HVAC Service In Buda, TX

I made sure to rinse the outdoor coil as well as clear the drain. During my evaluation of the system I discovered the following: the evaporator coil is extremely rusty, the blower wheel is very dirty, the contactor is pitted and charred, the condenser fan motor is leaking oil, and the system is low on refrigerant. I performed a leak search but was unable to locate a leak. I brought all of this to the attention of the homeowners. System is working to the best of its ability at this time.

I made sure to rinse the outdoor coil as well as clear the drain. During my evaluation of the system I discovered the following: the evaporator coil is extremely rusty, the blower wheel is very dirty, the contactor is pitted and charred, the condenser fan motor is leaking oil, and the system is low on refrigerant. I performed a leak search but was unable to locate a leak. I brought all of this to the attention of the homeowners. System is working to the best of its ability at this time.

I made sure to rinse the outdoor coil as well as clear the drain. During my evaluation of the system I discovered the following: the evaporator coil is extremely rusty, the blower wheel is very dirty, the contactor is pitted and charred, the condenser fan motor is leaking oil, and the system is low on refrigerant. I performed a leak search but was unable to locate a leak. I brought all of this to the attention of the homeowners. System is working to the best of its ability at this time.

I made sure to rinse the outdoor coil as well as clear the drain. During my evaluation of the system I discovered the following: the evaporator coil is extremely rusty, the blower wheel is very dirty, the contactor is pitted and charred, the condenser fan motor is leaking oil, and the system is low on refrigerant. I performed a leak search but was unable to locate a leak. I brought all of this to the attention of the homeowners. System is working to the best of its ability at this time.

Arrived to find the indoor unit blowing air but condenser not running. Started diagnostic and found the float switch tripped because of a clog in the primary line. Cleared the drain line and then treated. Thermostat was cycled and the system is cooling properly at this time.

Replaced secondary pan on Northside system. Installed new foam blocks and reattached secondary line. Added SS-2 and SS-3 safety switches. Verified operation of the drain and treated it with Viper cleaner. Installed new LP kit on main system and set pressure. Cleared drain line and verified operation in cooling.

On arrival, I met with homeowner, and he stated that during the day the system had a hard time getting below 77°. I turned on the thermostat to cool mode and allowed the system to run. I checked and verified system refrigerant charge was operating at a 10°SH and a 10°SC value. I did note that the outdoor condenser run capacitor has fallen below value: reading 35 out of 45mfd and 3 out of 5mfd. I went into the attic to check the furnace and coil units. I verified the drain line was properly flowing and all wires were tightened and secured. Spoke with the homeowner and we decided to have the run capacitor changed today. Installed new run capacitor and checked all electrical readings; verified everything was operating within manufacture’s specifications for operation.

Performed AC cool check. Checked electrical, mechanical, safety, and performance of the system. The Reme Halo air purifier and system sterilizers are operational. The air handler and blower wheel are clean. The drain line was cleared and treated. The condenser fan motor and contactor are in good condition and the capacitor is within value. The refrigerant charge is within factory specifications. The condenser coil was cleaned. No major issues were found, and the system is running at the time of departure.

I made sure to clear the drain and also rinse the outdoor coil. I checked over the entire system and found everything to be in pretty good shape. The only concern that I had is that the contactor has pitting and charring. I brought this to the attention of the homeowner and made him an option to replace it. He elected to move forward with the replacement and also renew his Gold Club Membership. I performed the work. I got the system switched back on and everything ran properly. System is in working order at completion of appointment.

I made sure to clear the drain and also rinse the outdoor coil. I checked over the entire system and found everything to be in pretty good shape. The only concern that I had is that the contactor has pitting and charring. I brought this to the attention of the homeowner and made him an option to replace it. He elected to move forward with the replacement and also renew his Gold Club Membership. I performed the work. I got the system switched back on and everything ran properly. System is in working order at completion of appointment.

I made sure to clear the drain and also rinse the outdoor coil. I checked over the entire system and found everything to be in pretty good shape. The only concern that I had is that the contactor has pitting and charring. I brought this to the attention of the homeowner and made him an option to replace it. He elected to move forward with the replacement and also renew his Gold Club Membership. I performed the work. I got the system switched back on and everything ran properly. System is in working order at completion of appointment.

I made sure to clear the drain and also rinse the outdoor coil. I checked over the entire system and found everything to be in pretty good shape. The only concern that I had is that the contactor has pitting and charring. I brought this to the attention of the homeowner and made him an option to replace it. He elected to move forward with the replacement and also renew his Gold Club Membership. I performed the work. I got the system switched back on and everything ran properly. System is in working order at completion of appointment.

Performed cooling maintenance on one heat pump system. Checked all electrical, mechanical and performance of the system. Cleared and treated the drain line and washed the outdoor coil. I found that the system does not have a water safety switch, the blower wheel and air handler are dirty and have some mildew growth, the starter at the condenser is pitted at the contacts, the condenser fan motor is showing signs of overheating, and the system is low on R-410A refrigerant. No other major issues found.

I arrived to find the system off. I spoke to homeowner about how the unit had been performing. I made sure to rinse the condenser coil and also clear and treat the drain. I checked over the entire system and found everything to be in good shape. All minor and major electrical components are operating properly without issue. Refrigerant charge is within range. No recommendations were made at this time. System is in working order at completion of appointment.

I arrived to find the system off. I spoke to homeowner about how the unit had been performing. I made sure to rinse the condenser coil and also clear and treat the drain. I checked over the entire system and found everything to be in good shape. All minor and major electrical components are operating properly without issue. Refrigerant charge is within range. No recommendations were made at this time. System is in working order at completion of appointment.

I arrived to find the system off. I spoke to homeowner about how the unit had been performing. I made sure to rinse the condenser coil and also clear and treat the drain. I checked over the entire system and found everything to be in good shape. All minor and major electrical components are operating properly without issue. Refrigerant charge is within range. No recommendations were made at this time. System is in working order at completion of appointment.

I arrived to find the system off. I spoke to homeowner about how the unit had been performing. I made sure to rinse the condenser coil and also clear and treat the drain. I checked over the entire system and found everything to be in good shape. All minor and major electrical components are operating properly without issue. Refrigerant charge is within range. No recommendations were made at this time. System is in working order at completion of appointment.

Performed cooling maintenance on a straight cooling system. Checked all electrical mechanical and performance of the system. Cleared and treated the drain line and washed the outdoor coil. The customer provided filters for replacement. I did find that the system does not have a water safety switch on the secondary drain line. I informed the homeowner, and they chose to have one installed today. I installed the water safety switch and cycled power at the thermostat. The system is operational at this time. No other major issues found.

Performed semiannual maintenance on one heat pump cooling system. Inspected all Performance, Mechanical and Safety systems. Changed out one homeowner supplied 4” Honeywell Media Filter. Flushed and treated the primary drain line that runs into one of the bathroom sinks to verify proper drainage of the system. Verified everything was operating within manufacture’s specifications for operation. Everything is working at this time.

Service diagnostic found that the condensate drain line is clogged. Water had tripped the safety switch shutting off power to the system. Options for repair were presented to the customer and they chose to have the drain line cleared today. I cleared the drain line and flow tested the drain with 1.5 gallons of water. I observed the water draining from the line near the condenser unit. I also treated the drain line. The system was function checked and was running at the time of departure.