Kyle TX Heating & Air Conditioning Services

Performed heat check. Checked electrical, mechanical, safety, and performance of the system. Flame ignition achieved and the flame sensor cleaned. The gas pressure was slightly out of range, so I adjusted that today. Filters were also clean. No other major issues were found, and the system was running at time of departure. Gas valves confirmed on. See attached checklist for full tune-up details.

I arrived at the home to find the system on and heating. I spoke to the homeowner about how the system had been operating. I performed a heating tune-up on the system. I made sure to rinse out the condenser coil. During my evaluation I noticed the following: the inside of the air handler is covered in organic growth, the coil has growth on the top and bottom side of it, the blower wheel is dirty, the contactor is pitted and charred and buzzes while engaged, and the condenser fan motor is leaking oil and overamping. System is in working order a completion of appointment.

I arrived at the home to find the system on and heating. I spoke to the homeowner about how the system had been operating. I performed a heating tune-up on the system. I made sure to rinse out the condenser coil. During my evaluation I noticed the following: the inside of the air handler is covered in organic growth, the coil has growth on the top and bottom side of it, the blower wheel is dirty, the contactor is pitted and charred and buzzes while engaged, and the condenser fan motor is leaking oil and overamping. System is in working order a completion of appointment.

I arrived at the home to find the system on and heating. I spoke to the homeowner about how the system had been operating. I performed a heating tune-up on the system. I made sure to rinse out the condenser coil. During my evaluation I noticed the following: the inside of the air handler is covered in organic growth, the coil has growth on the top and bottom side of it, the blower wheel is dirty, the contactor is pitted and charred and buzzes while engaged, and the condenser fan motor is leaking oil and overamping. System is in working order a completion of appointment.

I arrived at the home to find the system on and heating. I spoke to the homeowner about how the system had been operating. I performed a heating tune-up on the system. I made sure to rinse out the condenser coil. During my evaluation I noticed the following: the inside of the air handler is covered in organic growth, the coil has growth on the top and bottom side of it, the blower wheel is dirty, the contactor is pitted and charred and buzzes while engaged, and the condenser fan motor is leaking oil and overamping. System is in working order a completion of appointment.

Performed semiannual maintenance on one gas furnace heating system. Inspected all Performance, Mechanical and Safety Systems. I did run a combustion analysis on the furnace during the maintenance due to the age of the furnace. Found combustion readings to be within range for operation. Did note that the inducer motor bearings are beginning to fail. While the motor was running, I could hear the motor running at a higher pitch. Spoke with Mr. Joe about this concern and he said he wants to let it keep going for the time being. Did verify the system started up prior to departure. Everything is working at this time. See attached checklist for full tune-up details.

Performed heat check. Checked electrical, mechanical, safety, and performance of the system. All heat strips activated. Filters changed with customer supplied filters. During my maintenance, I noticed that the indoor blower motor has a little bit of buildup on it. Brought this to homeowner’s attention and she decided hold off on the blower cleaning until next year. No other major issues were found and system running at time of departure.

Performed heat check. Checked electrical, mechanical, safety, and performance of the system. All heat strips activated. Filter was clean and recently replaced by the homeowner. Outside condenser refrigerant pressures are within range and condenser cleaned. During my maintenance, I noticed the condenser fan motor is showing severe signs of overheating. I presented my findings to the homeowner, but he declined repairs today and would like to revisit during the Spring check. No other major issues were found and system running at time of departure. See attached checklist for full tune-up details.

Performed heat check on a Goodman 90% gas furnace. Checked electrical, mechanical, safety, and performance of the system. Filter was dirty however the customer did not have a replacement. No other major issues were found. See attached checklist for full tune-up details. Flame sensor was cleaned and is in good condition. Drain line was cleared and treated. Inside of the furnace and blower wheel are also clean. Electrical disconnects confirmed in and on system was running at the time of departure.

Performed heat check. Checked electrical, mechanical, safety, and performance of the system. Flame ignition achieved and flame sensor cleaned. Filter was clean as well. No major issues were found and system running at time of departure. Gas valves confirmed on.

I arrived to find the system off and not running. I discovered that the homeowner had run a new thermostat wire to the outdoor unit that needed to be hooked up and that’s why we were called out today. They agreed to my estimate and I got to work. I got the thermostat wire cleaned up and attached both inside and outside. I tested the system and saw the heat strips come on. I also tested the AC and made sure it came on as well. The unit is getting up there in age. By my estimation the system is 10-11 years old. I let them know the average lifespan of these systems and advised that they start saving for a new one.

I arrived to find the system off and not running. I discovered that the homeowner had run a new thermostat wire to the outdoor unit that needed to be hooked up and that’s why we were called out today. They agreed to my estimate and I got to work. I got the thermostat wire cleaned up and attached both inside and outside. I tested the system and saw the heat strips come on. I also tested the AC and made sure it came on as well. The unit is getting up there in age. By my estimation the system is 10-11 years old. I let them know the average lifespan of these systems and advised that they start saving for a new one.

I arrived to find the system off and not running. I discovered that the homeowner had run a new thermostat wire to the outdoor unit that needed to be hooked up and that’s why we were called out today. They agreed to my estimate and I got to work. I got the thermostat wire cleaned up and attached both inside and outside. I tested the system and saw the heat strips come on. I also tested the AC and made sure it came on as well. The unit is getting up there in age. By my estimation the system is 10-11 years old. I let them know the average lifespan of these systems and advised that they start saving for a new one.

I arrived to find the system off and not running. I discovered that the homeowner had run a new thermostat wire to the outdoor unit that needed to be hooked up and that’s why we were called out today. They agreed to my estimate and I got to work. I got the thermostat wire cleaned up and attached both inside and outside. I tested the system and saw the heat strips come on. I also tested the AC and made sure it came on as well. The unit is getting up there in age. By my estimation the system is 10-11 years old. I let them know the average lifespan of these systems and advised that they start saving for a new one.

I arrived at the home to find the system off and not running. I checked over the system and discovered the following: the flue pipe isn’t done up to our standard, the installing company ran a flexible gas line through the cabinet of the furnace, low voltage is being run through installer made holes, the platform wasn’t enlarged to account for the new furnace size, and the reason the system was in failure was due to a loose neutral at the high voltage junction box at the furnace. The homeowner elected to get the system back up and running. I remade new connections inside the junction box. I also checked the AC side of the system and the heating side of the system. He’s wanting to see if he can get in touch with the installation company to rectify the other issues.