Kyle TX Heating & Air Conditioning Services

Installed new evaporator coil in rooftop unit A. New liquid line filter drier installed. Cleaned out the primary drain pan. Pressure tested system with nitrogen and pulled vacuum. Weighed in factory charge of R-410A refrigerant. Tested operation of system. Everything is working at completion of service.

AC cool check completed on eight year old vertical Carrier heat pump. Drain line was flushed, cleared, and treated. Condenser coil was cleaned. I found the contactor on the outdoor unit is worn and pitted. I went over my findings with the homeowner. No other issues were found. The system was cooling at time of departure.

Service diagnostic found that the condensation drain line was clogged. Water had backed up and tripped the safety switch. I also found that the blower wheel and air handle were dirty. Options for repair were presented to the homeowner and he chose to have the drain line cleared and to have the blower wheel and air handler cleaned. I cleared the condensation drain line and flow tested the drain with two gallons of water. I also treated the drain line. I completed the cleanings on the blower wheel and air handler. I then function tested the system. The system was running at the completion of service.

Built and installed new return plenums to make use of 2 media filters. Installed new media cabinet and filter, reused one existing. Built and installed extended supply plenum with elbow. Extended flex duct where needed and attached to new plenum. Sealed all connections with mastic and hardcast. Installed new secondary drain pan along with SS2 and SS3 safety switches. Everything is working at completion of service.

The homeowner told me water was dripping out of the secondary drain from the eve of house. I looked at the problem and presented options to resolve the issue. The homeowner chose to have the drain cleaned, flushed, treated and primed. I completed the repairs. The primary drain line is now flowing freely. The system was running at completion of service.

Performed AC cool check and checked the electrical, safety, and performance of the system. I cleared the condensation drain line and flow tested the drain with water. I also treated the drain line. The air filters were replaced with client supplied filters. Condenser coil was cleaned. No major issues were found. The system was running at the completion of service.

Performed A/C tune-up on a Carrier Infinity heat pump system. Checked the electrical, mechanical and performance systems of the unit. Cleared, cleaned, flushed and treated the drain line. Secured the outdoor compressor wiring and washed the outdoor coil. No issues were found. The system is operational at this time.

AC cooling tune-up completed on horizontal Lennox system. Drain line was flushed, treated, and primed. Condenser coil was cleaned. I found both the indoor and outdoor capacitors were below manufacturer specs. Presented options for repair and the homeowner chose to move forward with replacing both capacitors today. I replaced the capacitors and function tested the system. No other issues were found. The system is cooling properly at time of departure.

Performed AC cool check and checked the electrical, mechanical, safety, and performance of the system. I cleared the condensation drain line and flow tested the drain with two gallons of water. I also treated the drain line. The air filter was replaced with a client supplied filter. Condenser coil was cleaned. System sterilizers are operational. No major issues were found. The system was running at the completion of service.

Installed horizontal Carrier gas furnace. New gas pipe and flue pipe connections for the furnace. Installed 3 ton R-454B Carrier 2 stage condenser and evaporator coil. Installed new disconnect box for the condenser and placed on new leveled pad. Installed new secondary drain pan. Rebuilt primary condensation drain and installed SS2/SS3 safety switches. Built and installed new extended supply plenum. Built and installed new return plenum and return box at the filter grill. Sealed all connections with mastic / hardcast. Installed Ecobee pro thermostat. Cleared primary drain with CO2 and primed trap with water. Charged AC with R-454B refrigerant. Tested heating and cooling operation. Everything is working at this time.

AC cooling check completed on horizontal Carrier zoned system. Both dampers are operating properly. Drain line was flushed, treated, and primed. Condenser coil was cleaned. I found the blower wheel heavily impacted with dirt. No other major issues were found. The system is cooling at time of departure.

Performed AC cool check and checked the electrical, mechanical, safety, and performance of the systems. I cleared the condensation drain lines and flow tested the drains with two gallons of water. I also treated the drain lines. Condenser coils were cleaned. The downstairs system had no major issues. The upstairs system had a dirty blower wheel and air handler. The condenser fan motor on the upstairs system is showing signs of overheating. I spoke to the homeowners about the issues with the upstairs system. Both systems were running at the completion of service.

On arrival, I found that both run capacitors for the upstairs and downstairs system had failed below value. Spoke with the homeowner and we have decided to go ahead and move forward with replacing the capacitors and getting signed up on maintenance for both systems as they are past due on service. Installed the two new capacitors and checked over system. Everything is working at this time.

Upon arrival, the homeowner stated the system had not been working all that well over the last couple days. She said before she changed the batteries on her thermostat, the power would periodically shut off. I went into the attic to check float switch and found the float switch was tripping power to the unit. I continued outside to look over condenser and found the contactor charred and pitted and the capacitor below 50 percent of capacity. Also found the condenser fan motor showing signs of severe overheating and the condenser coil wrapped in dirt and cottonwood. I went over my findings and presented repair options to the homeowner and she decided to move forward with a factory refresh on her system. I completed the factory refresh and cleared, primed, and treated the drain line. I then function tested the system. Everything is working at completion of service.

The unit was off when I arrived. The tenant stated that the indoor unit would blow, but the outdoor unit was not coming on. I checked the float switch and it was dry. I went outside to examine the heat pump and found a bulge in the capacitor. The underside of the evaporator coil is extremely dirty. The condenser fan motor is in poor condition. I went over my findings with the homeowner, he decided to replace the capacitor today. I replaced the capacitor and function tested the system. The system is cooling with an 18° temperature split.