HVAC Service In Buda, TX

I performed an evaluation over the heating side of the system and discovered the following: the condenser fan motor is leaking oil and the defrost control board isn’t cutting the fan off in defrost properly. The homeowner elected to replace both parts. I collected for the work and left to get the materials. Upon my return I got straight to work. I replaced the condenser fan motor and also replaced the defrost control board. I tested defrost and it’s now working correctly. System is in working order at completion of appointment.

I performed an evaluation over the heating side of the system and discovered the following: the condenser fan motor is leaking oil and the defrost control board isn’t cutting the fan off in defrost properly. The homeowner elected to replace both parts. I collected for the work and left to get the materials. Upon my return I got straight to work. I replaced the condenser fan motor and also replaced the defrost control board. I tested defrost and it’s now working correctly. System is in working order at completion of appointment.

I performed an evaluation over the heating side of the system and discovered the following: the condenser fan motor is leaking oil and the defrost control board isn’t cutting the fan off in defrost properly. The homeowner elected to replace both parts. I collected for the work and left to get the materials. Upon my return I got straight to work. I replaced the condenser fan motor and also replaced the defrost control board. I tested defrost and it’s now working correctly. System is in working order at completion of appointment.

Performed heating maintenance on one heat pump system. Checked all electrical, mechanical and performance of the system. Cleared and treated the drain line and washed the outdoor coil. I found the outdoor capacitor is under value, the underside of the indoor evaporator coil is covered in microbial growth, and the mini split is also covered in growth. I recommended the customer have both systems cleaned and have the outdoor capacitor replaced. The customer chose to have the capacitor replaced today and asked me to send an estimate for the pull and clean of the evaporator coil and mini split cleaning. I replaced the capacitor and cycled power at the thermostat. No other major issues were found. System is on at this time. See attached checklist for full tune-up details.

Performed heat check on an American Standard heat pump. Checked electrical, mechanical, safety, and performance of the system. Drain line was cleared and flow tested with water. Air purifier is operational. Return and supply ducts are clean. Air handler and blower are also clean. Auxiliary heat strips are operational. Condenser capacitor is at factory value. Condenser coil was cleaned. No major issues were found and the system was running at the time of departure. See attached checklist for full tune-up details.

Performed heat check on a Carrier heat pump. During the inspection I found that the system was flat/has no refrigerant. I performed a leak check by flowing nitrogen through the system and found a leak in the evaporator coil. Replaced Evaporator coil. Rebuilt secondary drain and replaced existing safety switch with an ss2. Replaced liquid line filter drier. Pressure tested with nitrogen and pulled a vacuum on the lineset. Weighed in the charge and verified system operation. Cleared the condensate drain line as well.. Everything is operational at this time.

Performed heat check on a Daikin heat pump system. Checked electrical, mechanical, safety, and performance of the system. Drain line was cleared and flow tested with water. Drain line was treated. Filter is dirty and the customer stated that he will pick up a new filter later today. Air handler and blower wheel are clean. Auxiliary heating is operational. System sterilizers and air purifier are also both operational. Condenser coil clean and capacitor on the condenser unit was within value. Condenser fan motor in good condition. System is operating normally and no other major issues were found. See attached checklist for full tune-up details.

Performed semiannual maintenance on one gas furnace heating system. Inspected all Performance, Mechanical and Safety Systems. Verified everything was operating within manufacture’s specifications for operation. Everything is working at this time. See attached checklist for full tune-up details.

Performed semiannual maintenance on one heat pump heating system. Inspected all Performance, Mechanical and Safety Systems. Mr. Prater mentioned he noticed a “burning” smell when the heater came on the other day. I informed him that the indoor heating elements were burning off the dust that had accumulated on them over the summer. Verified everything was operating within manufacture’s specifications for operation. Everything is working at this time.

Performed heat check. Checked electrical, mechanical, safety, and performance of the system. Both heat strips activated. The filter was clean as it was changed by homeowner before arrival. UV lights on indoor system are still operating. Outside condenser refrigerant pressures within range and condenser was clean. Capacitor within value. No major issues were found, and the system was operational at the time of departure.

