Kyle TX Heating & Air Conditioning Services

Performed heat check. Checked the electrical, mechanical, safety, and performance of the system. I cleared the condensation drain line and flow tested the drain with two gallons of water. I also treated the drain line. The air filter was clean and had been recently replaced by the homeowner. Surge protection on the air handler and condenser unit is operational. Refrigerant charge was within factory specifications. Condenser coil cleaned. No major issues were found. The system was running at the completion of service.

Performed heat check. Checked the electrical, mechanical, safety, and performance of the system. I cleared the condensation drain line and flow tested the drain with two gallons of water. I also treated the drain line. The air filters were replaced with client supplied filters. No major issues were found. The system was running at the completion of service.

After diagnostics of entire system, I found that the primary drain line from the evaporator coil was clogged. I also found low charge on the indoor torque booster. I did check static pressure of system and found it to be abnormally high. I went over repair options with the homeowners and they decided to sign up for our gold membership, have their drain line flushed and treated, and replace the indoor torque booster. I have also scheduled a consultation with our project manager to address static and some airflow issues. I completed the repairs and function tested the system. The system was running at completion of service.

Heat check completed on a horizontal gas system. Both dampers are opening and closing properly. Drain line was flushed and treated. Flame sensor was cleaned. UV lights and surge protection are still operating properly. All other mechanical and electrical components found within manufacturer specifications. The system is operating properly at time of departure.

Heat check completed on one system. Flame sensor was cleaned. Drain line was flushed. All electrical and mechanical components found within manufacturer specifications. The system is operating properly at time of departure.

Performed heater tune-up on a Carrier and a Lennox heat pump system. Checked the electrical, mechanical and performance systems of the units. Cleared, cleaned, flushed and treated the drain lines and washed both outdoor coils. No major issues were found. The systems are operational at this time.

Performed heater tune-up on a Carrier gas furnace system. Checked the electrical, mechanical and performance systems of the unit. Cleared, cleaned, flushed and treated the drain line and cleaned the exterior of the furnace. No major issues were found. The system is operational at this time.

Cut in and installed 2 new return filter grills, one on each side of the closet. Cleaned out the return chase. Cleared primary drain with CO2 and primed with water. Replaced flue pipe cap and rain collar on the outside of the roof. Sealed with silicon. Tested system operation. Everything is working at completion of service.

Installed 2.5 ton Payne R-454B system. Vertical gas furnace. Installed Ecobee lite thermostat. Installed new disconnect box for the condenser and new pad. Installed new plywood for the furnace to sit on. New gas pipe and flue pipe connections. Built and installed new extended supply plenum. Sealed all ductwork connections with mastic/hardcast. Rebuilt primary drain, added secondary safety switch. Found poly pipe drain broken and disconnected underneath the house. Installed all new drain pipe. Pressure tested system with nitrogen and pulled vacuum. Charged AC with R-454B refrigerant. Tested heating and cooling operation. Everything is working at completion of install.

Heat check completed on one horizontal gas system. Drain line was flushed. Flame sensor was cleaned. Batteries changed in all smoke and carbon monoxide detectors. No major issues were found. The system was running at completion of service.

Heat check completed on one horizontal gas system. Drain line was cleared and treated. Flame sensor was cleaned. No major issues were found. The system was working at completion of service.

Heat check completed on one horizontal gas system. Drain line was flushed and treated. Flame sensor was cleaned. I found the total static pressure nearly double what is recommended for the system. I spoke to the homeowner and she said she'd like to take another look at it during her next maintenance visit. No other major issues were found. The system was running at completion of service.

Performed heater tune-up on a Carrier gas furnace system. Checked the electrical, mechanical and performance systems of the unit. Cleared, cleaned, flushed and treated the drain line and cleaned the exterior of the furnace. No other issues were found. System is operational at this time.

Heat check performed on one horizontal gas system. Drain line was flushed and treated. The flame sensor was cleaned. All mechanical and electrical components are within manufacturer specifications. The system is operating properly at time of departure.

Service diagnostic found that the primary drain line was partially clogged. This was tripping the water safety switch intermittently causing the system to shut on and off. I spoke with the homeowner and he chose to have the drain line serviced at this time. I cleared the primary pan. Flushed and cleaned the primary drain and tested it with 2 gallons of water. I then treated the pan and drain line. Function tested the system and it is now operational.