Kyle TX Heating & Air Conditioning Services

Performed AC cool check. Checked electrical, mechanical, safety, and performance of the system. The air handler and blower wheel are clean. System sterilizers and air purifiers are operational. The filter was replaced with a customer supplied filter. The drain line was cleared and treated. Condenser fan motor and contactor are in good condition. Capacitor is within value. Refrigerant charge is within spec. Condenser coil was cleaned. Customer chose to renew maintenance agreement. The system was running at the time of departure.

Performed AC cool check. Checked electrical, mechanical, safety, and performance of the system. The air handler and blower wheel are clean. Drain line was cleared and treated. I sealed up a small air leak in the air handler where the signal wiring penetrates the unit. Air filter was replaced with a customer supplied filter. UV light and surge protector for the furnace are both operational. The condenser capacitor is below value. Disconnect is in good condition and the surge protection is operational. Condenser fan motor and contactor are both in good condition. Condenser coil clean. No other major issues were found. Options for repair were presented to the customer and they chose to have the condenser capacitor replaced today. I replaced the capacitor on the condenser unit and function checked the system. System was running at the time of departure.

We went into the attic and found the polarity to be correct, but the pressure switch tubing has cracked slightly; it rubbed out around the inducer housing. We decided to go ahead and hard pipe the gas line out of the furnace per code. Leak tested the new gas piping and verified no leaks were present in the threads. Verified furnace operation. Everything is working at this time.

We arrived to find the system off. We spoke to Mark about how the system had been performing. We made sure to clear the drain and also rinse out the outdoor unit. During our evaluation of the system, we found everything to be in good shape. All components are currently operating within the proper ranges. The refrigerant levels were in spec as well. We also did discuss having to install a condensate pump in case they continue to have drain issues in the future. We didn’t experience any with our visit, but it was discussed with Mark. No recommendations were made at this time. System is in working order at completion of service.

We arrived to find the system off. We spoke to Mark about how the system had been performing. We made sure to clear the drain and also rinse out the outdoor unit. During our evaluation of the system, we found everything to be in good shape. All components are currently operating within the proper ranges. The refrigerant levels were in spec as well. We also did discuss having to install a condensate pump in case they continue to have drain issues in the future. We didn’t experience any with our visit, but it was discussed with Mark. No recommendations were made at this time. System is in working order at completion of service.

We arrived to find the system off. We spoke to Mark about how the system had been performing. We made sure to clear the drain and also rinse out the outdoor unit. During our evaluation of the system, we found everything to be in good shape. All components are currently operating within the proper ranges. The refrigerant levels were in spec as well. We also did discuss having to install a condensate pump in case they continue to have drain issues in the future. We didn’t experience any with our visit, but it was discussed with Mark. No recommendations were made at this time. System is in working order at completion of service.

We arrived to find the system off. We spoke to Mark about how the system had been performing. We made sure to clear the drain and also rinse out the outdoor unit. During our evaluation of the system, we found everything to be in good shape. All components are currently operating within the proper ranges. The refrigerant levels were in spec as well. We also did discuss having to install a condensate pump in case they continue to have drain issues in the future. We didn’t experience any with our visit, but it was discussed with Mark. No recommendations were made at this time. System is in working order at completion of service.

Installed new 3-ton Carrier gas furnace system. Installed new Ecobee Pro thermostat. Rebuilt and insulated condensate drain line. Added SS2 and SS3 safety float switches. Installed new filter dryer, pressure tested with dry nitrogen and pulled a vacuum on copper line set. Replaced the condenser pad. Replaced the disconnect and ran the low voltage in seal tight. Replaced both supply and return plenums and sealed with a mastic airlock. Added a new Aprilaire 1210 media filter. Charged system to factory specs.

Completed semiannual maintenance on one system. Upon evaluation of the system, I found that there is no float switch. I also found the contactor to be charred and slightly pitted. No other major issues found. See attached checklist for full tune-up details. I brought my concerns to the homeowner, and he decided to move forward with both repairs. Replaced the contactor and installed a safety float switch. Once repairs were completed, I cycled the system in cooling. The system is operating properly at this time.

Completed semiannual maintenance on one system. Upon evaluation of the system, I found that there is no float switch. I also found the contactor to be charred and slightly pitted. No other major issues found. See attached checklist for full tune-up details. I brought my concerns to the homeowner, and he decided to move forward with both repairs. Replaced the contactor and installed a safety float switch. Once repairs were completed, I cycled the system in cooling. The system is operating properly at this time.

Completed semiannual maintenance on one system. Upon evaluation of the system, I found that there is no float switch. I also found the contactor to be charred and slightly pitted. No other major issues found. See attached checklist for full tune-up details. I brought my concerns to the homeowner, and he decided to move forward with both repairs. Replaced the contactor and installed a safety float switch. Once repairs were completed, I cycled the system in cooling. The system is operating properly at this time.

Completed semiannual maintenance on one system. Upon evaluation of the system, I found that there is no float switch. I also found the contactor to be charred and slightly pitted. No other major issues found. See attached checklist for full tune-up details. I brought my concerns to the homeowner, and he decided to move forward with both repairs. Replaced the contactor and installed a safety float switch. Once repairs were completed, I cycled the system in cooling. The system is operating properly at this time.

nstalled Carrier furnace and Payne condenser. Installed Honeywell T6 thermostat. Built new supply and return plenums and sealed all connections with mastic. Replaced secondary drain pan. Rebuilt and insulated primary and secondary drain lines. Cleared and verified primary drain operation. Installed SS2 and SS3 safety float switches. Pressure tested and pulled a vacuum on the copper line set. Replaced disconnect and whip for condenser. Ran low voltage in 1/2-inch Seal-Tite. Weighed in charge to meet manufacturers specifications.

On arrival, the customer informed me that his thermostat was blank and not working. After inspecting the system, I found that the high voltage wire nuts at the furnace had melted and was not providing any voltage to the system. I stripped back the wire and added the wire nut to the connections. **This is covered under Garner AC warranty.** As I started up the system, I found that one of the supply duct connections had come apart. I informed the customer and presented options for repair on the duct. He chose to have the duct sealed and would also have a cooling maintenance completed today. I secured the duct connection with duct straps and duct tape. Checked all electrical, mechanical and performance of the system. No other major issues were found. The system is operational at this time.

Performed cooling maintenance on two heat pump systems. Checked all electrical, mechanical and performance of both systems. Cleared and treated both drain lines and washed both outdoor coils. Customer supplied filters for replacement. While performing the maintenance I found the capacitor at the condenser for the upstairs system had ruptured. I informed the homeowner, and she chose to have the capacitor replaced at this time. I completed the repair and also replaced the burnt wire connections. I then cycled power at the thermostat. No other major issues were found. Both systems are operational at this time.