Kyle TX Heating & Air Conditioning Services

Service diagnostic found that the condensation drain line was clogged. Water had backed up into the safety switch and shut down the system. Options for repair were presented to the homeowner. Randy chose to have the drain line cleared. I cleared the condensation drain line and flow tested the drain with two gallons of water. I also treated the drain line. I function tested the system and the system was operating normally. The system was running at the completion of service.

Service diagnostic found that the condensation drain line was clogged. Water had backed up into the safety switch and shut down the system. Options for repair were presented to the homeowner and he chose to have the drain line cleared. I cleared the condensation drain line and flow tested the drain with two gallons of water. I also treated the drain line. I function tested the system and the system was operating normally. The system was running at the completion of service.

Performed AC cooling check. Checked the electrical, mechanical, safety, and performance of the system. I cleared the condensation drain line and flow tested the drain with two gallons of water. I also treated the drain line. The air filters were clean and had been recently replaced by the homeowner. The condenser coil was cleaned. No major issues were found. The system was running at the completion of service.

Pumped down existing refrigerant to the condenser. Installed new evaporator coil with new TXV metering device. Sealed the hole where the plenum goes up into the attic. Cleared the primary condensation drain and primed with water. Reinstalled the existing UV light. Installed new liquid line filter drier. Pressure tested system with nitrogen and pulled vacuum. Charged AC with R-410A refrigerant according to the subcooling chart on the condenser. Tested operation of system including both zones. Everything is working at completion of service.

Installed Carrier 3.5 ton heat pump. Installed new plywood overlay. Installed new supply plenum. Re attached all duct work and sealed with mastic. Rebuilt and insulated primary drain line. Cleared drain and verified operation. Installed new disconnect and whip at outdoor condensing system. Pressure tested system with nitrogen and pulled a vacuum. Everything is working at completion of install.

Service diagnostic found that one of the mini split head units had a drain clog. Spoke with the homeowner and she chose to have the drain line cleaned out. I cleared the drain line and tested both indoor head units with water to verify it is draining outside. I then treated both indoor coils and watched the system run for 15 minutes with no issues. The system had a 20 degree temp split and is operational at completion of service.

Performed a/c tune-up on a Carrier heat pump system. Checked the electrical, mechanical and performance systems of the unit. Cleared, cleaned, flushed and treated the drain line and cleaned the exterior of the air handler. All UV lights, air purifier and surge protection devices are on and working. Verified outdoor compressor wiring is secured and washed the outdoor coil. Did find the outdoor compressor has a hot spot but it is still working within manufacturer specs. No other issues were found. The system is operational at this time.

Service diagnostic found that the capacitor on the condenser unit was below value and the contactor had failed. Options for repair were presented to the homeowner. She chose to have the capacitor and contactor replaced. I replaced the capacitor and contactor on the condenser unit and function tested the system. The system was operational and was running at the completion of service.

Performed AC cooling check. Checked the electrical, mechanical, safety, and performance of the system. I cleared the condensation drain line and flow tested the drain with two gallons of water. I also treated the drain line. The air filter was clean and had been recently replaced by the homeowner. No major issues were found. The system was running at the completion of service.

Service diagnostic found the primary drain line was extremely clogged. This tripped the water safety switch which caused the outdoor system to shut off to prevent any water overflow in the closet. Presented repair options to the homeowner and they chose to have the drain line cleaned out. I cleared and treated the drain line and tested it with 2 gallons of water. System had a 17-18 degree temp split. No other issues were found. The system is operational at this time.

Performed the AC cooling check. Checked the electrical, mechanical, safety, and performance of the system. I cleared the condensation drain line and flow tested the drain with two gallons of water. I also treated the drain line. The air filter was replaced with a customer supplied filter. No major issues were found. The system was running at the completion of service.

Cool check has been completed on horizontal straight cool system. Condensation line has been cleaned and treated. Outdoor coils have been rinsed off. During the maintenance, I checked all mechanical and electrical components. I also performed a leak search for refrigerant. Currently the unit is operating properly and within manufacture specifications, with the exception of high static pressure.

AC cool check was completed on a horizontal straight cool system. Drain line was flushed and treated. Outdoor coils were cleaned. All mechanical and electrical components were checked. I did find the outdoor fan motor leaking lubricant. I also found in rush amps to the compressor exceeding manufacturers limitations. The system was cooling at completion of service.

Installed 3.5 ton Carrier R-454B heat pump system with electric heat kit. Installed EcoBee pro thermostat. Built and installed new return plenum and extended supply plenum. Sealed all ductwork connections with mastic/hardcast. Rebuilt primary condensation drain line going into a 1.5 inch vent pipe. Added SS2 and SS3 safety switches. Cleared and primed with water. Installed new secondary drain pan and added insulation to the secondary PVC. New disconnect box/wiring and pad for the condenser. Pressure tested system with nitrogen and pulled vacuum. Charged AC with R-454B refrigerant. Tested heating and cooling operation of new system. Everything is working at completion of install.

Service diagnostic found that the system was low on refrigerant. I performed a leak check and did not find a leak in the system. Options for repair were presented to the homeowner and they chose to have the system charged with refrigerant. I added 4lbs of R-410A to the system and brought the system up to 10 degrees of sub cooling. The system was running at the completion of service.