HVAC Service In Buda, TX

Performed AC cool check. Checked electrical, mechanical, safety, and performance of the system. The drain line was cleared and treated. The air handler and blower wheel are both clean. The evaporator coil is also clean. System sterilizers are operational. Surge protection is also operational. The wiring is tight and in good condition. The condenser fan motor and contactor are in good condition. The capacitor for the condenser unit is within value. The refrigerant charge is within factory specifications. The condenser coil was cleaned. No major issues were found, and the system was running at the time of departure.

Performed semiannual maintenance on one straight electric cooling unit. Inspected all Performance, Mechanical and Safety Systems. Verified all surge protection devices are on and green lit as designed, along with the Stage 4 Breathe Easy system. Tested all mechanical components and verified they were operating within manufacture’s specifications for operation. The system is operating with a 20° split between return and supply. Everything is working at this time.

Installed 2-ton Carrier heat pump system. Installed new plywood overlay. Rebuilt primary drain line due to drain blockage. Installed SS2 float switch. Built new supply plenum and sealed with mastic air lock. Ran new thermostat wire. Pressure tested line-set and pulled a vacuum. Replaced disconnect and whip. Ran low voltage in 1/2-inch Seal-Tite. Charged system to manufacturers specifications.

On arrival, the customer stated that she noticed the temperature rise in her home yesterday. She said that the air was circulating but it was not cold. Completed diagnostic and found that the condenser fan motor has lost a lot of lubricant, and therefore having a hard time spinning. In addition, the capacitor has failed. Presented my findings to the homeowner and she decided to move forward with the critical repair. I replaced the capacitor and cycled the thermostat. The unit is now cooling at this time.

Performed cooling maintenance on one heat pump system. Checked all electrical, mechanical and performance of the system. I found the drain line outside was a few inches under mud which was causing the drain to back up water into the system. I cleared and treated the drain line and extended the drain line a few feet per customer request to prevent it from going underground again. I cleared and treated the drain and washed the outdoor coil. No other major issues were found, and the system is operational at this time.

Performed cooling maintenance on one heat pump system. Checked all electrical, mechanical and performance of the system. Filter was replaced recently by the homeowner and is still in good condition. I did find the drain line had a partial clog. I cleared and treated the drain and tested it with two gallons of water. The outdoor condenser coil was washed as well. No major issues were found, and the system is operational at this time

Performed semiannual maintenance on one heat pump cooling system. Inspected all Performance, Mechanical and Safety Systems. I did change out one AprilAire 910 media filter that we supplied for the maintenance. Went through the system and checked over all mechanical components of both the indoor and outdoor units. Tested and verified everything was operating within manufacture’s specifications for operation. Everything is working at this time.

I arrived at the home to find the system on and running. I spoke to homeowner about how the unit had been performing. I made sure to rinse the condenser coil and also clear the drain. I checked over the system and found everything to be in great shape. All major and minor electrical components checked out fine. The refrigerant charge is within the proper range as well. No recommendations were made at this time. System is in working order at completion of appointment.

I arrived at the home to find the system on and running. I spoke to homeowner about how the unit had been performing. I made sure to rinse the condenser coil and also clear the drain. I checked over the system and found everything to be in great shape. All major and minor electrical components checked out fine. The refrigerant charge is within the proper range as well. No recommendations were made at this time. System is in working order at completion of appointment.

I arrived at the home to find the system on and running. I spoke to homeowner about how the unit had been performing. I made sure to rinse the condenser coil and also clear the drain. I checked over the system and found everything to be in great shape. All major and minor electrical components checked out fine. The refrigerant charge is within the proper range as well. No recommendations were made at this time. System is in working order at completion of appointment.

I arrived at the home to find the system on and running. I spoke to homeowner about how the unit had been performing. I made sure to rinse the condenser coil and also clear the drain. I checked over the system and found everything to be in great shape. All major and minor electrical components checked out fine. The refrigerant charge is within the proper range as well. No recommendations were made at this time. System is in working order at completion of appointment.

I arrived at the home to find the system off and not running. I spoke to homeowner about how the unit had been operating. I made sure to rinse the condenser and also clear the drain line. I checked over the system and found everything to be in decent shape. I did find the condenser fan motor to be very oily. I brought this to the attention of Stephen and made him a few estimates for repair. System is in working order at completion of appointment.

I arrived at the home to find the system off and not running. I spoke to homeowner about how the unit had been operating. I made sure to rinse the condenser and also clear the drain line. I checked over the system and found everything to be in decent shape. I did find the condenser fan motor to be very oily. I brought this to the attention of Stephen and made him a few estimates for repair. System is in working order at completion of appointment.

I arrived at the home to find the system off and not running. I spoke to homeowner about how the unit had been operating. I made sure to rinse the condenser and also clear the drain line. I checked over the system and found everything to be in decent shape. I did find the condenser fan motor to be very oily. I brought this to the attention of Stephen and made him a few estimates for repair. System is in working order at completion of appointment.

I arrived at the home to find the system off and not running. I spoke to homeowner about how the unit had been operating. I made sure to rinse the condenser and also clear the drain line. I checked over the system and found everything to be in decent shape. I did find the condenser fan motor to be very oily. I brought this to the attention of Stephen and made him a few estimates for repair. System is in working order at completion of appointment.

Performed cooling maintenance on one heat pump system. Checked all electrical, mechanical and performance of the system. Cleared and treated the drain line and washed the outdoor coil. No major issues were found, and the system is operational at this time.

Performed cooling maintenance on one heat pump system. Checked all electrical mechanical and performance of the system. Cleared and treated the drain line and washed the outdoor coil. The filter was replaced recently by the homeowner. I secured the compressor wiring to prevent any rub outs on the refrigerant line. No other major issues were found, and the system is operational at this time.

Installed new Carrier 4-ton straight ac system. Installed new T6 Pro thermostat. Rebuilt and insulated condensate drain line. Added SS2 and SS3 safety float switches. Cleared drain line with CO2 and ran three gallons of water to ensure proper operation. That was then followed by Viper drain treatment. Installed new filter dryer, pressure tested with dry nitrogen and pulled a vacuum on copper line set. Replace the condenser pad. Replaced the disconnect and ran the low voltage in Seal-Tite. Replaced both supply and return plenums and sealed with a mastic airlock. Charged system to factory spec and performed a benchmark. The system is working properly at time of departure.

I arrived at the home to find the system on and running. I spoke to Bill and Sally about how the unit had been operating. I made sure to clear the drain and rinse out the condenser coil. I checked over the system and discovered that the contactor is pitted and charred and that the capacitor is weak and out of spec. System is working to the best of its ability at this time.

I arrived at the home to find the system on and running. I spoke to Bill and Sally about how the unit had been operating. I made sure to clear the drain and rinse out the condenser coil. I checked over the system and discovered that the contactor is pitted and charred and that the capacitor is weak and out of spec. System is working to the best of its ability at this time.