Wimberley TX Heating & Air Conditioning Services

Performed the heater tune-up on one straight electric heating system and four mini split systems. Checked the electrical, mechanical and performance systems of the units. Cleared, cleaned and treated the drain lines and washed all outdoor units. Washed all mini split filters and replaced the one-inch filter for the Red Fox cabin. I did find that all 4 mini split systems have dirty blower wheels. No other major issues were found. All systems are operational at this time.

Heat check completed on a horizontal heat pump unit. I found that the condenser fan is showing signs of overheating. No other major issues found.

Two system heat check completed: the downstairs unit is a horizontal heat pump system, and the upstairs is a vertical all electric heat system. Upstairs unit - I found that the relay to the heat strips is faulty. Downstairs unit - I found rust buildup on the emergency drain pan. No other major issues found.

Heat checked completed on a horizontal heat pump system. I found that the condenser fan motor is slightly off-center due to hail damage earlier last year. It is causing vibration of heat pump resulting in motor working harder than it should. No other major issues found.

I performed the heater tune-up on a Carrier heat pump system. Checked the electrical, mechanical and performance systems of the unit. Cleared, cleaned, flushed and treated the drain line and cleaned the exterior of the air handler. I washed the outdoor coil and verified the compressor wiring is secure. As I reset the breaker disconnect, I found the breaker had failed and was not passing power. I spoke with homeowner, and she chose to have the disconnect box replaced. After replacing it I cycled power at the thermostat and the system is now operational. No other major issues found.

I performed the heater tune-up on a Bryant heat pump system. Checked the electrical, mechanical and performance systems of the unit. Cleared, cleaned, flushed and treated the drain line. I washed the outdoor coil and secured the compressor wiring to prevent any rub outs. I did find the p-trap was not installed properly.

Performed the heater tune-up on a Carrier heat pump system. Checked the electrical, mechanical and performance systems of the unit. Cleared, cleaned, flushed and treated the drain line and cleaned the exterior of the air handler. I insulated an area of the suction line that was exposed to prevent the line from sweating in the summer and causing rust spots on the secondary pan. I also washed the outdoor coil and changed the defrost timer to 60 minutes to prevent the system from freezing over. No other major issues were found. All surge protection devices are working. The system is operational at this time.

Performed heat check. Checked electrical, mechanical, safety, and performance of the system. I cleared the drain line and flow tested the drain with two gallons of water. I also treated the drain line. The filter was replaced with a customer supplied filter. No major issues were found, and the system is running at the completion of service.

Performed heat checks on three systems. Checked electrical, mechanical, safety, and performance of the systems. I cleared the drain lines and flow tested the drains with two gallons of water. I also treated the drains. The filters on the systems are new and still in clean condition. No major issues were found, and the systems are running at the completion of service.

Performed the heater tune-up. Checked electrical, mechanical, safety, and performance of the system. The drain line is piped without an access port so I installed a threaded connection so that it can be cleared effectively. I then cleared the drain, and flow tested the drain with two gallons of water. I also treated the drain line. No other major issues found, and the system is running at the completion of service.

Performed heat check. Checked electrical, mechanical, safety, and performance of the system. I cleared the drain line and flow tested the drain with two gallons of water. I also treated the drain. No major issues were found.

Performed the heater tune-up on a Carrier heat pump system. Checked the electrical, mechanical and performance systems of the unit. Cleared, cleaned, flushed and treated the drain line and cleaned the exterior of the air handler. Washed the outdoor condenser coil and verified the compressor wiring is secure. No major issues were found, and the system is operational at this time.

Disassembled and cleaned ductless system. Disassembled indoor head, removed pan, blower wheel and casing. Cleaned coil in place and reassembled. Removed all body panels from the condenser and cleaned thoroughly. Cleaned coil in place. Ensured system is draining and fully operational.

Performed heater tune-up on a one-year-old two-stage Carrier system. All UV lights are operational. No major issues found at this time.

Heating tune-up completed on a horizontal heat pump system. No major issues found at this time.

Performed a heater tune-up on four Carrier heat pump systems. Checked the electrical, mechanical and performance systems of the units. Cleared, cleaned, flushed and treated the drain lines and cleaned the exterior of all air handlers. I did find some microbial growth on the system and wiped it off as best as I could. All return air filters are clean since the customer had just replaced them a week ago. I also washed all four outdoor units and secured the compressor wiring on all systems. No major issues were found, and all systems are working at this time.

Performed semiannual maintenance on one heat pump heating system. Inspected all Performance, Mechanical and safety systems. Verified everything was operating within manufacture specifications for operation. Everything is working at this time.

Performed a heater tune-up on a Carrier heat pump system. Checked the electrical, mechanical and performance systems of the unit. Replaced the return air filter with a customer supplied filter and taped it to prevent any bypass. Cleared, cleaned, flushed and treated the drain line and cleaned the exterior of the air handler. I washed the outdoor unit and secured the compressor wiring. No major issues were found, and the system is operational at this time.

Performed semiannual maintenance on two heat pump heating systems. Inspected all Performance, Mechanical and Safety systems. Tested and verified everything was operating within manufacture specifications for operation. Everything is working at this time.

Performed a heater tune-up on an American Standard heat pump system. Checked the electrical, mechanical and performance systems of the unit. Cleared, cleaned, flushed and treated the drain line and cleaned the exterior of the air handler. I found some microbial growth inside the air handler and wiped it as best as I could. I then washed the outdoor unit and cycled power at the thermostat. No other major issues found.