HVAC Service In Buda, TX

Performed semiannual maintenance on one heat pump cooling system. Inspected all Performance, Mechanical and Safety Systems. I did note that the indoor fan coil is beginning to corrode. I checked refrigerant levels and was able to verify that the charge is within specifications for operation. Cleaned out the indoor drainage pan and flushed and treated the drain system. Homeowners changed out the indoor 24x24x1 filter prior to our arrival. Verified everything was operating within manufacture’s specifications for operation. Everything is working at this time. See attached checklist for full tune-up details.

Replaced the indoor evaporator coil. Replaced the in-line filter dryer, pressure tested with dry nitrogen and pulled a vacuum on the copper line set. Rebuilt the condensation drain line and added an SS2 safety switch. Cleared the drain line and treated it. Charged the system to factory specs and checked operation of the system. The system is working at this time.

Pumped down remaining refrigerant. Disconnected coil and case and replaced with new coil and case. Removed filter dryer from outside and placed new filter dryer inside near the coil. Sealed coil box with sticky tape, mastic, and hardcast. Rebuilt and insulated drain line. Cleared drain lines. Charged system with refrigerant. Conducted cool check and fastened connections.

Performed cooling maintenance on an R-22 heat pump system. Checked all electrical, mechanical and performance of the system. Cleared and treated the drain line and washed the outdoor coil. I found some microbial growth on the blower wheel and also found that the starter at the condenser is pitted at the contacts. I presented my findings to the customer, and he chose to have the starter replaced today. I replaced the starter and cycled power at the thermostat. No other major issues were found. System is operational at this time. See attached checklist for full tune-up details.

We arrived at the home to find the upstairs system running inside but not running outside. We went into diagnostics over the system and discovered the following: the condenser fan motor is seized, the capacitor is weak and out of spec, and the contactor has pitting and charring. We replaced the condenser fan motor, contactor, and capacitor. We also installed refrigerant locking caps at no additional charge. System is in working order at completion of appointment.

We arrived at the home to find the upstairs system running inside but not running outside. We went into diagnostics over the system and discovered the following: the condenser fan motor is seized, the capacitor is weak and out of spec, and the contactor has pitting and charring. We replaced the condenser fan motor, contactor, and capacitor. We also installed refrigerant locking caps at no additional charge. System is in working order at completion of appointment.

We arrived at the home to find the upstairs system running inside but not running outside. We went into diagnostics over the system and discovered the following: the condenser fan motor is seized, the capacitor is weak and out of spec, and the contactor has pitting and charring. We replaced the condenser fan motor, contactor, and capacitor. We also installed refrigerant locking caps at no additional charge. System is in working order at completion of appointment.

We arrived at the home to find the upstairs system running inside but not running outside. We went into diagnostics over the system and discovered the following: the condenser fan motor is seized, the capacitor is weak and out of spec, and the contactor has pitting and charring. We replaced the condenser fan motor, contactor, and capacitor. We also installed refrigerant locking caps at no additional charge. System is in working order at completion of appointment.

AC Unit Replacement: In response to a homeowner's request for a more advanced cooling system, I replaced their outdated American Standard AC unit with a state-of-the-art Rheem central AC unit. This upgrade guarantees improved performance and energy savings.

HVAC Repairs: I arrived to perform repairs on their client’s AC system. Corrected electrical issues causing the AC unit to intermittently shut off. Adjusted and tightened electrical contact points to ensure consistent operation.

AC System Repairs: arrived to investigate the cause of cooling problems in a client’s AC unit. Improved cooling efficiency by cleaning a clogged evaporator coil. Enhances heat absorption and promotes better heat exchange within the AC system.

Heat Pump Repair: Addressing a heat pump with insufficient heating, I inspected and repaired a leak in the refrigerant line. This comprehensive repair restored the heat pump's optimal heating performance.

Performed AC cool check. Checked electrical, mechanical, safety, and performance of the system. Filter was dirty and I replaced it with a customer supplied filter. Drain line was cleared and treated. Return plenum and blower wheel are clean. Condenser capacitor is within value. Condenser fan motor is in good condition. No major issues were found and the system was running at the time of departure. See attached checklist for full tune-up details.

Installed Carrier heat pump system. Installed Ecobee Pro thermostat. Installed new supply and return plenums and sealed with mastic. Replaced secondary drain pan. Rebuilt and insulated condensate drain line. Installed SS2 and SS3 safety float switches. Cleared and treated drain. Pressure tested and pulled a vacuum on the copper line set. Replaced disconnect and whip at outdoor unit. Verified system operation, and verified system charge was at manufacturer specifications.

Upstairs HVAC System: On arrival I found that when the thermostat would turn to cool mode, the system would reset power. I went outside and found that the start relay coil was shorted out and the run capacitor had failed below value. Installed new starter relay and new run capacitor. Tested system and verified operation.

Duct Air Purifier Installation: Responding to a client's quest for enhanced indoor air quality, we expertly installed a state-of-the-art duct air purifier. Strategically positioned within the HVAC system, this cutting-edge purifier effectively eliminates airborne contaminants and allergens, ensuring the homeowner breathes cleaner and healthier air. Our meticulous installation guarantees improved air quality throughout the residence.

Ductless Heat Pump Installation: Answering a client's request for efficient heating and cooling, we provided a comprehensive ductless heat pump installation. This included the installation of the heat pump and zoning control, allowing for customized temperature control in different zones. The result is enhanced comfort and energy savings, providing the client with a tailored and efficient heating and cooling solution.

Performed semiannual maintenance on one comfort cooling system. Inspected all Performance, Mechanical and Safety Systems. Washed the outdoor condenser and removed all debris and leaves from base of unit. Changed two homeowner supplied air filters and reset filter reminder on user interface. Verified everything was operating within manufacture’s specifications for operation. Everything is working at this time. See attached checklist for full tune-up details.

I installed one UV light going perpendicular across the top of the A-coil. I installed the other light inside the A-coil. I then installed the power pack and the surge protector on the main circuit of the air handler. I then replaced the blower motor. I tested everything and cycled the system. The blower motor now turns off properly. The UV lights and surge protector are working properly. System is in working order at completion of appointment.

I installed one UV light going perpendicular across the top of the A-coil. I installed the other light inside the A-coil. I then installed the power pack and the surge protector on the main circuit of the air handler. I then replaced the blower motor. I tested everything and cycled the system. The blower motor now turns off properly. The UV lights and surge protector are working properly. System is in working order at completion of appointment.