HVAC Service In Buda, TX

Performed semiannual maintenance on two heat pump heating systems and one liquid propane gas system. Inspected all Performance, Mechanical and Safety systems. Changed out homeowner provided filters. Cleaned and cleared the primary condensate lines. Tested and verified all mechanical components were operating within manufactures specifications for operation. Everything is working at this time.

Completed installation of a new Carrier ductless system in the homeowner’s garage. Mounted the outdoor unit on the wall outside 6 feet from the gas meter. Routed line set inside of line hide with electrical and condensation drain. Created new flare connections. Pressure tested with nitrogen and pulled vacuum. Installed 15-amp breaker. Ran drain line away from foundation. Tested system and drain for proper operation. All is working at this time.

Installed a 4-ton Carrier heat pump system. Installed Ecobee Pro thermostat. Installed new secondary drain pan. Ran new low voltage wire to the thermostat and to the outdoor heat pump. Installed new supply and return plenums. Sealed all connections with mastic. Rebuilt and insulated primary drain line. Cleared the primary drain that ties in with the bathroom sink and ensured water drained properly. Installed SS2 and SS3 safety float switches. Replaced the disconnect and whip at the outdoor heat pump. Ran low voltage in 1/2” Seal-Tite. Pressure tested line set with nitrogen and pulled a vacuum. Weighed in additional refrigerant to meet manufacturer specifications.

Performed the heater tune-up on a Carrier heat pump system. Checked the electrical, mechanical and performance systems of the unit. I did find some biological growth in the primary pan and cleaned it out as best as I could. I then cleared, cleaned, flushed and treated the drain line and cleaned the exterior of the air handler. I replaced the filters with ones that the homeowner provided and sealed them with tape to prevent any filter bypass. No other major issues were found, and the system is operational at this time.

Performed heater tune-up. Checked electrical, mechanical, safety, and performance of the system. I cleared the drain line and flow tested the system with two gallons of water. I also treated the drain line. No major issues were found, and the system is running at the completion of service.

Performed the heater tune-ups on two Carrier heat pump systems. Checked the electrical, mechanical and performance systems of the units. Cleared, cleaned, flushed and treated the drain lines and cleaned the exterior of the air handlers. I did find on the upstairs condenser system that the compressor wires were starting to rub out on the copper lines. I secured the wiring to prevent any rub outs in the future. I also found that some of the supply ducts for the upstairs system are not sealed and there is some air leaking into the attic. No other major issues were found, and both systems are operational at this time.

Performed heater tune-up. Checked electrical, mechanical, safety, and performance of the system. I cleared the drain line and flow tested the drain with two gallons of water. I also treated the drain line. No major issues were found, and the system is running at the completion of service.

Performed semiannual maintenance on one gas heating system. Inspected all Performance, Mechanical and Safety systems. Checked fuel pressures to ensure 100% heating capacity of the furnace. Tested both zone dampers to ensure they were opening and closed properly. I checked over the ducting of the system. A new supply plenum, dampers and ducts were sealed earlier in the year. I tested static pressure of the system and was achieving a .50inWC, matching the furnace rating per the manufacturer data tag. Everything is working at this time.

HVAC Repair – During a service call for a commercial HVAC unit producing inconsistent temperatures, I discovered that the air filter was heavily clogged, restricting airflow. I replaced the filter and cleaned the surrounding ducts, which significantly improved the system's efficiency and restored proper temperature control throughout the building.

Air Conditioning System Repair – A homeowner called about their air conditioner, which had frequent power surges. Upon investigation, I traced the problem to a damaged capacitor that was causing erratic power fluctuations. I replaced the capacitor and retested the unit to ensure smooth, consistent operation, resolving the issue for the homeowner.

Heating Repair Service – A commercial client reported uneven heating in different sections of their facility. My investigation revealed that an air distribution damper had become stuck, impeding airflow. I adjusted and recalibrated the damper system to ensure balanced heating throughout the space. This adjustment resolved the issue and restored consistent warmth.

Autumntime HVAC Maintenance Service – As part of our autumn HVAC maintenance, I performed a comprehensive inspection of the heating system's ductwork and cleaned out accumulated dust and debris to improve airflow. I also tested the blower motor and ensured the dampers were set correctly to optimize performance. These steps helped ensure the system would operate efficiently and reliably during the cooler months ahead.

Performed the heater tune-up on two Carrier gas systems. Checked electrical, mechanical and performance systems of the unit. Cleared, cleaned, flushed and treated both drain lines and cleaned the exterior of the furnaces. I replaced the high voltage wire nuts with a Wago wire connector on both systems. Upstairs System: I found that the blower motor capacitor is below value and the blower wheel is dirty. Downstairs System: I found that the blower motor capacitor is below value, the blower wheel is dirty, and the system has high static pressure of .75. The high static pressure is more than likely due to an undersized return plenum. No other major issues found.

Performed semiannual maintenance on two gas heating systems. Inspected all Performance, Mechanical and Safety Systems. Verified everything was operating within manufacture specifications for operation. Everything is working at this time.

Performed semiannual maintenance on one gas heating system. Inspected all Performance, Mechanical and Safety Systems. I did find that the hot surface igniter has failed. It was receiving 120volt power but was never firing up. Installed a new OEM HSI from Trane. Tested system and ran a combustion analysis on the furnace. Verified everything was operating within manufactures specifications for operation.

Performed a heater tune-up on a Carrier gas system. Checked electrical, mechanical and performance systems of the unit. I did find the drain runs into the master bedroom sink which was clogged. I cleared, cleaned, flushed and treated the drain line and cleaned the exterior of the furnace. After clearing the drain, we found that the sink is now draining properly now. I also replaced the high voltage wire nuts with a Wago wire connector. No other major issues were found, and the system is operational at this time.

Performed semiannual maintenance on one gas heating system. Inspected all Performance, Mechanical and Safety systems. Everything is working at this time.

Performed a heater tune-up on a Carrier gas system. Checked the electrical, mechanical and performance systems of the unit. Cleared, cleaned, flushed and treated the drain line and cleaned the exterior of the furnace. I replaced the high voltage wire nuts with a Wago wire connector. No other major issues were found, and the system is operational at this time.

Performed semiannual maintenance on one gas heating system. Inspected all Performance, Mechanical and Safety systems. Tested and verified that everything was operating within manufactures specifications for operation. No other major issues found.

Removed the old return plenum and the old media filter. Then custom-built new plenums and installed two new media filters. Removed the two 14” flex returns and upsize them to a 16” to the furthest return and an 18” to the closest to the system. Sealed all the connections with mastic to prevent heat gain from attic air. Cleared, flushed, and treated the drain line. Checked operation of the system and it is working properly at this time.