Kyle TX Heating & Air Conditioning Services

AC cool check completed on a vertical heat pump system. Drain line was flushed, cleared, and treated. Outdoor coils were cleaned. All mechanical and electrical components were checked. I did find in rush amps to the compressor exceeding manufacturers limitations. I went over my findings with the homeowner and discussed installing a soft start kit. He chose to move forward with the repair. The soft start kit was successfully installed. After installation, the unit was cycled to verify proper operation. Everything is working at completion of service.

Performed a/c tune-up on a Carrier Infinity heat pump system. Checked the electrical, mechanical and performance systems of the unit. Cleared, cleaned, flushed and treated the drain line. Cleaned the exterior of the air handler and washed the outdoor coil. Removed the indoor blower housing. Disassembled the blower housing and deep cleaned the blower wheel. Reassembled the blower housing and installed it back into the furnace system. The cleaner blower wheel will put less stress on the blower motor as it moves air through the system and will help extend the life of the motor. I then installed an ICM voltage monitor at the outdoor system. Verified all wiring is tight and programmed the voltage monitor to the correct settings. Once work was completed, I cycled power at the thermostat and verified the system is operational.

Cool check completed on a vertical straight cool system. Drain line was flushed and treated. Outdoor coils were cleaned. All mechanical and electrical components were found within manufacturer specifications. No major issues were found. The system is cooling properly at time of departure.

Service diagnostic found the primary drain line was clogged. This tripped the water safety switch and caused the outdoor unit to shut off. I also found the outdoor fan motor and compressor have a hot spot. The compressor is also doing high amps on startup. The heat pump breaker felt spongy when I reset it. Presented repair options and the homeowner chose to have the drain line cleaned at this time. I cleared, cleaned, and treated the drain line and function tested the system. The system is operational at completion of service.

Service diagnostic found the primary drain line was clogged. This tripped the water safety switch and shut off the outdoor system. It was time for their a/c tune-up for this year so I went ahead and completed it today. Performed a/c tune-up on a Rheem heat pump system. Checked the electrical, mechanical and performance systems of the unit. Cleared, cleaned, flushed and treated the drain line and cleaned the exterior of the air handler. I did find the indoor coil is dirty and is causing the drain to back up frequently. The indoor blower wheel also has some dirt in it. I also noticed a lot of ants around the outdoor system as well. The system is operational at completion of service.

Service diagnostic found that the condensation drain line was clogged. Water had backed up into the safety switch and shut down the system. I removed the float switch and the system ran in cooling mode. I cycled the system on and off four times testing to see if the circuit breaker would trip. The system ran each time without issue. Options for repair were presented to the homeowner and he chose to have the drain line cleared. I cleared the drain line and flow tested the drain with water. I also treated the drain line and replaced the air filter with a client supplied filter. I function tested the system and the system was running at the completion of service.

Performed AC cool check. Checked the electrical, mechanical, safety, and performance of the system. I cleared the condensation drain line and flow tested the drain with two gallons of water. I also treated the drain line. The air filter was clean and had been recently replaced by the homeowner. No major issues were found. The system was running at the completion of service.

Performed AC cool check. Checked the electrical, mechanical, safety, and performance of the system. I cleared the condensation drain line and flow tested the drain with two gallons of water. The air filters were clean and had been recently replaced by the homeowner. No major issues were found. The system was running at the completion of service.

Performed a/c tune-up on a Rheem heat pump system. Checked the electrical, mechanical and performance systems of the unit. Cleared, cleaned, flushed and treated the drain line. Cleaned the exterior of the air handler and washed the outdoor coil. Replaced the filter with a client supplied filter. No major issues were found. The system is operational at this time.

On arrival I found that the thermostat was off and not receiving power from the system. I went up to the furnace and found that the panel was not holding the door switch closed and this was keeping the system off. I performed a AC cool check. Checked the electrical, mechanical, safety, and performance of the system. I cleared the condensation drain line and flow tested the drain with two gallons of water. I also treated the drain line. The air filter was replaced with a client supplied filter. No major issues were found. The system was running at the completion of service.

Performed a/c tune-up on a Carrier straight cool system. Checked the electrical, mechanical and performance systems of the unit. Cleared, cleaned, flushed and treated the drain line. Cleaned the exterior of the air handler and washed the outdoor coil. I did find the return ducting has high static pressure. The outdoor capacitor is below manufacturer specifications and the fan motor has a hot spot. No other issues were found. The system was running at completion of service.

AC cool check completed on a horizontal straight cool system. Drain line was flushed and treated. Outdoor coils were cleaned. All mechanical and electrical components were found within manufacturer specifications. No major issues were found. The system is running at completion of service.

Performed a/c tune-up on a Carrier straight cool system. Checked the electrical, mechanical and performance systems of the unit. Cleared, cleaned, flushed and treated the drain line and cleaned the exterior of the air handler. Secured outdoor compressor wiring and washed the outdoor coil. Did also notice the return air ductwork has high static pressure but there is no space for improvements. The indoor secondary drain pan has a rust spot. The metering device could be starting to go out as it is not maintaining a constant superheat. The outdoor fan motor has a hotspot. Spoke with the homeowner and he chose to add refrigerant to the system. I added 12oz of refrigerant. System is now at 10 degrees subcool as rated per manufacturer. I also performed a leak search on the system and no leaks were found. The system is operational at this time.

Performed a/c tune-up on a Carrier heat pump system. Checked the electrical, mechanical and performance systems of the unit. Cleared, cleaned, flushed and treated the drain line and cleaned the exterior of the air handler. Secured outdoor compressor wiring and washed the outdoor coil. The drain line is extremely clogged up as it runs under the sink. It is currently draining slowly but I did recommend having a plumber out to prevent future issues. Also found some biological growth at the air handler. The outdoor fan motor has a hot spot. The outdoor control wiring is also exposed and recommend using seal-tight to protect the wiring. Spoke with the homeowners and they chose to have the seal-tight installed. I cycled power once the work was completed and function tested the system. the system is operational at this time.

AC cool check completed on a vertical straight cool system. Drain line was cleared and treated. Outdoor coil was cleaned. All mechanical and electrical components were checked. I found the outdoor torque booster well below manufacturer specifications. I went over my findings with the homeowner and she chose to have the torque booster replaced today. I replaced the torque booster and function tested the system. Everything was running at completion of service.