Kyle TX Heating & Air Conditioning Services

AC cool check was completed on a horizontal zoned straight cool system. Drain line was flushed and treated. Outdoor coils were cleaned. All mechanical and electrical components were checked. No major issues were found. The system was running at completion of service.

Removed the existing 7 inch flex duct to the front bedroom. Sealed the I-box supplying the room with mastic to the Sheetrock and all of the seams. Installed and sealed new 7 inch collar on the supply plenum. Ran all new 7 inch flex duct, re-routed to have less severe bends for better airflow. Tested system operation. Everything is working at completion of service.

Pumped down existing refrigerant. Removed existing liquid line filter drier and installed new one in the attic. Repaired the leak at the 3/8 copper connection to the coil in the attic. Cleared primary drain with CO2 and primed with water. Pressure tested system with nitrogen and pulled vacuum. Applied JS685 repellant to the condenser service area. Charged AC with R-410A refrigerant to ~10 degrees subcooling. Testing operation of system. Everything is working at completion of service

Installed new 5 ton 2 stage Carrier gas system in attic. Added new extended supply and oversized RA with two 310 media cabinets. Rebuilt drain line with overflow switches, added line filter drier and pressure tested system for extensive leak check. Pulled deep vacuum and weighed in factory charge. Corrected ducting from a triangle to dedicated runs with fabricated metal wyes to the master bed and bath. Installed attic insulation tent. Everything is working at completion of install.

Service diagnostic found that the capacitor on the condenser unit had failed. Options for repair were presented to the homeowner and Bill chose to have the capacitor replaced. I replaced the capacitor and function tested the system. The system was running at the completion of service.

Performed a/c tune-up on a Carrier straight cool system. Checked the electrical, mechanical and performance systems of the unit. Cleared, cleaned, flushed and treated the drain line. Secured outdoor compressor wiring and washed the outdoor coil. No major issues were found. All surge protection devices are working. The system is operational at this time.

AC cool check was completed on a horizontal straight cool system. Drain line was flushed and treated. Outdoor coils were cleaned. All mechanical and electrical components were checked. The indoor blower motor is leaking lubricant. Emergency drain pan is filled with rust. Outdoor contractor is pitted and charred. Outdoor condenser fan motor has overheated multiple times and should be replaced. I also found high in amps rush to the compressor. I went over my findings and repair options with the homeowner

Installed new outdoor compressor. Added new line filter drier inside, and pressure tested system for extensive leak check. Pulled deep vacuum and weighed in new factory charge. Cleared drain line and also installed new easy start. Everything is working at completion of service.

Performed a/c tune-up on a Carrier heat pump system. Checked the electrical, mechanical, and performance systems of the unit. Cleared, cleaned, flushed and treated the drain line. Air filters were replaced recently and are clean. Verified outdoor compressor wiring is secure and washed the outdoor coil. No major issues were found. All UV lights and surge protection devices are on and working. The system is operational at this time.

AC cool check was completed on a horizontal heat pump system. Drain line was flushed and treated. Outdoor coils were cleaned. All mechanical and electrical components were checked. I did find the in rush amps to the compressor have exceeded manufacturer limitations. No other issues were found. The system is cooling at completion of service.

Performed AC cooling check. Checked the electrical, mechanical, safety, and performance of the system. I cleared the condensation drain line and flow tested the drain with two gallons of water. I also treated the drain line. The air filter was clean and had been recently replaced by the homeowner. No major issues were found. The system was running at the completion of service.

Service diagnostic found that the furnace control board was not sending the 24v signal consistently to the blower fan. The board would send 24v to the blower fan and it would run for about 2-5 seconds before it would lose the signal and the fan would stop. Options for repair were presented to the homeowner and he chose to have the furnace control board replaced. I picked up the new control board and returned to the job. I replaced the furnace control board and function tested the system. The system was running at the completion of service.

Service diagnostic found that the capacitor on the condenser unit had failed. Options for repair were presented to the homeowner and he chose to have the capacitor replaced. I replaced the capacitor and function tested the system. The system is now operational and was running at the completion of service.

Performed a/c tune-up on an American Standard heat pump system. Checked the electrical, mechanical and performance systems of the unit. Cleared, cleaned, flushed and treated the drain line and cleaned the exterior of the air handler. I did find the system is low on refrigerant charge. Also found the outdoor starter is starting to get pitted at the contacts. Spoke with the homeowner and he chose to have refrigerant added to the system. I added 5 lbs of R-410A refrigerant and function tested the system. It now has a 20 degree split and 8 degrees of subcool. The system is running at completion of service

Service diagnostic found that the condensation drain line was clogged. Water had backed up into the safety switch and shut down the system. I performed the AC cooling check. Checked the electrical, mechanical, safety, and performance of the system. I cleared the condensation drain line and flow tested the drain with water. I also treated the drain line. No major issues were found. The system was running at the completion of service.