HVAC Service In Buda, TX

Performed heat check on two systems. Checked the electrical, mechanical, safety, and performance of the systems. I cleared the condensation drain lines and flow tested the drains with two gallons of water. I also treated the drain lines. The air filters are clean and have been recently replaced by the homeowner. No major issues were found. The systems were running at the completion of service.

Installed Carrier heat pump system. Installed Santa Fe dehumidifier. Installed new supply trunk line and new return plenum. Installed Aprilaire media cabinet. Built new drain that ties into both the dehumidifier and the system. Insulated and cleared the drain. Installed new secondary drain pans for both dehumidifier and the system. Installed new supply registers. Installed new bucket and sealed to the drywall in the master bedroom. Hung and secured all ducts back to the unit. Installed new Ecobee Pro thermostat. Installed new subpanel in the attic. Installed new disconnect and whip at outdoor unit. Reinsulated suction line Tested system in both heating and cooling.

Heat checked performed on a horizontal heat pump system and mini split. Drain lines were flushed and treated. Both outdoor coils were cleaned. All mechanical and electrical components found within manufacturer specifications. Both systems are operating properly at time of departure.

Removed old return plenum and added two new returns with both filter cabinets. Sealed all seams with silver tape, hard cast, super sticky and mastic. Capped bedroom return and attached to new plenums. Swapped old supply register in master bedroom with a new register. Cleared drain. Everything is operational at this time.

Performed heat check. Checked the electrical, mechanical, safety, and performance of the system. I cleared the condensation drain line and flow tested the drain with two gallons of water. I also treated the drain line. The air filter was clean and had been recently replaced by the homeowner. No major issues were found. The system was running at the completion of service.

Performed heater tune-up on a Carrier gas furnace system. Checked the electrical, mechanical and performance systems of the unit. Cleared, cleaned, flushed and treated the drain line. Replaced air filter with client supplied filter. No major issues were found. Both surge protection devices are working. The system is operational at this time.

Performed heater tune-up on a Carrier electric heating system. Checked the electrical, mechanical and performance systems of the unit. Cleared, cleaned, flushed and treated the drain line. I did find the main breaker for the condenser is oversized. It requires a Eaton 2 pole 40amp breaker and currently has a 60A. The outdoor surge protection device has also failed. I presented repair options to the homeowner and she chose to have the surge protection device replaced. I replaced the outdoor surge protection device and cycled power. No other issues were found. The system is operational at this time.

Performed heater tune-up on a Lennox gas furnace system. Checked the electrical, mechanical and performance systems of the unit. Cleared, cleaned, flushed and treated the drain line and cleaned the exterior of the furnace system. Replaced the high voltage wire nuts with a wago wire connector. Sealed some air straws on the furnace. No major issues were found. The system is operational at this time.

Performed heat check. Checked the electrical, mechanical, safety, and performance of the system. I cleared the condensation drain line and flow tested the drain with two gallons of water. I also treated the drain line. The air filters were replaced with client supplied filters. The blower wheel had some dust/dirt buildup on it. No other issues were found. The system was running at the completion of service.

Performed heat check. Checked the electrical, mechanical, safety, and performance of the system. I cleared the condensation drain line and flow tested the drain with two gallons of water. I also treated the drain line. The air filter was new and had been replaced by the homeowner before arrival. No major issues were found. The system was running at the completion of service.

Performed heat check. Checked the electrical, mechanical, safety, and performance of the system. I cleared the condensation drain line and flow tested the drain with two gallons of water. I also treated the drain line. No major issues were found. The system was running at the completion of service.

Performed heater tune-up on a Carrier heat pump system. Checked the electrical, mechanical and performance systems of the unit. Cleared, cleaned, flushed and treated the drain line. Cleaned the exterior of the air handler and secured the outdoor compressor wiring. No major issues were found. All UV lights, air purifier and surge protection devices are working. The system is operational at this time.

Performed heater tune-up on a Carrier heat pump system. Checked the electrical, mechanical and performance systems of the unit. Cleared, cleaned, flushed and treated the drain line and cleaned the exterior of the air handler. Sealed around the filter to help prevent any filter bypass. I did find the outdoor starter is pitted at the contacts. Presented repair options and homeowner chose to have the starter replaced. I replaced the starter and cycled power at the thermostat. No other issues were found. The system is operational at this time.

Performed heat check. Checked the electrical, mechanical, safety, and performance of the system. I cleared the condensation drain line and flow tested the drain with two gallons of water. I also treated the drain line. The air filter was replaced with a client supplied filter. No major issues were found. The system was running at the completion of service.

Performed heater tune-up on a Carrier mini split system. Checked the electrical, mechanical and performance systems of the unit. Cleared, cleaned, flushed and treated the drain line. Washed the air filters and cleaned the exterior of the indoor mini split. Also cleaned and washed the outdoor coil. No issues were found. The system is operational at this time

Performed heat check. Checked the electrical, mechanical, safety, and performance of the system. I cleared the condensation drain line and flow tested the drain with two gallons of water. I also treated the drain line. The air filters were clean and had been recently replaced by the homeowner. No major issues were found. The system was running at the completion of service.

Performed heat check on two systems. I cleared the condensation drain lines and flow tested the drains with two gallons of water. I also treated the drain lines. The air filters were clean and had been recently replaced by the homeowner. Both systems had blower motor capacitors that were below value. The upstairs system had high static pressure and the downstairs systems had rust forming on the heat exchanger. I spoke with the homeowner and went over what I had found. He decided to replace the capacitor on the downstairs system. I replaced the blower motor capacitor on the downstairs system and function tested the system. The system is operational. No other major issues were found. Both systems were running at the completion of service.

Performed heater tune-up on a Goodman gas furnace system. Checked the electrical, mechanical and performance systems of the unit. Cleared, cleaned, flushed and treated the drain line and cleaned the exterior of the furnace. I replaced the high voltage wire nuts with a Wago wire connector. No other issues were found. The system is operational at this time.

Installed zoned 4-ton R-454B Carrier Infinity system with gas furnace and evaporator coil in the attic. Installed Carrier Infinity thermostats. Installed new Infinity zone control board. Built and installed new supply plenum with 1 square zone damper and 1 round zone damper. Built and installed new return plenum with 2 - 20x25 Aprilaire media filters. Installed new secondary drain pan. Rebuilt primary condensation drain and added SS2 and SS3 safety switches. Installed new gas pipe and flue pipe connections for the furnace. Pressure tested system with nitrogen and pulled vacuum. Cleared primary drain with CO2 and primed trap with water. Charged AC with R-454B refrigerant according to Infinity thermostat. Tested heating and cooling operation of new system. Tested operation of zone control. Everything is working at completion of install.

Performed heat check. Checked the electrical, mechanical, safety, and performance of the system. I cleared the condensation drain line and flow tested the drain with two gallons of water. I also treated the drain line. The air filters were clean and had been recently replaced by the homeowner. Surge protectors are operational. No major issues were found. The system was running at the completion of service.