HVAC Service In Buda, TX

Performed service diagnostic. Diagnostic found that the contactor on the condenser unit, the circuit breaker for the condenser and the surge protector for the condenser have all failed. Options for repair were presented to the customer and they chose to have all three repairs completed. Contactor, breaker and surge protector were replaced. System was function checked and is running upon completion of repairs.

Performed the AC tune-up. I did inform the homeowner that his capacitor is just below the allotted 5%.

Performed the AC tune-up and no major issues were found.

Performed an AC tune-up and no major issues were found. System was working at completion of job.

Performed semiannual maintenance on one cooling system. Inspected all Performance, Mechanical and Safety Systems. Verified everything was operating within manufacture’s specifications for operation. Everything is working at this time.

Installed new indoor metering device. Pulled deep vacuum on system and recharged system with R-410A refrigerant. Adjusted metering device per manufacture’s specifications. Everything is working at this time. Informed homeowner system would be running for a while to remove all heat and humidity from the home and bring down to setpoint temperature.

Performed cooling maintenance. Checked electrical, mechanical and performance of the system. Cleared and treated drain line and washed condenser coil. No major issues were found. Customer supplied filters for replacement. System is on and thermostat was set to 74.

Performed duct system cleaning on entire home with the BrushBeast. Also cleaned out dryer vent and flexible tubing and performed inspection on system. System is operating at this time.

Performed semiannual maintenance on one heat pump cooling system. Inspected all Performance, Mechanical and Safety Systems. Did note the indoor fan coil beginning to show signs of corrosion and rust. Used my electronic leak detector and tested coil for any refrigerant leaks. Did not find any leaks present at this time but will continue to monitor coil moving forward to ensure system stays running at 100% cooling/heating capacity. Flushed and treated the drain pan and primary drain line. Verified everything was operating within manufacture’s specifications for operation. Everything is working at this time.

On arrival, found both system thermostats set to off. Turned the downstairs thermostat on and found only the indoor blower running. Went into the walk in attic on the upstairs and found that the emergency water safety switch was filled with water and tripped, turning the cooling system off from producing additional condensation. Flushed and treated the primary drain line and verified system turned on as designed. Inspected the upstairs thermostat and turned the cooling system on. I noted that only the indoor blower came on, and no refrigerant was being pumped throughout the indoor cooling coil. I went to the outdoor heat pump system and found ants have gotten inside the starter contactor, which prohibited the contacts from closing to allow high voltage electricity to pass through. I installed a new contactor starter, wired up all high and low voltage connections and sprayed electrical system with ant spray to prevent ants from coming into the electrical area. Turned the system on and v

Performed semiannual maintenance on one straight electric cooling system. Inspected all Performance, Mechanical and Safety Systems. Verified everything was operating within manufacture’s specifications for operation. The R-22 refrigerant levels are within guidelines and system is operating at an excellent condition. Changed one homeowner supplied 20x20x1 filter. Everything is working at this time.

Duct Replacement near N Cedar St. Upon receiving a client's inquiry about their ductwork, we visited the premises to evaluate the situation and suggested that they replace the ductwork. Today, we came to their home to replace the ducting with a more dependable system. We eliminated and disposed of the old ductwork throughout the residence and meticulously mounted and sealed the new ducting.

A/C Replacement near Bluff St. At the last maintenance check-up, we discovered the client’s air conditioning unit needed to be replaced. We came out today to install the new system. Removed the old unit from the home and carefully installed the new system and checked all components to ensure operation. The new a/c system is working as per the manufacturer’s specifications.

A/C Repair near Crooked Creek. We were called about a problem with a client’s a/c system. Arrived to investigate the cause of the problems and found the capacitor on the unit required replacement. Replaced the capacitor on the unit and tested it for performance and quality assurance. The air conditioning system is now up and running well again.

Ductwork replacement near Ashford Park Blvd. When a client reached out to us regarding their ductwork we came out and analyzed the situation and recommended ductwork replacement. We arrived today to replace the ducting throughout the home with a more reliable system. Removed and discarded the old ductwork throughout the home and carefully installed and sealed the new ducting in the residence.

Performed cooling maintenance. Checked electrical, mechanical and performance of the system. Cleared and treated drain line and washed condenser coil. Found the outdoor capacitor undervalue. Presented customer with options to repair but they declined at this time. No other major issues were found. System is on and running at this time.

Performed semiannual maintenance on one cooling system. Inspected all Performance, Mechanical and Safety Systems. Verified everything was operating within the manufacture’s specifications for operation. Outside condenser refrigerant pressures are within range and condenser cleaned. Wires inside adjusted. Indoor system drain line cleared and treated. No major issues were found. System running at time of departure.

Performed AC cool check. Checked electrical, mechanical, safety, and performance of the system. No major issues were found. Drain line cleared and treated. Condenser coil clean. Filter changed. Furnace breaker replaced. System was running at the time of departure.

Performed AC cool check. Checked electrical, mechanical, safety, and performance of the system. No major issues were found. Drain line cleared and treated. Condenser coil clean. Electrical disconnect confirmed in and on. System was running at the time of departure.

Performed cooling maintenance. Checked electrical mechanical and performance of the system. Cleared and treated drain line and washed the condenser coil. I found the outdoor capacitor undervalued. No other major issues found. I presented the customer with repair options and she chose to have the capacitor replaced at this time. Repair completed. Disconnect is in and on. The system is running at this time.