Kyle TX Heating & Air Conditioning Services

Heating tune-up completed on a vertical all electric air handler. Drain line was flushed and treated. Gasket was installed to prevent filter bypass. All mechanical and electrical components found within manufacturer specifications. The system is heating properly at time of departure.

Performed heat check. Checked the electrical, mechanical, safety, and performance of the system. I cleared the condensation drain line and flow tested the drain with two gallons of water. I also treated the drain line. The air filter was clean and had been recently replaced by the homeowner. No major issues were found. The system was running at the completion of service.

Performed heat check. Checked the electrical, mechanical, safety, and performance of the system. I cleared the condensation drain line and flow tested the drain with two gallons of water. I also treated the drain line. The air filter was clean and had been recently replaced by the homeowner. No major issues were found. The system was running at the completion of service.

Performed heater tune-up on a 2006 Goodman gas furnace system. Checked the electrical, mechanical and performance systems of the unit. Cleared, cleaned, flushed and treated the drain line and cleaned the exterior of the furnace. I did find the static pressure of the system is high. No other issues were found. The system is operational at this time.

Performed heater tune-up on a Carrier gas furnace system. Checked the electrical, mechanical and performance systems of the unit. Cleared, cleaned, flushed and treated the drain line and cleaned the exterior of the furnace. I did find the blower wheel is dirty. I spoke with the homeowner and she chose to have it cleaned. I removed the furnace board and then removed the blower housing from the system. Took the housing and blower wheel apart. Cleaned and washed the blower wheel. Reassembled the housing back together and installed it back at the furnace. Reset power and tested the operation of the system. No other issues were found. The system is operational at this time.

Heat check on horizontal gas furnace completed. Drain line was flushed and treated. Flame sensor was cleaned. All mechanical and electrical components were checked. I did find high static pressure. No other major issues were found. The system is running at completion of service.

Performed heater tune-up on a Goodman 90% gas furnace system. Checked the electrical, mechanical and performance systems of the unit. Cleared, cleaned, flushed and treated the drain line and cleaned the exterior of the furnace. Replaced air filter with a client supplied filter. I did find the water safety switch is located higher than it should. If the drain line backs up it would overflow out of the flue collector box and into the closet. I also found there is high static pressure on the system but due to the location there is no room for improvements. No other issues were found. The system is operational at this time.

Heat check completed on a vertical gas furnace. Flame sensor was cleaned. Drain line was flushed and treated. All mechanical and electrical components were checked. I adjusted gas pressures to spec. I did find the blower motor leaking lubricant accompanied with high in rush on amp draw. No other major issues were found. The system is running at completion of service.

Installed 2 ton Carrier 2 stage R-454B system. Horizontal gas furnace in attic. Installed Ecobee pro thermostat. Installed new disconnect box and high voltage wiring for the condenser. Built and installed new extended supply plenum. Built and installed new return plenum with 20x25 Aprilaire media filter. Installed new secondary drain pan. Rebuilt primary condensation drain, added SS2 and SS3 safety switches. New gas pipe and flue pipe connections for the furnace. Sealed all ductwork connections with mastic/hardcast. Cleared primary drain with CO2 and primed trap with water. Weighed in 12 oz R-454B refrigerant. Tested heating and cooling operation of new system. Everything is working at completion of install.

Performed heater tune-up on a Carrier gas furnace system. Checked the electrical, mechanical and performance systems of the unit. Cleared, cleaned, flushed and treated the drain line and cleaned the exterior of the furnace. I did find the flue pipe was leaking carbon monoxide at the inducer and flue pipe connection. Repair options were presented to the homeowner and he chose to have the flue draft hood connector replaced. I replaced the connector and verified there is no more carbon monoxide spillage from the furnace system. Flue pipe is clean and clear of obstructions. System is now operational.

Heat check completed on a vertical heat pump system. Drain line was flushed and treated. Condensing coils were cleaned. All mechanical and electrical components were checked. I did find excess buildup on the blower wheel. No other issues were found. The system is heating properly at time of departure.

Service diagnostic found that the condenser fan motor had failed. Options for repair were presented to the homeowner and Conley chose to have the condenser fan motor replaced and to sign up for maintenance. I replaced the condenser fan motor and function tested the system. The system was running at the completion of service.

Heat check completed on a vertical heat pump system. Condenser coils were cleaned. Drain line was flushed and treated. No major issues were found. The system is heating properly at time of departure.

Performed AC cool check. Checked the electrical, mechanical, safety, and performance of the system. I cleared the condensation drain line and flow tested the drain with water. I also treated the drain line. The air filter was new and had been replaced by the homeowner before arrival. Surge protectors are operational. No major issues were found. The system was running at the completion of service.

Performed heat check. Checked the electrical, mechanical, safety, and performance of the system. I cleared the condensation drain line and flow tested the drain with water. I also treated the drain line. The air filters were replaced with client supplied filters. No major issues were found. The system was running at the completion of service.