Wimberley TX Heating & Air Conditioning Services

Performed cooling maintenance. Checked all electrical, mechanical and performance of the system. Cleared and treated the drain line and washed the outdoor coil. I found that the knockouts on the furnace where the low voltage goes in were not sealed and the system was pulling in attic air into the home. I sealed the knockout holes and also changed the high voltage wire nuts to a bigger size. I reset the breaker and confirmed the system is operational at this time. No other major issues were found.

Performed diagnostic on the master bedroom system for the home on the right side of the gate. I found that the outdoor condenser capacitor has failed on the herm side. I also found that the 4-inch media filter for the system is the incorrect size and there is air that is not being filtered going into the home. Also, the liquid line is not sealed in the attic, so the system is pulling attic air into the home. I presented my findings to the homeowner, and he chose to have the capacitor and filter replaced at this time. I replaced both the capacitor and filter and cycled power at the thermostat. I also sealed the liquid line with cork tape to prevent any more attic air from going into the system. No other major issues were found. Both systems are operational at this time.

Performed cooling maintenance on a straight cool system. Checked all electrical, mechanical and performance of the system. I cleared and treated the drain line and washed the outdoor coil. Customer supplied a filter for replacement. No major issues were found, and the system is operational at this time.

Performed cooling maintenance on one heat pump system. Checked all electrical mechanical and performance of the system. Cleared and treated the drain line and washed the outdoor coil. I did find that the outdoor condenser fan motor is showing signs of overheating. No other major issues were found, and the system is operational at this time.

Replaced the indoor TXV. Replaced the in-line filter dryer, pressure tested with dry nitrogen, and pulled a vacuum on the copper line set. Charged system to factory spec. Cleared and treated the condensate drain, and checked operation of the system

Air purifier was installed in the system above the master bedroom. The system was function checked and was running at the time of departure.

I pulled and cleaned the blower wheels on both systems. Both systems were function checked and were running at the time of departure.

Removed the old condensate drain line. Used new PVC and insulation to run to the existing penetration but with better slope than what was previously there. Supported the drain line and checked operation. Treated the drain line with Viper drain treatment. Checked over the system and it is working properly at this time.

Performed cooling maintenance on two heat pump systems. Checked all electrical, mechanical and performance of both systems. Cleared and treated the drain lines and washed both outdoor coils. I found that the air purifier for the master bedroom system is no longer working. I informed the customer, and she asked me to send over an estimate for the replacement of the air purifier. No other major issues were found. Both systems are operational at this time.

Performed cooling maintenance on two straight cool systems. Checked all electrical, mechanical and performance of both systems. Cleared and treated the drain lines and washed both outdoor coils. Customer supplied filters for replacement. The customer stated that she felt the upstairs and her master bedroom were more humid than the rest of the house. Her thermostat was on a schedule for blower fan to turn on for 15 minutes every hour. I removed the fan schedule and set it to auto. I also set her thermostat to overcool by 2 degrees to decrease humidity levels. I informed her of the changes I made and asked her to give us a call if the problem continues. Refrigerant levels on both systems are good. No major issues were found. Both systems are operational at this time.

Performed cooling maintenance on two systems. Checked electrical, mechanical and performance of the systems. Cleared and treated both drain lines and washed both outdoor coils. I found that the system on the main house has a dirty blower wheel, and the starter at the condenser is burnt and pitted. I also found that the condenser fan motor for the guest house system is leaking lubricant. No other major issues were found. Both systems are operational at this time.

Performed cooling maintenance on one straight cool system. Checked all electrical, mechanical and performance of the system. Cleared and treated the drain line and washed the outdoor coil. I found that the primary drain line is not at a steady downward slope. The customer informed me that during summer when the system runs constantly, it does clog up frequently. No other major issues were found.

Performed cooling maintenance on the upstairs system. Checked electrical, mechanical and performance of the system. Cleared and treated the drain line and washed the outdoor coil. No other major issues were found. System is operational at this time.

Performed cooling maintenance on one heat pump system. Checked the electrical, mechanical and performance of the system. Cleared and treated the drain line and washed the outdoor coil. While performing maintenance, I found that the system to be low on refrigerant. I performed a leak check and found a leak at the evaporator coil. I also found that the outdoor condenser fan motor is leaking grease. I presented repair options to the customer, and they chose to have refrigerant added at this time. I added refrigerant to get the system back to manufacture’s specifications. No other major issues were found system.

Performed AC cool check on two systems. Both systems have spots of mold/mildew in the air handlers. I wiped down the spots to clean what mold I could see but without disassembling and cleaning, I am not able to get it all. Both blower wheels are also dirty. Drain lines were cleared and treated. Condenser fan motors are in good condition. Condenser coils clean. Condenser capacitors are within value. Both systems are running at 10 degrees of sub cooling. Batteries for the Honeywell thermostat were replaced. Carrier thermostat was set to have the backlight off when not in use. No other major issues found. See attached checklists for full tune-up details. Options to clean the blower wheels were presented to Mariana but she declined the repairs at this time. Both systems were running at the time of departure.

Performed cooling maintenance on two heat pump systems. Checked all electrical, mechanical and performance of the systems. Filters are clean. I cleared and treated both drain lines and washed both outdoor coils. I did find that the outdoor condenser fan motor on the east side of the house is showing signs of overheating. I informed the customer, but she declined repairs at this time. No other major issues were found. All surge protectors and UV lights are working. Both systems are operational at this time.

Performed cooling maintenance on one heat pump system. Checked all electrical, mechanical and performance of the system. Cleared and treated the drain line and washed the outdoor coil. The outdoor temperature is 53 degrees, so I ran the system in heating mode to check refrigerant levels. No major issues were found, and the system is operational at this time. See attached checklist for full tune-up details.

HVAC Repairs: Called out to a client’s home to investigate HVAC system temperature irregularities. Resolved temperature discrepancies by calibrating the thermostat. Ensured accurate temperature readings for improved comfort and energy efficiency.

Performed heating maintenance on one heat pump system. Checked all electrical, mechanical and performance of the system. Cleared and treated the drain line and washed the outdoor coil. Customer provided an Aprilaire 210 media filter for replacement. No major issues were found, and the system is running at this time. See attached checklist for full tune-up details.

Ductwork Repair: In response to uneven heating in a client's home, our HVAC inspection revealed loose and damaged duct connections. Our expert team meticulously repaired the ductwork, ensuring a proper seal that improved airflow and resolved temperature inconsistencies. The client now experiences even and consistent heating, with our recommendation for periodic duct inspections to maintain efficiency.