Mountain City TX Heating & Air Conditioning Services

Performed heating tune-up on a heat pump system. System is operational.

Performed heating tune-up on American Standard heat pump up flow in hallway. Drain treatment performed and filters changed out recently. Safety features tested and the interior air handler cabinet in clean condition. Outdoor condenser unit washed off and electrical and refrigerant charge in range. System is up and heating.

In the notes on the last visit George indicated that there may be a leak in the evaporator coil, and we need to check it again on our next visit. Refrigerant pressures are where they are supposed to be at this time, and I put my leak detector on the evaporator coil and did not get any hits. Everything is working and we will check again on the next visit.

Preformed heater tune-up on a Carrier heat pump system in attic. Checked electric heat strips and treated condensate drain. Also checked heat rise and motor bearings. Cleaned outdoor condenser coil and checked value on voltage enhancement system. Sprayed JS-685 ant spray around panel opening. System working well at this time.

Performed heating tune-up on a Carrier heat pump up-flow system in hallway. Reme Halo bulb has failed and needs replacement. Emergency heat has been tested and in working order. Drain treatment performed and 20x20x1 filter changed and dated. Refrigerant charge verified and outdoor unit washed off. System is up and heating. Customer has renewed maintenance agreement for another year.

Routine heating maintenance performed on a Carrier gas system. Sequence of operation completed without issue. Safety features have been tested, voltage enhancement system verified, and gas output reading 9.8 in spec. Drain treatment performed and customer has recently changed out 20x25x4 filter. Did find a fault at the thermostat. New thermostat has been installed and tested in all modes. System heating and cooling properly.

When I arrived, I found the system to be very low on refrigerant. I found the leak in the evaporator coil and gave the customer their options. They chose to have it replaced at the silver level on Friday, 10/23/20. Repair will be charged to the customer’s Greensky account.

Adjusted the louver on the mini split head so it would close completely.

Routine heater maintenance on an American standard. Sequence of operation completed without an issue. Drain treatment performed and filters in good condition. All safety features and gas components tested and verified. Outdoor unit refrigerant charge has been recorded per customers feedback of a possible leak, but none found, and condenser washed off. System up and heating.

When I arrived, the customer informed me that the mini split system did not seem like it was blowing the way it normally does and that they thought it had frost on it. When I turned it on and checked the temperature split from return to supply, I had a 22-degree difference. 70.4-48.0. The coil is clean, the filter was cleaned yesterday, and the blower wheel is moving plenty of air across it. Everything is working at this time and I am not sure why it was having issues yesterday. The customer will call if the issues present themselves again.

When I arrived, the customer informed me that the mini split system did not seem like it was blowing the way it normally does and that they thought it had frost on it. When I turned it on and checked the temperature split from return to supply, I had a 22-degree difference. 70.4-48.0. The coil is clean, the filter was cleaned yesterday, and the blower wheel is moving plenty of air across it. Everything is working at this time and I am not sure why it was having issues yesterday. The customer will call if the issues present themselves again.

Conducted cooling check 2020 on an attic installed Green Speed heat pump system. The system is cooling properly at this time.

20x20x4 perfect fit media filter has been replaced. Will contact customer for winter check. System up and cooling.

Perfect Fit replacement cartridge

Conduct cooling check 2020. The system is cooling properly at this time. The filter needs to be replace, but there isn’t one here at this time.

I find a dirty filter inside the air handler. I remove the filter and put a clean one in. Once I change the filter, I check the refrigerant pressures. Everything is working at this time. The evaporator coil is also getting dirty, and it is necessary to change filters every 30 days.

Check both fan motors for damage. Could not find any issue there. Switch the call to perform their maintenance since customer needed 2020 cool check done. During the cool check, I found that the voltage enhancer was reading 35/3.8 of 70/5. Customer chose the Silver option for replacement. Made the repair and finish the cool check. The system is cooling properly at this time.

Outdoor system not coming on due to clog drain. Purge and treat the drain and the system outside came on. Recommend a compressor saver/starter for compressor easy start and longevity. Check amp draws on the outdoor unit, check refrigerant levels and wash the outdoor coil. System working at completion of service.

Outdoor system not coming on due to clog drain. Purge and treat the drain and the system outside came on. Recommend a compressor saver/starter for compressor easy start and longevity. Check amp draws on the outdoor unit, check refrigerant levels and wash the outdoor coil. System working at completion of service.

Outdoor system not coming on due to clog drain. Purge and treat the drain and the system outside came on. Recommend a compressor saver/starter for compressor easy start and longevity. Check amp draws on the outdoor unit, check refrigerant levels and wash the outdoor coil. System working at completion of service.

Outdoor system not coming on due to clog drain. Purge and treat the drain and the system outside came on. Recommend a compressor saver/starter for compressor easy start and longevity. Check amp draws on the outdoor unit, check refrigerant levels and wash the outdoor coil. System working at completion of service.

Conduct cooling check 2020. The system is cooling properly at this time.

Found and replaced a depleted voltage absorber, installed a new compressor saver and added 1lb of R-410A. Performed electrical termination service and tested the system. System working at completion of service.

Found and replaced a depleted voltage absorber, installed a new compressor saver and added 1lb of R-410A. Performed electrical termination service and tested the system. System working at completion of service.

Found and replaced a depleted voltage absorber, installed a new compressor saver and added 1lb of R-410A. Performed electrical termination service and tested the system. System working at completion of service.