Kyle TX Heating & Air Conditioning Services

Cool check completed on an up-flow heat pump system. No major issues found, and the system is running at manufactures specs.

Upon arrival, the customer stated water leaking issues and the system was turned off. It is an up-flow system on the second floor. During evaluation of the drain lines and evaporator coil I discovered that the most likely culprit causing a clog was the internal drain pan; I vacuumed out quite a bit of sludge. After clearing out both the primary and secondary drains, I dumped multiple gallons of water into the internal drain pan flushing out the remaining sludge. Verified proper drainage after the repair.

Upon arrival, the customer stated that the indoor unit was running but the outdoor unit was not. Went into the attic and replaced the air filter. Continued my inspection and found that the float switch was tripped due to a clogged drain line. With the customer’s approval I cleared the drain line, and cycled the unit on to verify it is now cooling properly.

Cool check completed on a 2-year-old vertical gas system. The system is operating within manufacture specs. The drain line was cleared and treated. No major issues found.

Cool check completed on a vertical gas system. I did find that the condenser fan motor is showing signs of overheating. No other major issues found.

Installed new Carrier gas system. Sealed field transition and rebuilt drain line with SS-2 safety float switch. Installed filter dryer and pressure tested system for extensive leak check. Pulled deep vacuum and verified charge. Replaced outdoor disconnect and installed new Ecobee Lite thermostat. System operating in all modes at this time.

Service diagnostic found that the drain line was clogged. The drain line was piped in such a way that prevents effective maintenance of the drain. Options for repair were presented to the customer, and Julie chose to have the drain line rebuilt and cleared. She also chose to sign up for maintenance. I cleared the drain and rebuilt the drain so that the trap and drain line can be treated. I flow tested the drain line with water. The system was function checked and is cooling at the time of departure.

Replaced outdoor condenser fan motor. Removed furnace out of closet to replace coil. Installed new coil and reconnected copper and drain lines. Reinstalled furnace and sealed transition with mastic tape and air lock. Pressure tested the line-set and pulled deep vacuum. Verified charge and cleared and treated drain line. Everything working at this time.

I arrived at the home to find the system on and running. I spoke to the homeowners about how the unit had been operating. I checked over the system and discovered that the drain line was clogged. I brought this to their attention and made them an option to get it cleared. They agreed. The details of that estimate are below: “Includes clearing and treatment of the drain.” I got the work performed and checked over the rest of the system. I discovered that the contactor is pitted and charred, the capacitor is weak and out of spec, and that the blower motor is leaking oil. I brought this to the attention of Harry and Anne and made the a few options to get these issues rectified. System is working to the best of its ability at this time

I arrived at the home to find the system on and running. I spoke to the homeowners about how the unit had been operating. I checked over the system and discovered that the drain line was clogged. I brought this to their attention and made them an option to get it cleared. They agreed. The details of that estimate are below: “Includes clearing and treatment of the drain.” I got the work performed and checked over the rest of the system. I discovered that the contactor is pitted and charred, the capacitor is weak and out of spec, and that the blower motor is leaking oil. I brought this to the attention of Harry and Anne and made the a few options to get these issues rectified. System is working to the best of its ability at this time

I arrived at the home to find the system on and running. I spoke to the homeowners about how the unit had been operating. I checked over the system and discovered that the drain line was clogged. I brought this to their attention and made them an option to get it cleared. They agreed. The details of that estimate are below: “Includes clearing and treatment of the drain.” I got the work performed and checked over the rest of the system. I discovered that the contactor is pitted and charred, the capacitor is weak and out of spec, and that the blower motor is leaking oil. I brought this to the attention of Harry and Anne and made the a few options to get these issues rectified. System is working to the best of its ability at this time

I arrived at the home to find the system on and running. I spoke to the homeowners about how the unit had been operating. I checked over the system and discovered that the drain line was clogged. I brought this to their attention and made them an option to get it cleared. They agreed. The details of that estimate are below: “Includes clearing and treatment of the drain.” I got the work performed and checked over the rest of the system. I discovered that the contactor is pitted and charred, the capacitor is weak and out of spec, and that the blower motor is leaking oil. I brought this to the attention of Harry and Anne and made the a few options to get these issues rectified. System is working to the best of its ability at this time

I arrived at the home to find the system on and running. I spoke to Baylor about how the unit had been operating. I checked over the system and discovered a pinhole leak on the liquid line coming out of the filter drier. I brought this to the attention of Baylor and made him an option to get it fixed. He elected to move forward with the work. Details of the work performed today are below: “Includes repair of the leak and 1 pound of refrigerant. Also includes additional refrigerant needed for the system (3 pounds).” I got to work and got the leak patched. I pressure tested the system and also pulled a vacuum to sub 500 microns. I performed a decay test and the system passed. I charged the system with up with 4 total pounds of refrigerant. System is in working order at completion of appointment

I arrived at the home to find the system on and running. I spoke to Baylor about how the unit had been operating. I checked over the system and discovered a pinhole leak on the liquid line coming out of the filter drier. I brought this to the attention of Baylor and made him an option to get it fixed. He elected to move forward with the work. Details of the work performed today are below: “Includes repair of the leak and 1 pound of refrigerant. Also includes additional refrigerant needed for the system (3 pounds).” I got to work and got the leak patched. I pressure tested the system and also pulled a vacuum to sub 500 microns. I performed a decay test and the system passed. I charged the system with up with 4 total pounds of refrigerant. System is in working order at completion of appointment

I arrived at the home to find the system on and running. I spoke to Baylor about how the unit had been operating. I checked over the system and discovered a pinhole leak on the liquid line coming out of the filter drier. I brought this to the attention of Baylor and made him an option to get it fixed. He elected to move forward with the work. Details of the work performed today are below: “Includes repair of the leak and 1 pound of refrigerant. Also includes additional refrigerant needed for the system (3 pounds).” I got to work and got the leak patched. I pressure tested the system and also pulled a vacuum to sub 500 microns. I performed a decay test and the system passed. I charged the system with up with 4 total pounds of refrigerant. System is in working order at completion of appointment