Kyle TX Heating & Air Conditioning Services

Performed cooling maintenance. Checked electrical, mechanical and performance of the system. Cleared and treated the drain line and washed the condenser coil. No major issues found. See attached checklist for full tune-up details.

Performed service diagnostic. Diagnostic found that the primary condensate drain line was clogged. Water had backed up and tripped the safety switch. Options for repair were presented to the customer and they chose to have the drain line cleared today. Drain line was cleared and flow tested with water. Drain line was treated. System was function checked and was running at the time of departure.

Performed service diagnostic. Diagnostic found that the primary condensate drain line was clogged. Water had backed up and tripped the safety switch. Options for repair were presented to the customer and they chose to have the drain line cleared. Drain line was cleared and treated. System was function checked and was running at the time of departure.

Performed cooling maintenance. Checked electrical, mechanical and performance of the system. Cleared and treated drain line and washed the condenser coil. Also replaced 4 inch media filter. I found the condenser fan motor showing signs of overheating. Please see attached checklist for full tune-up details. I presented the customer with options to repair, and he chose to have the motor replaced and add surge protection to the condenser and the air handler in the attic. After completing repairs, I cycled the thermostat everything is on and running at this time.

On arrival, I found the thermostat set to cool, but the outdoor heat pump was not pumping any refrigerant. I turned off the high voltage power to the system and checked the outdoor run capacitor. I found the capacitor to have failed well below value. I replaced the capacitor and started the system up. I then noticed that there was no power being passed through to the contactor. I diagnosed that the low-pressure switch had stuck open. I removed the top of the fan shroud and tapped on the pressure switch and it seated back closed. The outdoor system came on and ran as designed. The indoor filter has not been changed in some time and is extremely clogged up causing an airflow restriction. A replacement filter (AprilAire 210) needs to be purchased and installed. The homeowner had an F100 filter inside and I informed the homeowner that the correct filter needs to be installed to ensure proper airflow and air filtration. Everything is working at this time.

Performed cooling maintenance. Checked electrical, mechanical and performance of the system. Cleared and treated the drain line and washed the condenser coil. No major issues were found. I replaced the 4-inch media filter. UV lights are on and operational. System is working at this time.

Performed cooling maintenance. Checked electrical, mechanical and performance of the system. Cleared and treated drain line and washed the condenser coil. No major issues were found. System is on and running at this time.

Performed AC cool check. Checked electrical, mechanical, safety, and performance of the system. No major issues were found. Drain line cleared and treated. Condenser coil cleaned. Electrical disconnect confirmed in and on. System was running at the time of departure.

Performed AC cool check. Checked electrical, mechanical, safety, and performance of the system. No major issues were found. Drain line was cleared and treated. Condenser coil cleaned. Electrical disconnect confirmed in and on. System was running at the time of departure.

Performed cooling maintenance. Checked electrical, mechanical and performance of the system. Cleared and treated the drain line and washed the condenser coil. I did find that the transformer needs to be replaced. No other major issues were found. The system is on and running at this time

Performed cooling maintenance. Checked electrical, mechanical and performance of the system. Cleared and treated the drain line and washed the condenser coil. I did find that the transformer needs to be replaced. No other major issues were found. The system is on and running at this time

Found compressor plug terminals have melted. Installed new grounding plugs and started system. System currently operational.

On arrival, the homeowner stated that the air coming from vents was not cold. I performed diagnostics and found the refrigerant charge to be extremely low. Went into the attic to perform a refrigerant leak search, but was unable to do so do to the location of the HVAC system. I was unable to access the coil panel as it was up against the beams of the home, facing the opposite direction of the crawl area. Informed homeowner of this issue and he said he would just like to recharge the system for the time being. I added in 6.5# of R-410A refrigerant. Inspected temperature difference between the return and supply vents and informed homeowner to purchase replacement filters, as the current ones installed are extremely clogged up. System was running with a 12°SH and a 12°SC upon departure.

Performed cooling maintenance. Checked electrical, mechanical and performance of the system. Cleared and treated drain line and washed the condenser coil. I found that the 3 UV lights had tripped the transformer. I separated one of the lights and added it to a new transformer. All three lights are now working properly. No other major issues were found. System is on and running at this time.

Performed service diagnostic. Diagnostic found that the system was low on refrigerant. Leak check was performed and no leaks where detected. Options for repair were presented to the customer and they chose to have refrigerant added today. Refrigerant was balanced by adding 4 lbs. Upon departure, the system was operating at 9 degrees of sub cooling per data plate.