HVAC Service In Buda, TX

Performed maintenance on the AC system. Cleared drain but it is tied into the sink, and it seems the sink has a clog as well. Advised customer to have the sink drain treated. The filters are cutting airflow to the system, but the customer does not wish to go with a lower MERV rating due to health concerns.

Performed maintenance on the system. Cleared and treated the drain line. Also cleaned the condenser coils. On the condenser I found a failed capacitor and a failed fan motor. Presented my findings and the customer chose to replace both components. Completed repairs and tested system operation.

Performed maintenance on the AC systems. Cleared drains and cleaned condensers. I did find issues with the 1.5-ton system: 1) The air handler safety switches were wired incorrectly. 2) The capacitor had failed. Completed repairs and systems are both operational.

Performed maintenance on the AC system please see checklist for more details. I cleared and treated the drain line. Also cleaned the condenser coil. There was very little clearance around the flue pipe, so I adjusted the radiant barrier around the pipe. I also found that two ducts had fallen to the ground, so I strapped them back up.

Installed new 2-ton Rheem heat pump system. Built a transition to existing supply plenum. Replaced return plenum and sealed with mastic. Rebuilt and insulated condensate drain line. Installed new filter dryer and pressure tested with dry nitrogen. Pulled a vacuum on copper line set. Replaced disconnect and whip. Replaced condenser pad. Fixed ductwork to allow better airflow.

Performed maintenance on the AC system. Cleared and treated the drain. Also cleaned the condenser coils. We reoriented the kitchen grill to shoot into the room and not to the wall. System is operational at this time with thermostat set to customer preference.

Performed maintenance on the AC system. I cleared the drain and treated the drain line. I cleaned the condenser and the condensing coil. I did find that the condenser fan motor was showing signs of failure and there is buildup on the inside unit. The client opted to replace the fan motor but hold off on everything else. I replaced the fan motor while on site and system is operational at this time.

Installed new Carrier heat pump system in closet. Added 20x20 filter base and plywood overlay. Rebuilt drain line with SS-2 safety switch and French drain outside. Sealed return chase and copper penetration. Fixed kinked duct to master bedroom and verified system operation.

Performed maintenance on all three AC systems. I cleared the drain lines and cleaned the condensers. Both the main house and the pool house had bad capacitors. The client chose to replace just the main house capacitor. Repair completed and systems are operational.

Performed maintenance on the AC system. I cleared the drain line and cleaned the condenser. I did find that the blower motor has overheated and should be replaced. The disconnect also needs to be replaced. I gave options to repair, but customer declined. System is operational at this time.

Performed maintenance on the AC system. Changed filter, cleared the drain, and cleaned condensing coil. System operational.

Performed maintenance on the AC system. I cleared the drain line and cleaned the condenser coil. We are starting to see wear on the condenser fan motor, and I gave the client options to replace but he declined at this time. System is operational.

Performed AC cool check. Checked electrical, mechanical, safety, and performance of the system. Mold/mildew was found inside the air handler. No other major issues were found. Drain line cleared and treated. Condenser coil cleaned. Options for repair were presented to customer and they declined repair at this time. Electrical disconnect confirmed in and on. System was running at the time of departure.

Performed AC cool check on three systems. System that runs the right side of the house also had a dirty blower wheel. The condenser fan motor on the unit showed signs of overheating. Upstairs system also had a condenser fan motor that showed signs of overheating. No other major issues were found. Drain lines cleared and treated. Condenser coils cleaned. Electrical disconnects confirmed in and on. Systems were running at the time of departure.

Performed maintenance on the AC system. Cleared drain and cleaned condenser coil. I did talk to the clients about the condenser fan motor, and they chose to wait and do the warranty replacement later in the year. System is operational at this time.

Diagnostic found that the safety switch on the primary drain line had failed. Safety switch was replaced under warranty. System is operational and was running at the time of departure.

Performed maintenance on the AC system. Cleared drains and cleaned condenser. I found that the condenser fan motor had overheated, and that the outdoor capacitor was in danger of failing. I gave the client his options, and he chose to have both components replaced. I completed repairs and completed performance and safety testing. System operational.

Performed service diagnostic. Diagnostic found that the capacitor on the condenser unit had failed. Condenser fan motor had also failed. Options for repair were presented to customer and they chose to have both components replaced. Repair was completed. Electrical disconnect confirmed in and on. System was running at the time of departure.

Installed minisplit system. Everything is working great.

Performed maintenance on the AC system. Checked blower, evaporator coil and all electrical and mechanical systems. Cleared the drains and cleaned the condensing coil. Checked pressure with no major issues. System is operational.