Kyle TX Heating & Air Conditioning Services

AC cool check completed on horizontal three year-old Rheem system. Drain line has been cleared. Condenser coil has been cleaned. All electrical and manufacturer components within specifications. No major issues were found. The system is cooling properly at time of departure.

Performed AC cool check and checked the electrical, mechanical, safety, and performance of the system. I cleared the drain line and flow tested the drain with water. I also treated the drain line. Air filters were replaced with client supplied filters. I cleaned the condenser coil. No major issues were found. The system was running at the completion of service.

Performed A/C tune-up on a Carrier heat pump system. Checked the electrical, mechanical and performance systems of the unit. Cleared, cleaned, flushed and treated the drain line. Cleaned the exterior of the furnace and washed the outdoor coil. I found that the indoor coil is starting to develop some rust spots but is still working. The air purifier and UV light are all working. No major issues were found. The system is operational at this time.

I cleaned the dryer vent from the inside of the house through to the vent on the roof. The brush was observed at the vent on the roof. Hose connection from the dryer to the vent was also cleaned along with the back of the dryer. The area around the dryer was vacuumed and debris was removed. Hose for the dryer was reconnected and the dryer was returned to its place in the washroom.

Performed AC cool check and checked the electrical, mechanical, safety, and performance of the system. I cleared the condensation drain line and flow tested the drain with two gallons of water. I also treated the drain line. Air filters were replaced with client supplied filters. Condenser coil was cleaned. The capacitor for the condenser unit was below value. Options for repair were presented to the homeowners and they chose to have the capacitor replaced. I replaced the capacitor on the condenser unit and function tested the system. No other major issues were found. The system was running at the completion of service.

Performed diagnostic on the system and found that the capacitor at the outdoor condenser unit had failed on the herm side. I also found the outdoor fan motor is showing signs of over heating and recommended having the drain line cleaned out. I spoke with homeowner and he chose to only have the capacitor replaced today. I replaced the outdoor capacitor. I also washed the outdoor coil and secured the compressor wiring at no extra charge. Reset power and verified the system is operational. The system is running at completion of service.

Performed A/C tune-up on a Carrier straight cool system and checked the electrical, mechanical and performance systems of the unit. Cleared, cleaned, flushed and treated the drain line. Cleaned the exterior of the furnace and washed the outdoor coil. I found that the blower wheel was dirty. I spoke with homeowners and they decided to have the blower wheel cleaned and install surge protection at both indoor and outdoor systems. I cleaned the blower wheel and housing and installed the surge protection devices. Reset power and verified the system is operational. No other major issues were found. The system is running at completion of service.

Installed balancing damper in duct going to daughter’s room. Replaced old condensing unit with the new condenser. Redid copper going out of the house into the new unit. Reinsulated the suction line. Ran low voltage in 1/2” seal tite. Installed liquid line filter drier upstairs in the attic. Pressure tested the system and pulled a vacuum on the copper line set. Weighed in additional charge per lineset length. Tested system operation. Everything is working at completion of service.

Installed R-454B straight electric mobile home system. Installed Honeywell T6 thermostat. Made new primary drain and lineset connections. Cleared primary drain with CO2 and tested operation with water. Installed new pad and disconnect for the condenser. Pressure tested system with nitrogen and pulled vacuum. Tested heating and cooling operation. Everything is working at completion of service.

AC cool check completed on vertical Carrier heat pump. Drain line flushed and condenser coil cleaned. All electrical and mechanical are within manufacturer specifications. The condenser fan motor is showing signs of overheating and there is not surge protection on the system. I discussed repair options with the homeowner. No other major issues were found. The system is cooling properly at time of departure.

Removed old air handler & condenser. Installed new furnace and condenser. New condenser pad. New disconnect box/High volt whip. Brazed new lines/pressure tested to 250. New supply and return plenum/collars. Sealed all connections with mastic air lock. New b vents for furnace. Reconnected gas pipe line. Installed new Ecobee thermostat and programmed. Cleared primary drain and water tested. Introduced new R-454B liquid refrigerant. Performance tested the system. Everything is working at completion of service.

AC cooling check completed on horizontal Lennox system. I found the emergency drain pan is not properly situated under the evaporator coil. There is no secondary float switch. There's a slight vibration from the blower motor or wheel. I brought my findings to the homeowner. No other major issues found. The system is running at time of departure.

Installed R-454B Carrier condenser and evaporator coil. Installed new pad disconnect box for the condenser. Installed horizontal Carrier gas furnace with new gas and flue pipe connections. Built and installed new return and supply plenums. Added 12 inch return to get more air going into the system. Sealed all connections with mastic / hardcast. Installed new secondary drain pan. Rebuilt primary condensation drain with new SS2 and SS3 safety switches. Cleared primary drain and primed trap with water. Pressure tested system with nitrogen and pulled vacuum. Tested heating and cooling operation. Everything is working at completion of service

AC cool check completed on two year-old horizontal Carrier system. All mechanical and electrical are within manufacturer specs. I spoke to the homeowners about surge protection. No major issues were found. The system is cooling properly at time of departure.

AC cool check completed on 15 year-old horizontal straight cool system. I discussed the condition of the condenser contactor with the homeowner, but due to the age of the system they decided not to do a repair at this time. No other major issues found. The system is cooling properly at time of departure.