HVAC Service In Buda, TX

Performed the AC tune-up. While performing the inspection I did find deficiencies with the system and the client chose to have the mandatory repairs done at this time. After performing the repairs, the system is operational.

Performed the AC tune-up. While performing the inspection I did find deficiencies with the system. I presented the client with his options, and he chose to have the mandatory repairs done at this time. After performing the repairs everything is coming on and working at this time.

Performed AC cool check. Checked electrical, mechanical, safety, and performance of the system. No major issues were found. Drain line cleared and treated. Condenser coil cleaned. Electrical disconnect confirmed in and on. System was running at the time of departure.

Performed cool check on the AC system. Checked blower, coil, and all electrical with no major issues found on the furnace or coil. Cleared drains. Check capacitor starter and breaker. When checking charge, I did find that the system was low on refrigerant. Gave the client options and he chose to charge system to proper specs. Completed repair, cleaned condensing coil, and set thermostat to customer preference. System operational.

Performed scheduled maintenance on two AC systems. Cleared drains and checked wiring on both systems. Cleaned and washed both condensers. Checked caps and pressure. On the 5-ton system, the capacitor was bad, and I gave the client options, and she chose to have it replaced. No other major issues were found. Repair completed and systems cycled. Thermostat put back to customer preference and disconnects checked and in the on position.

Installed new Rheem heat pump system in attic. Replaced supply plenum and hard ducted to return with AprilAire media filter cabinet. Also replaced flex duct, buckets, and registers. Rebuilt drain line with SS-2 and SS-3 safety switches. Installed new line filter dryer and pressure tested system for extensive leak check. Pulled deep vacuum and weighed in factory charge. System working at this time.

Diagnosed bad capacitor. Gave client options and he chose to have it replaced. Replaced capacitor on site and secured it in place. Tested system and it is operational.

Performed service diagnostic. Diagnostic found that the capacitor on the condenser unit had failed and the disconnect for the condenser unit was broken. Connections are intact on the disconnect but the pull handle was missing. Options for repair were presented to customer chose to have both components replaced. Capacitor was replaced and the system is up and running. Repair was completed. Disconnect confirmed in and on. System was running at the time of departure.

Customer stated that water was leaking out of system. Found that the drain pan had debris in the primary that had backed up causing the pan to overflow. Presented repair options and customer chose to have the pan and drain cleared. Customer also chose option to clean coil and blower motor. Repairs were completed and system is operational.

Installed new Rheem 4-ton gas system. Re-piped and insulated condensate drain line and installed float switches. Installed new inline filter dryer on cooper line set. Pressure tested with dry nitrogen and pulled a vacuum on the line set. Weighed in refrigerant and charged system to factory specs. Replaced both supply and return plenum as well as replace all zoning components (16x16 dampers and zone board). Reattached ductwork to each zone and sealed all joints and connections with an airlock mastic. System operational.

System was not cooling, and I diagnosed that the capacitor had failed (40/7.5 cap and was reading 10/2.8). Gave the customer options and he chose to have the capacitor replaced. Tested system: pressures were good and so was the temp split. System is operational upon departure.

Installed new Rheem system in attic. Installed new temporary supply and return plenums to preexisting ductwork. Installed media filter and new Ecobee thermostat. Added filter dryer and pressure tested system for extensive leak check. Pulled deep vacuum and weighed in factory charge. Rebuilt drain line with SS-2 and SS-3 safety switches. System operating at this time.

Performed maintenance on the AC system. Also checked air flow and cooling in the guest room. Found no issues other than the windows were open allowing heat into the room. I did find the cap under value and presented Ralph with repair options. He chose to have the capacitor replaced today. Completed repairs and system operational.

Performed maintenance on the AC system. I did find the capacitor to be failing and the fan motor showing signs of overheating. I presented Dena with options to repair, and she chose to change the capacitor and wait on fan motor. Completed repair and performed safety testing. System operational.

Performed the AC tune-up. I did find some deficiencies with the system and presented options for repairs to the client. They chose to have the capacitor replaced and would like estimates for remainder of the work. Replaced capacitor and system is operational.

Performed the AC tune-up. While performing the inspection I did find deficiencies with the system. I presented them to the client, and he is going to talk it over with the other homeowners and decide what repairs they want to make.

Performed AC cool check. Checked electrical, mechanical, safety, and performance of the system with no major issues found. Drain line cleared and treated. Condenser coil cleaned. Electrical disconnect confirmed in and on. System was running at the time of departure.

Diagnosed a failed blower motor. Presented Janet with options and she chose to replace motor, clean blower wheel and sign up for maintenance. Performed repair and cleaning and then completed maintenance. No other major issues found. System operational.

Trip 1 - Performed maintenance on system. I did find that one of the system sterilizer bulbs had burnt out. Presented Frank with options and he chose to renew his maintenance agreement and replace bulb on the sterilizer. Will return later today to replace bulb. Please see attached checklist for full tune-up details. Trip 2 - Installed replacement bulb and tested system. Sterilizers fully operational.

Performed maintenance on system. I did find a couple of deficiencies and presented Martha with options for repairs. She chose to replace the condenser fan motor and capacitor. Completed repairs and system is operational.