HVAC Service In Buda, TX

I arrived at the home to find the systems off and not running. I spoke to the homeowner about how the units had been performing. I made sure to rinse out both condensers and also clear both drains. The upstairs system is in great shape. No major issues were discovered. The downstairs system has a few problems that I discovered: the float switch has failed, the blower wheel is dirty, the condenser fan motor is leaking oil, and the start kit has failed. I brought all of this to the attention of the homeowner and made them a few options. Systems are working to the best of their ability at this time.

I arrived at the home to find the systems off and not running. I spoke to the homeowner about how the units had been performing. I made sure to rinse out both condensers and also clear both drains. The upstairs system is in great shape. No major issues were discovered. The downstairs system has a few problems that I discovered: the float switch has failed, the blower wheel is dirty, the condenser fan motor is leaking oil, and the start kit has failed. I brought all of this to the attention of the homeowner and made them a few options. Systems are working to the best of their ability at this time.

I arrived at the home to find the systems off and not running. I spoke to the homeowner about how the units had been performing. I made sure to rinse out both condensers and also clear both drains. The upstairs system is in great shape. No major issues were discovered. The downstairs system has a few problems that I discovered: the float switch has failed, the blower wheel is dirty, the condenser fan motor is leaking oil, and the start kit has failed. I brought all of this to the attention of the homeowner and made them a few options. Systems are working to the best of their ability at this time.

Cool check completed on a two-year-old vertical heat pump. The indoor unit is clean and the air filter good as well. I cleared the drain line and checked the float switch. The outdoor coils were cleaned. All electrical is within manufactures specs and the refrigerant level is within range. No major issues found.

I arrived at the home to find the system off and not running. I spoke to the homeowner about how the system had been operating. I made sure to rinse the outdoor coil and also clear the drain. I checked over the system and found it to be very clean. All major and minor electrical components checked out fine. The refrigerant charge was proper as well. No recommendations were made at this time. The system is working properly at completion of appointment.

I arrived at the home to find the system off and not running. I spoke to the homeowner about how the system had been operating. I made sure to rinse the outdoor coil and also clear the drain. I checked over the system and found it to be very clean. All major and minor electrical components checked out fine. The refrigerant charge was proper as well. No recommendations were made at this time. The system is working properly at completion of appointment.

I arrived at the home to find the system off and not running. I spoke to the homeowner about how the system had been operating. I made sure to rinse the outdoor coil and also clear the drain. I checked over the system and found it to be very clean. All major and minor electrical components checked out fine. The refrigerant charge was proper as well. No recommendations were made at this time. The system is working properly at completion of appointment.

I arrived at the home to find the system off and not running. I spoke to the homeowner about how the system had been operating. I made sure to rinse the outdoor coil and also clear the drain. I checked over the system and found it to be very clean. All major and minor electrical components checked out fine. The refrigerant charge was proper as well. No recommendations were made at this time. The system is working properly at completion of appointment.

Cool check completed on a horizontal gas system. Condensation drain line cleared and treated. The float switch was checked and is operational. No issues found in the upstairs system. Went outside and cleaned the condenser coil. Checked refrigerant and the charge is within spec. All electrical is also within manufacture specs. The system is operating properly at this time. No major issues found.

Performed AC cool check. Checked electrical, mechanical, safety, and performance of the system. The drain line was cleared and treated. The air handler, evaporator coil and blower wheel are all clean. The wiring is tight and in good condition. System sterilizers are operational. The filter was replaced with a customer supplied filter. The condenser fan motor and contactor are both in good condition. The condenser capacitor is within value. The refrigerant charge is within factory specifications. Surge protection is operational, and the condenser coil was cleaned. No major issues were found, and the system was running at the time of departure.

Performed AC cool check. Checked electrical, mechanical, safety, and performance of the system. The blower wheel is clean. The wiring is tight and in good condition. The drain line was cleared and treated. The blower motor capacitor is below value. The condenser fan motor and contactor are both in good condition. The condenser capacitor is within value. The refrigerant charge is within factory specifications. The condenser coil was cleaned. Options for repair were presented to the customer, and he chose to have the blower motor capacitor replaced today. I replaced the blower motor capacitor and function checked the system. The system is running at the time of departure.

Recovered all the refrigerant from the system. Removed the old compressor and installed the new one. Installed new wire harness and replaced filter dryer located in condenser. Pressure tested the system and used a micro leak detector to ensure there weren’t any leaks. Pulled a vacuum and weighed in factory charge. Allowed system to run and verified charge met manufacturer specifications. Everything is operational at this time.

Service diagnostic found that the blower motor is failing. The motor is getting power and signal to run; however, it will not fully spin up and therefore not moving air. Options for repair were presented to the customer, and they chose to have the blower motor replaced today. I replaced the blower motor and function checked the system. The system is now operational.

Spoke with Mr. Wilber, and he stated that he went to change out his 20x20x1 air filter and noticed it was fully soaked and in pieces. He also noticed water on the garage floor coming out of the unit. I looked at the primary drain line and found that the condensate line had become backed up. I cleared out the line and then cleaned out the internal drain pan. I also added in a condensate drain treatment and turned the system back on. Went outside to check the capacitor and electrical amp draw. I verified everything was operating within the manufacturer’s specifications for operation.

Performed semiannual maintenance on two HVAC systems: one split system in the main house and one mini split system in the “she-shed”. Inspected all Performance, Mechanical and Safety systems. Tested and verified all mechanical components were operating within manufacture’s specifications for operation. Everything is working at this time.

Upsized bucket in recording studio to a 12x12 with a 10” duct. Installed hard round pipe across the attic and hung it. Installed damper at supply plenum to allow for balancing. Used short flex runs at the end of the hard pipe to connect to the bucket and the supply plenum. Sealed all connections with mastic air lock.

Performed semiannual maintenance on one heat pump cooling system. Inspected all Performance, Mechanical and Safety Systems. Changed out one homeowner supplied 4” media filter at the air handler base. Flushed and treated the primary drain line and cleaned out the outdoor heat pump unit. Verified all mechanical components were operating within manufacture’s specifications for operation. Everything is working at this time.

Installed new straight electric Carrier system in attic. Installed new drain pan and raised system up on foam blocks. Rebuilt drain line with SS-2 and SS-3 safety switches. Installed line filter dryer and pressure tested system for an extensive leak check. Pulled deep vacuum and weighed in factory charge. Installed new supply and return plenums and removed compromised return ducting. Also installed new RAFG in hallway. System is operating at this time

Evaporator coil was wiped down to remove as much mold/mildew as possible. System sterilizers were installed. I function checked the system and everything is operational. The system is running at the time of departure.

Service diagnostic found that yard waste had clogged up the condensate drain line. Water backup up into the safety switch and shut down the system. Options for repair were presented to the customer, and they chose to have the drain line cleared. I cleared the drain line and flow tested it with water. I then treated the drain line. I also extended the drain line so that instead of resting on the ground it is now a few inches off the ground. This will help keep yard debris out of the drain. The system was function checked and was running at the time of departure.