she chose to have the capacitor replaced and to sign up for maintenance. I replaced the capacitor and function tested the system. The system was running at the completion of service.

Performed a/c tune-up on a Trane straight cooling system. Checked the electrical, mechanical and performance systems of the unit. Cleared, cleaned, flushed and treated the drain line and washed the outdoor coil. Replaced the AprilAire 210 filter for the homeowner with a Garner AC supplied filter. No major issues were found. The system is operational at this time.

Service diagnostic found that the fan shroud on top of the condenser had rusted and the screws holding the plastic inner shroud had broken through. This was allowing the condenser fan blades to run against the plastic shroud. I also found that the capacitor on the condenser unit was below value. Options for repair were presented to the homeowner and he chose to have the capacitor replaced and to sign up for maintenance. I replaced the capacitor and used new wider screws to secure the fan shroud together. I function tested the system and the system was running at the completion of service.

Performed a/c tune-up on a Carrier heat pump system. Checked the electrical, mechanical and performance systems of the unit. Cleared, cleaned, flushed and treated the drain line. Verified outdoor compressor wiring is secure and washed the outdoor coil. I did change the fan setting on the homeowners thermostat schedule settings from on and set it to auto. This will help control the humidity levels in the home better. No major issues were found. The system is operational at this time.

Performed AC cooling check. Checked the electrical, mechanical, safety, and performance of the system. I cleared the condensation drain line and flow tested the drain with two gallons of water. I also treated the drain line. I cleaned the condenser coil. No major issues were found. The system was running at the completion of service.

Installed Carrier furnace. Installed Carrier 4 ton condenser. Installed Ecobee thermostat. Installed new secondary drain pan. Rebuilt and insulated primary and secondary drain lines. Installed SS2 and SS3 Safety float switches. Cleared drain and verified operation. Installed new return and extended supply plenum. Attached all existing duct work and sealed with mastic. Replaced gas flex and installed flu pipe. Pressure tested lineset and pulled a vacuum. Function checked the system. Everything is working at completion of install.

After speaking with the homeowners, I found that they were experiencing “temperature creep” due to the high heat index Thursday and Sunday. I looked over the system and found that It was working properly. I did point out that the condenser fan motor was overheated and leaking grease though. They did choose to have that replaced today. I installed and programmed the new motor and the system is working at the completion of the service.

Diagnosed a failing condenser fan motor. I spoke with Charlene about the motor and showed her how rough it was operating. She agreed to have the motor replaced today. The motor has been changed and programmed. System is operating the completion of service.

Performed AC cooling check. Checked the electrical, mechanical, safety and performance of the system. The drain line was cleared, and flow tested with water. I also treated the drain line. The air filters were replaced with customer supplied filters. The condenser coil was cleaned. No major issues were found. The system was running at time of departure.

Installed whole home ducting system with new buckets, registers, plenum, and flex. Hung and sealed ducting and verified system operation. Also cleared drain line and installed UV lights and power pack in coil. Everything working at this time.

Service diagnostic found that the condensation drain line was clogged. Water had backed up into the safety switch and shut down the system. Options for reply were presented, and the homeowner chose to have the drain line cleared. I cleared the drain line and flow tested the drain with water. I also treated the drain line. I function tested the system and the system was running at the completion of service.

Performed AC cooling check. Checked the electrical, mechanical, safety, and performance of the system. I cleared the condensation drain line and flow tested the drain with water. I also treated the drain line. The air filters were clean and had been recently replaced by the homeowner. The system was running at the completion of service.

Diagnostics found the float switch tripped killing power to the unit. Further diagnostics found an extremely dirty blower wheel and a torque booster well below manufacturers recommended charge. I went over my findings and the homeowner chose to sign up for our gold membership, replace the torque booster, and clear the clog in the primary drain. I replaced the torque booster and cleared and treated the drain. I cycled the system on and monitored the system for approximately 10 minutes listening for abnormal sounds coming from the condenser and did not hear any. The system was running at completion of service.

Installed Carrier 3 Ton furnace and installed new extended supply and a new return plenum. Replaced secondary drain pan. Installed Ecobee pro thermostat. Rebuilt and insulated primary and secondary drain line. Installed SS2 and SS3 safety float switches. Cleared drain and verified operation. Replaced gas flex line. Re attached existing duct work and sealed all connections with mastic. Replaced disconnect and whip at outdoor unit. Pressure tested and pulled a vacuum. Weighed in additional refrigerant to meet manufacturer specifications. Tested system operation in heating and cooling. Everything is working at completion of install.

Diagnostics found the float switch tripped due to a clogged primary drain line. I discussed repair options with the homeowner. He chose to sign up for our gold membership and have his drain line flushed, cleaned, and treated. I cleared and treated the drain line and function checked the system. The system was cooling at completion of service.