Performed heat check. Checked electrical, mechanical, safety, and performance of the system. Both heat strips activated. The filters were dirty and they were replaced with customer supplied filters at today’s visit. During my inspection of indoor system, I noticed the blower is dirty from buildup. Brought this to the homeowner’s attention and she declined the blower cleaning. During my inspection of the outside condenser, the homeowner mentioned to me that the unit had been making a loud noise upon start up. After fully inspecting the system, I found everything to be operating as normal. Capacitor values are within range and so are refrigerant pressures. The condenser is also clean. No other major issues were found and the system was running at time of departure. See attached checklist for full tune-up details.

I arrived to find the thermostat blank and the system not working. I went into diagnostics over the system and discovered that the thermostat had failed. We had 24v at the thermostat, but nothing was coming up on the display. I jumped R to G to make sure that it wasn’t an issue with the R wire and was able to confirm that it was indeed the thermostat. I provided the homeowner with a few solutions. He elected to have the thermostat replaced with an Ecobee. I collected for the work and replaced the thermostat. We got everything hooked up and I tested the system in all modes. System is in working order at completion of appointment.

I arrived to find the thermostat blank and the system not working. I went into diagnostics over the system and discovered that the thermostat had failed. We had 24v at the thermostat, but nothing was coming up on the display. I jumped R to G to make sure that it wasn’t an issue with the R wire and was able to confirm that it was indeed the thermostat. I provided the homeowner with a few solutions. He elected to have the thermostat replaced with an Ecobee. I collected for the work and replaced the thermostat. We got everything hooked up and I tested the system in all modes. System is in working order at completion of appointment.

I arrived to find the thermostat blank and the system not working. I went into diagnostics over the system and discovered that the thermostat had failed. We had 24v at the thermostat, but nothing was coming up on the display. I jumped R to G to make sure that it wasn’t an issue with the R wire and was able to confirm that it was indeed the thermostat. I provided the homeowner with a few solutions. He elected to have the thermostat replaced with an Ecobee. I collected for the work and replaced the thermostat. We got everything hooked up and I tested the system in all modes. System is in working order at completion of appointment.

I arrived to find the thermostat blank and the system not working. I went into diagnostics over the system and discovered that the thermostat had failed. We had 24v at the thermostat, but nothing was coming up on the display. I jumped R to G to make sure that it wasn’t an issue with the R wire and was able to confirm that it was indeed the thermostat. I provided the homeowner with a few solutions. He elected to have the thermostat replaced with an Ecobee. I collected for the work and replaced the thermostat. We got everything hooked up and I tested the system in all modes. System is in working order at completion of appointment.

Performed heating maintenance on one heat pump system. Checked all electrical, mechanical and performance of the system. Cleared and treated the drain line and washed the outdoor coil. No other major issues were found and the system is on at this time. See attached checklist for full tune-up details.

Furnace Maintenance: In a proactive effort to ensure optimal performance, I conducted a thorough maintenance check on a residential client's furnace. This included replacing the air filter, cleaning the burners, and inspecting the heat exchanger. Additionally, I performed a carbon monoxide test to guarantee the safety of the heating system. This comprehensive maintenance regimen aims to maximize efficiency, enhance safety, and extend the lifespan of the furnace, providing the homeowner with reliable and efficient heating.

AC System Repair: In response to irregular operation in an AC unit caused by a faulty contactor, we replaced the component after a careful inspection. The new contactor was installed, and rigorous testing confirmed seamless functionality. This meticulous replacement guarantees reliable and uninterrupted AC operation, providing a consistent and comfortable indoor climate with optimized system efficiency. The client can now enjoy enhanced cooling performance and comfort.

Furnace Repair: Responding to a furnace issue, our inspection revealed a faulty ignition transformer. Swiftly replacing it with a new, reliable unit ensured consistent ignition and guaranteed the furnace's reliable and efficient operation. This precise replacement restored warmth and comfort to the client's home.

Performed heat check on a Carrier heat pump. Checked electrical, mechanical, safety, and performance of the system. Drain line was cleared and treated. Duct work is new and in excellent condition. Auxiliary heat is operational, and all the strips were running. Air handler and blower wheel are clean. The condenser has a new fan motor. Capacitor is in value. Condenser coil is cleaned. Surge protection for the air handler and condenser are also operational. No major issues with the system were found and the system was running at the time of departure. See attached checklist for full tune-up details.