Wimberley TX Heating & Air Conditioning Services

Performed maintenance on the AC systems. I cleared and treated both drains and confirmed that safety switches were working. I changed the filter on the downstairs system. I cleaned both condensers. Both systems are operational at this time.

Inspected all Performance, Mechanical and Safety Systems. Found the outdoor run capacitor below value for operation and the primary water safety switch intermittently failing between cycles not allowing for the outdoor cooling unit to turn on. Also noted the indoor coil is extremely rusted/corroded leading to potential for rupture of the coil causing the system to lose refrigerant. Spoke with homeowner and they decided to move forward with replacing the outdoor run capacitor and installing new water safety switches inside attic. Homeowner also decided to join our yearly maintenance plan. Completed repairs and tested all systems. Everything is working at this time.

Performed maintenance on the AC system. I rewired the float switch into the Y wire because it was not stopping voltage on the red. I cleared and treated the drain. I cleaned the condenser coil and added locking caps. System is operational at this time.

Performed maintenance on the AC system. I cleared and treated the drain line. I cleaned the condenser coil and ensured all electrical connections were tight. I found that the condenser fan had overheated and presented repair options to client. She opted to have the motor replaced today. Completed repair and system is operational.

Performed AC cool check on two systems. Both disconnects for the condenser units were not wired correctly. No other major issues were found. Drain lines cleared and treated. Condenser coils cleaned. Fuses for the two disconnects have been installed and the disconnects have been rewired correctly. Systems were running at the time of departure.

Performed semiannual maintenance on 2 cooling systems. Tested all Performance, Mechanical and Safety Systems. The side guest house system is running within manufacture’s specifications for operation. The main house has a corroded indoor cooling coil, the drain pan is severely clogged, and the outdoor condenser coil is extremely brittle. Lastly, the outdoor exhaust motor has overheated.

Performed semiannual maintenance on 3 cooling systems. Tested all operations. Found everything to be working within manufacture’s specifications for operation. Cleared drains and cleaned condensers. Everything is working at this time.

Performed maintenance on the AC system. I cleared the drain and cleaned the condenser coil. System is operational at this time. Please see attached checklist for full tune-up details.

Performed maintenance on the AC system. Cleared and treated the drain. Cleaned the condenser. System is operational at this time.

Performed maintenance on the AC system. There is build up in the air handler. I brought this up to the customer and added foam tape around return to help with blow by. I cleared the drain and treated pan. I also cleaned the condenser coil. I gave customer options for our Breathe Easy Package and surge protection, but they declined today. System is operational at this time.

Performed the AC tune-ups. While performing the inspections I did find deficiencies with the system. I presented the client with her options, and she chose to have them repaired at this time. After performing the repair everything is working at this time.

Performed the AC tune-up. While performing the inspection I found deficiencies with the condenser fan motor and the starter. I presented the client with her options, and she chose to have them replaced today. After performing the repair everything is working at this time.

Performed AC cool check on two systems. Checked electrical, mechanical, safety, and performance of the systems. Guest house system was low on refrigerant. The capacitor on the condenser unit had also failed. No other major issues were found with either system. Drain lines cleared and treated. Condenser coils cleaned. Options for repair were presented to customer and they chose to have the capacitor replaced and the system recharged. Repairs where completed. Systems were running at the time of departure.

Installed new 4-ton Carrier heat pump system for the downstairs. Installed new Ecobee Pro thermostat. Replaced the return plenum. Sealed all joints with a mastic airlock. Rebuilt condensate drain line and insulated it. Added SS2 and SS3 safety float switches. Replace inline filter dryer, pressure tested with dry nitrogen and pulled a vacuum on copper line set. Ran low voltage on both condensers in seal tight and installed new penetration covers. Charged system to factory specs.

Performed the AC tune-ups. While performing the inspection I did find that the Stage 4 Breathe Easy package for the Living Area system had failed. I replaced it under the parts and labor warranty. Everything is working at this time.

After performing the diagnostic, I found that the primary drain line on the Carrier system was completely clogged and tripping the safety float switch. I also found that the battery cap on the condenser was failing. I presented the clients with their options, and they chose to have both repairs completed today. Completed repairs and completed performance and safety testing. System operational.

After performing the diagnostic, I found that the battery cap had completely failed. I also found that the starter had failed as well. I presented the clients with their options, and they chose to have them replaced at this time. Repairs completed and system operational.

Installed new Carrier straight electric system in attic. Hung system from ceiling with plywood base. Added new drain pan and reused plenums. Installed new line filter dryer and pressure tested system for extensive leak check. Pulled deep vacuum and charged system to factory specs. System operating at this time.

After performing the diagnostic, I found that the battery cap to the upstairs system had completely failed. I presented the client with her options, and they chose to have it replaced today. After completing repairs, the system is operational.

Performed semiannual maintenance. Inspected all Performance, Mechanical and Safety Systems. Verified everything was operating within manufacture’s specifications for operation. Everything is working at this time.