Kyle TX Heating & Air Conditioning Services

Performed AC cool check. Checked the electrical, mechanical, safety, and performance of the system. I cleared the condensation drain line and flow tested the drain with water. I also treated the drain line. The current air filter is slowing down airflow across the evaporator coil. I let the tenant know he will need to change the filter to prevent issues. Condenser coil was cleaned. No major issues were found. The system was running at the completion of service.

Performed A/C tune-up on a Carrier straight cool system. Checked the electrical, mechanical and performance systems of the unit. Cleared, cleaned, flushed and treated the drain line and cleaned the exterior of the furnace. Replaced return air filters and washed the outdoor coil. I found there is no water safety switch on the secondary drain and the outdoor fan motor is showing signs of over heating. No other major issues were found. The system is operational at this time.

Performed A/C tune-up on a Trane straight cool system. Checked the electrical, mechanical and performance systems of the unit. Cleared, cleaned, flushed and treated the drain line and cleaned the exterior of the furnace. Filter was replaced recently and is clean. I did adjust the airflow to help reduce humidity levels in the home and prevent unwanted stress on the blower motor. Verified outdoor compressor wiring is secure and washed the outdoor coil. I did find the system is slightly low refrigerant. No other major issues were found. The system is operational at this time.

Spoke with the homeowner when I arrived and she mentioned that the outdoor unit was running but they were not getting any cold air coming from the vents. I went outside and found that the fan motor was operational but the compressor was not pumping any refrigerant. I tested the run capacitor at the outdoor condenser and found it had failed below value across the HERM terminal. I noted that the capacitor had been replaced before but was connected in conjunction with another fan motor capacitor for the condenser fan motor that has been replaced. I checked and went through the remainder of the system in the walk in attic and verified all other systems were operating within manufacture specifications for operation. I went over repair options with the homeowner and she chose to replace the capacitor. Installed new outdoor run capacitor, installed new wiring terminal connections across all high voltage wiring. Cycled power to the system and verified operation. System was operatin

Installed new supply plenum and sealed with mastic and hard cast. Reattached all duct work with new collars and sealed with mastic. Completed duct sealing from attic with mastic to the drywall. Cleared drain and cleaned drain pan. Cleaned coil in place and cleaned blower wheel and blower housing. Checked system capacitor. Tested system operation and checked temperature split. Everything is working at this time.

Performed an A/C tune-up on a Carrier straight cool system. Checked the electrical, mechanical and performance systems of the unit. Cleared, cleaned, flushed and treated the drain line and cleaned the exterior of the furnace. Replaced high voltage wire nuts with Wago wire connectors. Secured outdoor compressor wiring and washed the outdoor coil. I did find that the Aprilaire 216 filter is causing high static pressure and putting unwanted stress on the blower motor. I recommended using an Aprilaire 210 filter to put less wear and tear on the system. I also found the outdoor fan motor is showing signs of overheating. No other major issues found.

Service diagnostic found that the thermostat had failed. I isolated and bypassed the thermostat to make sure that the equipment was operational. I then confirmed that the thermostat was not passing the 24v signal to run the equipment. Options for repair were presented to the homeowner, and he chose to have the thermostat replaced and to sign up for maintenance. I replaced the thermostat and function tested the system. I then went over the operation of the thermostat with the homeowners. The system was running at the completion of service.

Service diagnostic found that the condensation drain line was clogged. Water was backing up and draining out of the secondary drain line. I also found that the condenser fan motor is showing signs of overheating. Options for repair were presented to the homeowner, and she chose to have the drain line cleared and to sign up for maintenance. I cleared the condensation drain line and flow tested the drain with two gallons of water. I also treated the drain line. The system was running at the completion of service.

Performed an A/C tune-up on two Carrier heat pump systems. Checked the electrical, mechanical and performance systems of the units. Cleared, cleaned, flushed and treated the drain lines and cleaned the exterior of the air handlers. Verified that the compressor wiring is secure and washed both outdoor coils. All filters were replaced recently and are still in clean condition. All UV lights and surge protection devices are working. No major issues were found. Both systems are operational at this time.

On arrival I spoke with the homeowner, and he mentioned that the outside unit stopped running while the indoor unit was still moving air inside. After performing the diagnostic, I found that the primary condensate line was clogged up tripping the emergency water safety switch. I cleaned and cleared the primary drain line and added in a condensate drain treatment. I cycled power to the system and allowed for the unit to run. I checked over operation and verified everything is now working at this time.

Cool check completed on horizontal Carrier heat pump. Drain line was flushed and treated. Condenser coils were cleaned. During maintenance I did find torque booster below manufacture specs. I also found the condenser fan motor showing signs of overheating. Presented options for repair, and the homeowner has chosen to move from the Silver membership to the Gold membership as well as replace torque booster today. Replaced torque booster and tested system.

Cool check completed on a horizontal carrier system. Drain line was cleared and treated. Condensing coils were cleaned. During maintenance I found all electrical and mechanical components within manufacture specs. However, no surge protection found on system. System is cooling at time of departure.

On arrival I spoke with the homeowner, and he mentioned that his outdoor compressor and fan motor was not running but he was getting air moving through the house. I went into the attic and found that the primary condensate line was clogged and had tripped the emergency water safety switch. I spoke with the homeowner, and he just wants to get the drain line repaired today. I flushed and cleared the primary drain line that attaches to the hall bathroom sink. I added in drain treatment as well into the line to help with prior condensate drainage. Cycled high voltage power to system and verified operation. While onsite, I went ahead and cleaned up the attic stairs and return air grille in the hallway as he did mention he had a squirrel in the attic that was going through some insulation and knocking it loose. Everything is working at this time.

Cooling maintenance completed. The drain line has been flushed and treated. The condenser coils have been cleaned. During maintenance of unit, I found no issues with any electrical or mechanical component. The system is cooling properly at time of departure.

Replaced the outdoor fan motor. I then pulled and cleaned the blower wheel housing. After washing the blower wheel and housing I reset power and cycled power at the thermostat. I cleared and treated the drain line at no additional cost as well. System is operational at this time.